So introduced the computer control system of gas heating furnace.
为此，介绍了燃气加热炉的计算机智能控制系统实现。
Design, construction and using of a gas heating furnace for hammer forging have been introduced.
介绍了一台锻锤用煤气加热炉的设计、施工及使用情况。
To introduce the control principle of X-R control chart, and use the principle to control the temperature of coal gas heating furnace.
介绍X -R控制图的基本控制原理，并运用该原理对煤气加热炉的温度进行控制。
Oil heat electric heater and that electrical heating oil heat furnace, the difference between the traditional fuel gas heating furnace and furnace.
导热油电加热器又叫电加热导热油炉，其区别于传统的燃油加热炉及燃气加热炉。
The requirement to flow, pressure, heating temperature and purity of converter gas used in reheating furnace were introduced.
介绍了加热炉在使用转炉煤气作为燃料时，对其流量、压力、加热温度和纯洁度的要求。
Replace the reverberatory furnace and gas producer etc. , there is no light fire producing when heating, and it accords with national fire protection safety rules.
取代反射炉、煤气发生炉等，加热无明火产生，符合国家消防安全条例。
This paper introduces that the blast furnace gas is used heating furnace, and summarizes serval experience.
介绍了采用炼铁副产品高炉煤气为加热炉燃料的应用情况，总结了经验和教训。
The non-oxidizing zone is consisted of entry sealed room, waste gas preheating zone, direct heating zone, and furnace nozzle and flue gas exhausting system.
无氧化段由入口密封室，废气预热区，直接加热区，炉喉，废气排放系统组成。
The gas from blast furnace is useful for heating purpose. But it contains a considerable amount of dust, so it must be cleaned before used as a fuel.
高炉煤气用来加热很有用。但它含有大量的灰尘，所以在用作燃料之前必须经过除尘。
The fuel used for heating is either furnace gas or coke oven gas. Thecombustion air is always preheated to improve fuel utilization.
用来加热的燃料不是高炉煤气就是焦炉煤气。燃烧用风通常要预热，以提高燃料的利用率。
This paper introduces the problem of the hot coal gas used in the heating furnace and the application of the regenerative combustion in the heating furnace burning the hot coal gas.
介绍燃热脏煤气在特钢加热炉上存在的问题和蓄热式燃烧技术在燃发生炉热脏煤气特钢加热炉上应用。
The fuel used for heating is either blast furnace gas or coke oven gas. The combustion air is always preheated to improve fuel utilization.
用来加热的燃料不是高炉煤气就是焦炉煤气。燃烧用风通常要预热，以提高燃料的利用率。
In combination with the feature of blast furnace gas heating, described the manual intelligent design mode for coke oven automatic heating and automatic control effect.
结合高炉煤气加热特点，介绍了焦炉自动加热的人工智能设计模式和自动控制效果。
This article discussed that the coke oven was revamped by auxiliary heating to raise the temperature of furnace end for gas generator.
焦炉使用发生炉煤气加热时，炉头温度较低，采用补充加热的方法提高炉头温度。
The designing characters and the application of the gas heating room-form furnace with automatic control used for forging process were proposed.
叙述了锻造用室状煤气加热炉的设计特点及其实际应用。
This pape introduces the "convert oil to gas" practice in rolling heating furnace. Using some new techniques and materials, the equipment level has been raised.
介绍了加热炉油改气的实践和使用效果。通过采用新工艺、新材料，提高了加热炉的技术装备水平。
The structure of the temperature control system of the gas fired furnace for heating of the big aeronautic forge piece is studied.
研究了供航空大锻件加热用煤气炉控温系统的结构。
When the fuel for the heating furnace of Beiman Special steel Corporation was changed from gas to oil, severe carbonization happened on the surface of cold-drawn steel.
北满特钢加热炉由烧煤气改烧油后，冷拔材表面产生严重增碳的现象。
The heating furnace direct fuel compared with hot gas, can save energy economy after above 60%.
相比直接燃油的热加工炉，使用热煤气后可节省能源经济60%以上。
Practice proved that blend blast furnace gas and mix gas can be improve the heating furnace work condition and availably exalt heat (ability.)
生产证明在高炉煤气中适当掺加部分混合煤气可改善加热炉工作状况，有效提高加热能力。
This pape introduces the "convert oil to gas" practice in rolling heating furnace.
介绍了加热炉油改气的实践和使用效果。
The heat pipe failure, lower heating air temperature, higher flue gas emission of the furnace in operation are analyzed and improvement measures are suggested.
对实际运行中存在的热管失效、热空气温度偏低、排烟温度偏高等问题进行了分析，并提出了相应的改进措施。
Through utilizing the byproduct - gas comprehensively , decrease the energy consumption of rolling heating furnace and boiler, and reduce gas of system , so get more economic and social benefit .
通过对企业副产煤气的综合利用，降低了轧钢加热炉燃油消耗和锅炉动力煤消耗，煤气的放散率大幅度降低，为企业创造了较大的经济效益和社会效益。
Our company specializing in the production of heating furnace, gas type heating furnace, the trolley type heating furnace, regenerative heating furnace.
我公司专业生产加热炉，燃气式加热炉，台车式加热炉，蓄热式加热炉。
As a result, the heating capacity and quality of heating furnace is improved, the slab surface oxidation burning loss is decreased and the gas consumption reduced and the economic benefit remarkable.
改造后使加热炉提高了加热能力和加热质量，减少了板坯表面氧化烧损，降低了煤气消耗，经济效益显著。
Gas occurrence boiler ignition former must sweep of heating furnace and flue gas may remaining.
煤气发生炉点火前一定要吹扫加热炉内和烟道中可能残存的煤气。
The result shows that the content of combustible gas is far lower than the lower explosive limits and there is no the explosion danger in heating furnace.
研究结果表明，加热炉运行全过程中可燃气体含量较少且远低于烟气混合物爆炸极限，不存在爆炸危险；
The result shows that the content of combustible gas is far lower than the lower explosive limits and there is no the explosion danger in heating furnace.
研究结果表明，加热炉运行全过程中可燃气体含量较少且远低于烟气混合物爆炸极限，不存在爆炸危险；
应用推荐