The non-sinuous oscillation of the mold is used to reduce the mold friction force and stick type breakout, and to lower the oscillation frequency for high speed casting.
应用结晶器非正弦振动技术可以降低结晶器摩擦阻力，减少粘结性漏钢，同时大幅度降低高拉速时的结晶器振动频率。
The maximum static friction force goes up with the relative humidity…
利用单峰接触的模型，建立了相对湿度与摩擦力关系的公式。
The friction force is therefore called a nonconservative or a dissipative force.
因此，摩擦力称为非保守力或耗散力。
The friction force is therefore called a nonconservative or a dissipative force .
因此，摩擦力称为非保守力或耗散力。
The main causes of shaft wall fracture contain the reverse friction force and the temperature stress.
分析研究表明导致立井壁破坏的主要原因是井壁负摩擦力和温度应力。
From the common mechanical phenomenon, present a theoretical method on how to judge the direction of static friction force.
本文以常见的力学现象为例，从理论上阐述判断静摩擦力方向的方法及作功问题的证明方法。
In this paper, the effect of friction force on metal forming parameters has been summarized based on some last research reports.
论文基于近期已发表的文献，综述了摩擦阻力对金属成形参数的影响。
The distribution of slip displacement, slip velocity and friction force on the strike slip fault were obtained by numerical simulation.
通过数值计算得到了平移断层上滑移位移、速度及摩擦力的分布规律。
Furthermore, the effect of friction force on the stress fields of the integrated coating systems is considerable and cannot be neglected.
并且表面摩擦力对涂层体系的应力分布有显著影响。
Flanged valves have following features: small opening stroke, small friction force when opening and shutting, and high abrasion resistance.
本阀门结构为法兰连接，具有开启行程小、摩擦力小、耐磨等特点。
This paper introduces systematically the method for measuring the instantaneous friction force of cylinder liner-piston pair in the engine.
系统地阐述了发动机缸套活塞组瞬态摩擦力的测量方法。
This sudden change in the direction of the friction force made the system extremely non-linear and the solution process highly complicated.
摩擦力方向的这种突然改变使系统变得高度的非线性，求解十分复杂。
Taking into account the friction force between obturator ring and liner, this approach is closer to the real condition than the conventional one.
该方法考虑了闭气环与衬套之间的摩擦力，比常规方法更接近实际；
This paper presents a discussion of steady-state response of the structural skidding damping friction force by using the computer aided analysis.
本文用计算机辅助分析结构受滑移阻尼摩擦力时的稳态响应。
A new type of joint, which offers a friction force dependent on the amplitude of displacement, is proposed to suppress the vibration of structures.
研究利用一种摩擦力随振动幅值的增大而增大的阻尼铰进行结构振动的被动控制。
The effect of the adhesion on the friction force of the self-assembled monolayers is dependent on the flowing and bond of the self-assembled molecules.
自组装分子膜粘着效应对摩擦力的影响与自组装分子的键合及流动相关。
This paper mainly discusses the methods of judging the direction of friction force, and the effect and cause of friction force is studied systematically.
本文重点阐述了判定摩擦力方向的方法，对摩擦力的作用及摩擦力的成因进行了比较深入的探讨。
Based on a slab caster which is equipped by hydraulic oscillators, the transient friction force between mould and strand shell was measured and analyzed.
本文以板坯连铸机为研究对象，对液压振动条件下结晶器和铸坯间的瞬态摩擦力进行测试和分析。
In the casting process, the withdrawal straightener has to overcome the friction force from the crystallizer and resistance from the secondary cooling device.
工作时，拉矫机必须克服拉坯过程中结晶器内的摩擦力、二冷装置阻力、矫直阻力等。
However, the behavior of friction force during the continuous casting and the relation between the quality of the billet and the friction force are still unclear.
软接触结晶器电磁连铸可以改善铸坯的表面质量，但其电磁场对拉坯阻力的影响以及拉坯阻力与铸坯表面质量间的关系仍值得研究。
Examined by practice, the method about the working condition parameter optimization for coal plough and the calculation about friction force on plow head are feasible.
经实践检验，本文的刨煤机工况参数优化方法和刨头摩擦力计算方法是切实可行的。
Aimed at aerostatic guideway, a two dimensional distribution of air pressure and effect factor on the friction force were analyzed under high speed working conditions.
以静压气浮导轨为研究对象，对导轨气浮块底部气体压力的二维分布规律及影响摩擦力的因素进行了理论分析。
This method can calculate the nonlinear friction force conveniently and can consider the effects of the blade high modes and the high harmonics of the blade responses.
该方法能够方便地计算接触面非线性摩擦力，考虑响应的高次谐波以及叶片高阶振型的影响。
During normal construction process, the friction force between shield and soil exhibited greater influence on surface deformation compared with bulkhead additive thrust.
在正常施工时，盾壳与土体之间的摩擦力对地面变形的影响远大于正面附加推力。
The dependence of the static friction force on a rod immersed in granular matter on the filling height of granules and the diameter of the rod is studied experimentally.
通过实验研究了圆棒在颗粒物质中受到的摩擦力与颗粒填充高度及棒径的关系。
The inertia friction welding process is a non-linear process because of the interaction between temperature field and material properties as well as friction force and thrust force.
焊接过程中的温度、材料热物性、摩擦力和顶锻压力的相互作用使焊接过程高度非线性。
In order to investigate the origin of the oscillation of friction force on the atomic scale, Molecular dynamics simulation is employed to research it from the period of the oscillation.
为了研究原子尺度下摩擦力波动现象产生的本质，利用分子动力学模拟的方法从摩擦力波动周期的角度对其进行探讨。
Pneumatic PWM position servo system is nonlinear system. The satisfied results are difficult to be obtained with traditional control method while the friction force of cylinder is large.
气动脉宽调制位置伺服系统是非线性的系统，在气缸摩擦力较大的情况下，采用传统的控制方法难以取得满意的效果。
Statistic method is used to analyze the correlation between static contact area and dynamic friction force. The results clarify that there is a linear correlation with significant level.
应用统计学方法对静态接触面积与动态摩擦力进行了相关分析，结果表明二者具有显著水平的线性相关关系。
Statistic method is used to analyze the correlation between static contact area and dynamic friction force. The results clarify that there is a linear correlation with significant level.
应用统计学方法对静态接触面积与动态摩擦力进行了相关分析，结果表明二者具有显著水平的线性相关关系。
应用推荐