The gas flow rate is one of the key design parameters for HPH furnace.
循环风量是全氢罩式退火炉的关键设计参数之一。
The TJSOG can work steadily when the total gas flow rate reaches the maximum.
气体达到最大流量时，发生器仍然能稳定地工作。
The quality of the samples was improved with increasing carrier gas flow rate.
而当载气流量增大时，样品质量改善。
The splashed slag density is increased with the increase of top gas flow rate.
结果表明，顶吹气体流量的提高有利于增加炉衬的溅渣密度；
An empirical formula was given for determining the minimum inert gas flow rate.
提出了估算惰化流量的经验公式。
The influence of reaction temperature and gas flow rate on purification efficiency was studied.
研究反应温度和气体流量对磷化氢净化效率的影响。
The results show that the small signal gain distribution of such laser is closely related to gas flow rate.
此研究结果表明这类激光器的小信号增益分布与气体流速有关。
The numerical simulating results of liquid velocities agree with the experimental data at low gas flow rate.
在低气速下，局部液体速率的模拟结果与实验数据吻合良好。
At a constant gas flow rate, the overall volumetric mass transfer coefficients increase with the rotational speed.
在一定的转速范围内，气相流速不变时，吸收系数随转子转速的增加而增加。
Some conditions, such as vaporization temperature, detection temperature and gas flow rate, etc. were also discussed.
对汽化温度、检测温度、气体流速等进行了探讨。
The welding current, welding speed and the plasma gas flow rate were the most important parameters in the ending stage.
发现焊接电流、离子气流量和焊接速度对收弧过程影响较大。
The transient behaviors of gas flow initiated by quick change of gas flow rate were tested on a big multiphase flow loop.
在大型多相流实验环道上进行了气体流量快速变化的瞬态特性实验。
The experimental data of gas flow rate in the bed with four slant angles and three kinds of particle materials are obtained.
选用三种颗料状物料，在四种不同倾斜度的斜管中测定了不同负压差和固体流率条件下的气体流率。
The activation ambience, reaction temperature, catalyst's send live time, gas flow rate were used to study the best catalyst.
对最优催化剂进行了活化气氛、反应温度、催化剂致活时间、反应气流速等方面的考察。
The effects of gas flow rate, pyrolysis temperature and different ratios of steam on chlorine removal from coal are also examined.
同时考察了气体流速、热解温度和不同比率的水蒸气对煤中氯析出的影响。
When gas flow rate quickly decreases, there will appear a short period of stratified flow in the transient process of the slug flow.
当气体流量突然降低时，在段塞流的瞬态变化过程中则会出现短时间的分层流。
The effects of liquid flow rate, carrying gas flow rate, heat flux and liquid properties on heat transfer coefficient were measured.
研究了液体流量、载气流量、壁面热负荷及料液物性等对降膜载气蒸发传热的影响。
Through experimental measuremnet, the optimum current and gas flow rate for strictly controlling the bead forming process are found out.
通过试验证明，严格控制焊接电流和离子气流量，可以对焊缝成形进行有效控制。
For reactive sputtering, the gradient films with varying ratio of chemical component can be prepared by changing gas flow rate continuously.
对于反应溅射，可通过连续改变反应气体流量制得化学成分比连续变化的梯度薄膜。
The influence of chamber pressure, gas flow rate and RF power on micro loading effect in reactive ion etch of silicon dioxide is researched.
对二氧化硅反应离子刻蚀中反应室压力，刻蚀气体流量和射频功率等因素对刻蚀速率和刻蚀均匀性的影响进行了研究。
The results show that the etching rate depends strongly on plasma composition and the RF bias voltage, but rather weakly on the gas flow rate.
结果表明刻蚀气体的组分和射频偏压对刻蚀速率有较大影响，而气体流量影响不大。
The results show that the entrainment of slag in tundish with gas curtain was mainly affected by gas flow rate and the position of gas blowing.
结果表明，气幕挡墙的位置和吹气量是影响中间包卷渣的主要因素。
But gas flow rate is too big, but will make arc beam are short and heat loss increased ability to cut down to make cutting process, cannot proceed.
但气体流量过大，反而会使弧柱变短，损失热量增加，使切割能力减弱，直至使切割过程不能正常进行。
The effects of the plasma power, spraying distance and plasma gas flow rate on the microstructure and properties of the coatings were investigated.
研究了电弧功率、喷涂距离和等离子气体流量对涂层显微组织和性能的影响。
The effects of gas flow rate and rotating speed on the fluid field, local void fraction distribution and bubble size distribution were investigated.
考察了不同通气量和操作转速下气液搅拌槽内流体流动，局部气含率和气泡尺寸的分布规律。
The experimental quantities, such as the electric current density, the concentration of SO2 and the gas flow rate in cathode compartment were tested.
考察了电流密度、气相中SO_2浓度、阴极室气体流量等因素对SO_2传质的影响。
The continuous emission process of gas bubbles under a constant gas flow rate through a single orifice immersed in a quiescent viscous liquid is studied.
考察一定流量气体，通过锐孔在静止黏性液体中连续溢出气泡的过程。
The continuous emission process of gas bubbles under a constant gas flow rate through a single orifice immersed in a quiescent viscous liquid is studied.
考察一定流量气体，通过锐孔在静止黏性液体中连续溢出气泡的过程。
应用推荐