The result shows that the flexural stress of the western China is about several hundred MPa.
模拟结果表明中国西部的岩石圈挠曲应力的量值达数百兆帕。
Compare the temperature stress to the flexural stress which is used to obtain the cracking rules of the early age concrete.
将早龄期混凝土的温度应力与强度对比，以此来确定混凝土开裂规律。
It will decrease the maximum axial stress of the lining, but it will increase the maximum shear stress and flexural stress.
开挖引致的松动区减少围岩劲度，将减少衬砌轴向应力，但增加剪应力及挠曲应力。
The formula for calculating the ultimate stress of unbonded post tensioning tendons and the calculating method of ultimate flexural strength of UPPC beam Bridges are proposed.
在此基础上给出了无粘结预应力筋极限应力计算公式和UPPC梁正截面抗弯强度计算方法。
The key to calculate the ultimate flexural strength of unbonded partially prestressed concrete (UPPC) beam Bridges is how to determine the ultimate stress of unbonded post tensioning tendons.
无粘结部分预应力混凝土(UPPC)梁桥抗弯强度计算的关键，是如何确定无粘结预应力筋的极限应力。
Scattering of flexural waves by multiple cutouts and dynamic stress concentration in the thin plates were investigated in terms of the complex variable function method and multi-polar coordinates.
采用复变函数法和多极坐标方法，研究了弯曲波对含有多圆孔薄板的散射问题。
The results show that flexural strength of fresh water ice is closely related to stress rate and temperature.
结果表明，水库淡水冰弯曲强度与应力速率和冰温有着密切关系。
After reaching maximal flexural strength, with the increase in stress rate, the flexural strength decreases instead.
达到极限弯曲强度后，应力速率继续增加，弯曲强度值呈减小趋势。
The fatigue rupture made up 80 percent of the total petroleum drillstring failures, which is related to the flexural-torsional alternate stress acted on drillstring.
石油钻柱的失效80 %以上都为疲劳破坏，这与钻柱在弯曲和扭转组合下的交变应力有关。
For the brittle ceramic materials, flexural strengths are determined by the stress at fracture in transverse bending tests.
对脆性陶瓷材料来说，抗弯强度即为横向弯曲试验中样品断裂时的应力。
The anti- presses the modulus of resilience lower and can reduce the flexural-tensile stress of the material bottom.
抗压回弹模量降低可减少材料底部的弯拉应力。
The paper respectively carries through the deformation, stress and strain and ultimate flexural resistance of the reinforced concrete Tee-shaped beam under the different gluing forms.
分别进行了不同粘贴形式下加固钢筋混凝土T形梁的极限承载力、变形和应力-应变分析。
Scattering of flexural waves and dynamic stress concentration in plate are different from static stress problem.
弯曲波的散射及动应力集中不同于静力问题。
The bending moment diagram and circle of stress are drawn; the most flexural torque and primary stress are solved in MATLAB.
利用MATLAB绘制剪力图、弯矩图、应力圆以及求解最大弯矩和主应力。
The bending moment diagram and circle of stress are drawn; the most flexural torque and primary stress are solved in MATLAB.
利用MATLAB绘制剪力图、弯矩图、应力圆以及求解最大弯矩和主应力。
应用推荐