The lack of bonding was existed in the case of lower deformation rate.
当变形率较小时界面有未焊合存在。
The melting point of eutectic decreases slightly with the increase of deformation rate.
共晶熔化开始温度随形变率的增大略有下降。
The temperature and the deformation rate are the key factors to prepare ultra-fine grain materials.
变形温度和变形速率是获得超细晶材料的关键。
It is considered that the carbon gradient of carburized layer can be controlled by hot-rolling deformation rate.
分析认为，可以用热轧形变量大小控制渗碳层的碳梯度。
The influence of rainfall and excavation on slope displacement is proven immediately by increasing slope deformation rate.
同时监测结果表明，降雨和开挖使边坡位移速率显著增大。
Rolled molybdenum plate has a high density, even close to its theoretic value when the deformation rate is higher than 50%.
经过轧制的钨板具有很高的密度，变形率达到50%以上的钨板的密度基本上接近理论密度。
The re-crystallization rule of SWRH82B steel at high-temperature, more rolling times and high deformation rate was studied.
研究了SWRH82B钢在高温多道次高变形速率下再结晶的规律。
It is shown from the study that different hierarchy levels correspond to different strength, viscosity and deformation rate.
由研究可以看出，不同的构造层次对应着不同的强度、粘性及应变率。
The Shanxi graben zone has the largest fault deformation rate showing it is the most important block boundary of North China.
山西断陷带的断层形变速率最高，是华北地区最重要的活动块体边界；
If the cold deformation rate is higher than 70 %, the recrystallized grain size distribution agrees with lognormal distribution.
在冷形变量大于或等于70 %时，其再结晶晶粒尺寸分布符合对数正态分布。
In order to increase the volume deformation rate as LPG bottle broken, a boss-backing has been developed for welding the bottles.
为提高液化石油气钢瓶破裂时的容积变形率，研制了带有凸台结构的焊接衬圈。
It concluded that deformation rate showed specific effect on the four textural parameters involved, but deformation degree had none.
结果表明，压缩程度对考察的四个质构参数有显著影响，压缩速率无显著影响。
It concluded that deformation rate had specific effect on the four textural parameters involved, but little effect on deformation degree.
结果表明，压缩程度对考察的四个质地参数有显著影响，压缩速率无显著影响。
Deformation rate influence the temperature rise of forging, a reasonable choice could influence the forging of forming to a certain extent.
变形速率影响锻件的温升，其合理选择对锻件成形有一定影响。
The magnitude and symbol of the residual stress greatly depends on the initial deformation rate of the pipe under drawing with the working tools.
残余应力的符号和大小在很大程度上取决于钢管在拔制工具中的初始变形率。
The influences of deformation rate on the mechanical properties of 304 austenitic stainless steel were studied by tensile test at room temperature.
采用室温拉伸实验研究了不同变形速度对304奥氏体不锈钢力学性能的影响规律。
So, using the digital deformation data to calculate the crustal deformation rate can be taken as a seismic method in the routine seismic prediction.
因此，应用形变数字化资料计算地壳形变速率，可作为对地震活动以及日常地震预测的一种分析方法。
For high rockfill DAMS, the grain crushing in high stress field may raise the deformation rate of dam body and should be considered in numerical calculation.
对于高堆石坝而言，在高应力场作用下堆石颗粒将明显破碎，从而导致坝体变形率增加，因此，在高坝数值计算中必须考虑颗粒破碎的影响。
The results show that cold-roll texture mainly consists of copper-type texture, r-type texture and some S-type texture, when the general deformation rate is 96%.
结果表明：轧制总变形率为96%的铝箔，织构以铜型织构、R型织构和一些S织构为主。
The test results indicate that the swelling deformation rate in the early stage may affected by the inundation ways, but the ultimate deformation rates should be the same.
试验结果表明，不同浸水路径在浸水的初期阶段对膨胀土的膨胀变形速率有一定的影响，但膨胀率最终值基本一致；
While for the alloys from milled powders, the compressive strength increased and the ductility decreased when enhancing deformation rate or lowering deformation temperature.
对于球磨粉末烧结合金，增大变形速率或降低变形温度，合金的强度增大，延性降低。
Some main processing parameters are briefly introduced, such as speed of main shaft, feed rate, shape of spinning wheel, deformation rate of each step and structure of template.
对主要工艺参数如主轴转速、进给率、旋轮形状、道次变形率、模板形式等作了简要介绍。
Finally, the relation among component of shear deformation, component of extension deformation and deformation rate and tectonic earthquake is analyzed on the basis of a example.
最后根据实例计算结果分析了剪切变形分量、扩张变形分量与形变速率、构造地震的关系。
Excellent resistance to oil, high temperature resistance, weather resistance are good, but the mechanical strength, compression deformation rate and water resistance is slightly worse.
对油品有极佳的抵抗力，耐高温、耐候性均佳，但机械强度、压缩变形率及耐水性稍差。
Present crustal stress values are high, structural deformation rate is fast, intensity of earthquake has an obvious increasing trend, and terrestrial heat flow anomaly is very obvious.
现代地壳应力值高，构造变形速度快，地震活动强度加剧，地热流异常明显。
Volume effect is in the case of the plastic processing system with vibration, under this process the deformation resistance force of materials is reduced, and the deformation rate is risen.
一般认为将机械振动引入到金属的塑性成形加工中，不但可以降低材料变形时所需的外力，还能大幅度提高产品成形质量，这些效果的产生主要缘于体积效应的影响。
Along some eastern boundary belts: Qujiang, Xiaojiang fault belts in the south of Yunnan to Xianshuihe fault belts in northwestern Sichuan, the present horizontal deformation rate decreases.
川滇地块东测边界带，由曲江、小江至鲜水河断裂带自南而北现今水平形变量逐渐减小；
With the decreases of deformation temperature and increases of deformation degree and deformation rate, the recrystallized grain size decreases and the recrystallization volume percent increases.
随着变形温度的降低、变形程度和变形速率的增大，再结晶晶粒尺寸减小，再结晶体积分数增大。
With the decreases of deformation temperature and increases of deformation degree and deformation rate, the recrystallized grain size decreases and the recrystallization volume percent increases.
随着变形温度的降低、变形程度和变形速率的增大，再结晶晶粒尺寸减小，再结晶体积分数增大。
应用推荐