An example of the finite element equivalent stress method in engineering design practice is described.
介绍有限元等效应力法在拱坝设计中的运用实例。
An equivalent stress method for the structural analysis of derrick with initial deformation is offered.
为此，采用等价应力法对有初始变形的井架进行结构分析。
The accumulated fatigue damage was calculated in frequency domain by equivalent stress method and equivalent narrow band method respectively.
在频域内分别用等效应力法和等效窄带法计算了累积损伤。
In this paper, the assumption of equivalent stress method only used near the dam heel and toe and the middle regions stress USES the FEM calculated stress.
针对该问题，提出局部等效应力方法，即对坝基面坝踵和坝趾局部区域进行局部等效处理，坝基面中间大部分区域仍采用有限元计算。
Fortunately in some degree this kind of stress convergence can be eliminated or reduced to a lower level processed with the finite element equivalent stress method.
有限单元法进行拱坝分析具有诸多方面的优点，但存在较大的应力集中，而经等效应力法处理可在一定程度上削除这种应力集中的影响。
Thmugh the comparison with both the simplified method of structural mechanics and the finite element equivalent stress method, the feasibility of the method is verified.
通过与结构力学简化方法和有限元等效应力法的比较，验证了该方法的可行性。
It was very complicated when taking the traditional equivalent section method to calculate the section stress of steel concrete structural unit under its normal working condition.
对于钢筋混凝土构件在正常使用状态下的截面应力计算，用传统的“等效截面法”计算十分复杂。
Penetration performance in surface layer of concrete target was analyzed by stress wave damage theory, calculating method base on "simplified equivalent resistance line" was presented.
从应力波表层损伤理论分析了混凝土表层“开坑区”的侵彻特性，提出“简化等效阻力线”的计算方法；
The paper has established the calculation method of the equivalent modulus of elasticity of foundation that is based on the principles of thermal stress equivalence.
利用有限元法对温度应力进行了大量计算，在此基础上建立了以温度应力等效为原则的基顶当量回弹模量换算方法。
The finite element internal force method for calculating arch dam equivalent stress is improved.
本文对有限元内力法求解拱坝等效应力分析方法进行了进一步改进。
The stress and displacement distributions of the bellows under torsion loading are investigated by using both finite element method (FEM) and equivalent cylinder method.
本论文分别采用有限元法和等效圆筒法对波纹管在扭转载荷作用下的应力分布和位移变化情况进行了计算。
After the comparative analysis about the displacements in two sides, top and bottom of roadway and surrounding rock stress, the feasibility and applicability of the equivalent method is verified.
通过对巷道两帮、顶、底部位移和围岩应力的对比分析，验证了该等效方法的可行性和适用性。
In the method, the effect of temperature change is equivalent to that of initial stress. The formulas of equivalent initial stress and equivalent loading for plane problem are given.
该方法将温度变化对岩体的力学影响转化为等效初应力的作用来求解节理岩体热应力问题，给出了平面应力和平面应变问题中等效初应力和等效载荷矩阵的计算公式。
There are mainly three methods in the second system stress analysis of the orthotropic steel deck, P-E method, the equivalent girder beam method and the FEM.
薄壁钢扁平箱梁正交异性板钢桥面系第二体系应力的计算方法主要有P -E法、等效格子梁法和有限元法等。
The superposition method should be used to the components of stresses and then the present equivalent stress will be counted.
迭加应在各应力分量上进行，然后再计算应力的当前等效值。
Equivalent additional stress method can be the same with integral method or combined method depending on the equivalent method of additional nodal force calculated.
等效附加应力法根据附加节点力计算方法的不同分别对应整体式和组合式方法。
Classical integral method and combined method for reinforced concrete constitute the theoretical basis of equivalent additional stress method.
钢筋混凝土中经典的整体式和组合式方法构成了等效附加应力法的理论基础。
In 3-d stress space, simplified form of Mohr-Coulomb equivalent area circle yield criterion is derived by adopting analytic geometry method.
在三维应力空间，采用解析几何的方法，导出了莫尔-库仑等面积圆屈服准则的简化形式。
Elastic finite element method are used to calculate the point of internal mould of the equivalent stress, equivalent strain, such as force and energy parameters and their distribution.
用有限元法计算了模具的温度分布，这为研究模具在不同温度条件下的应力状态做好了准备。
Elastic finite element method are used to calculate the point of internal mould of the equivalent stress, equivalent strain, such as force and energy parameters and their distribution.
用有限元法计算了模具的温度分布，这为研究模具在不同温度条件下的应力状态做好了准备。
应用推荐