Using computer may simulate the errors of measurement result when every parameter varies.
通过计算机模拟系统各参数变化时给测量结果带来的误差。
Experimental results show that the method can calculate the errors of measurement results effectively.
模拟试验结果表明，该计算方法可以有效的计算出测量结果的误差。
The errors of measurement of CPFM and CPFM with a reference chamber were theoretically analyzed in the paper.
该文从理论上对CPFM和带参考室的CPFM的流量测量误差进行了分析。
The theoretical basis and measuring apparatus of the temperature measuring method for wall stabilized arc plasma are described, and the errors of measurement are estimated.
介绍壁稳弧等离子体温度测量方法的理论依据和测量装置，并进行了误差分析。
The goal behind measuring n executions of task (n >= 1) is to make the cumulative execution time so large that all the time measurement errors I discuss above become insignificant.
度量task的n 次执行的目的在于，让累计的执行时间足够大，从而减少前面讨论的所有时间度量误差的影响。
A shadow moire method and its results for measurement of distortion of aluminium plate at exploding charge is presented. Possible errors are also estimated.
本文介绍了用阴影云纹法测量爆炸载荷下铝板变形的方法及结果，并进行了误差讨论和静态标定。
Nowadays, in order to improve dynamic measurement precision effectively, the correction technique for dynamic errors has become one of the main techniques.
为有效提高动态测量精度，动态测量误差修正技术已成为当今引人注目的主要技术措施之一。
The relationship between the detection of feature points and the measurement of motion parameters is studied in this instance of ignoring the camera calibrate errors.
在不考虑摄像机内外参数标定误差的情况下，研究了标志点像元的测量精度对运动参数测量的影响。
The errors of heading and attitude measurement with GPS are discussed and the schemes are proposed.
通过误差分析，讨论了影响GPS航姿测定的各项误差，提出了GPS航姿测量方案。
Errors in digital measurement of the peak value and front time of impulses are calculated by this method, with influence factors and variance ranges analysed.
利用这种方法，计算了冲击电压峰值和波前时间的数字测量误差，并分析了误差的影响因素和变动范围。
The origin of measurement errors and measures to improve the accuracy are discussed.
本文还讨论了测量误差的来源和提高测量精度的措施。
But the current measurement of prosperity is riddled with errors and omissions.
但是，当前的繁荣衡量到处都是错误和漏洞。
According to metrological characteristics of diffraction grating, the measurement error models are built up and the equations between installation and measurement errors of grating are deduced.
根据衍射光栅的计量特点，建立了正交衍射光栅测量误差模型，推导了光栅安装误差与测量误差之间的关系。
Based on analyzing the sources of measurement errors, the correction methods of the errors are introduced and error models of two port calibration are provided.
在对网络分析仪的测量误差来源进行分析的基础上，介绍了误差的主要校准方法，同时给出了二端口校正的误差模型。
According to its exponential wave responses, the impulse measurement errors of a digitizer can be calculated.
根据指数波响应，可以计算数字仪的冲击响应和冲击测量误差。
The impulse measurement errors of the XZF—900 precision resistor divider and the ZRF—1200 low damped capacitor divider are given from exponential wave tests and calculations.
根据指数波试验和计算，文中给出了XZF-900精密电阻分压器和ZRF-1200低阻尼电容分压器的冲击测量误差。
Attitude measurement errors of the double cone scanning infrared earth sensor caused by brushless DC motor speed asymmetry was researched.
针对双圆锥扫描式红外地平仪因无刷直流扫描电机转速不均匀造成的姿态角测量误差进行了研究。
Clock error is the main and direct source of errors in network measurement.
时钟误差是网络测量中最主要的直接误差来源。
This paper discusses the errors in verification system of small volume measurement instrument, and gives a detailed analysis on the test ways of small capacity measuring instruments.
本文论述了小容量计量器具检定系统存在的误差问题，并详细的分析了小容量计量器具的验定方式。
Flexible coordinate system is introduced into theodolite industrial measurement, so there arent errors of instruments levelling and relative orientation in self locating of the system.
将柔性坐标系引入经纬仪工业测量中，使其系统自定位不再受仪器整平误差和相对定向误差的影响。
This paper analyzes the measuring errors of the phasor measurement unit (PMU) and points out the necessity of state estimation based on PMU measurement.
分析了相量量测装置的量测误差情况，指出了相量量测参与状态估计计算的必要性。
Systematic errors in measurement of neutron multiplication have been experimentally studied.
实验研究了中子倍增率测量的系统误差。
However, it has been found that the performance of CMKF degrades considerably when cross-range measurement errors of the target position are large.
然而，当目标位置的互距离测量误差比较大时，CMKF的性能将急剧下降。
The causes of errors mainly included two aspects, the standardization of measurement procedures and the psychological factor of individual patients.
产生误差的原因主要包括两个方面，测量过程的规范性和患者个体的心理因素。
When frequency sweeping method being used properly for measuring amplitude-frequency characteristics, the analysis and estimation of errors in measurement results could be avoided.
正确使用扫频法测量幅频特性，可以避免大量测量结果中误差的分析与估算。
The problems of uncertainty estimation are analyzed in detail when measurement results of form errors are evaluated with the methods of least-square and minimum zone.
详细分析了用最小二乘法和最小包容区域法评定形状误差测量结果时的不确定度估计问题。
The problems of uncertainty estimation are analyzed in detail when measurement results of form errors are evaluated with the methods of least-square and minimum zone.
详细分析了用最小二乘法和最小包容区域法评定形状误差测量结果时的不确定度估计问题。
应用推荐