Bolt Hole Spacing should be consistent with the allowable deviation of norms.
螺栓孔孔距的允许偏差应符合规范的规定。
Only by controlling fairly the hole spacing, secondary grouting time interval, number of secondary grouting and seal arou…
要提高施工工艺水平，应掌握好布孔间距、复灌间隔时间、复灌次数及注浆管周围封堵等环节。
Supporting the use of impact drilling electric drill. Drilling, hole spacing with hole depth should meet the design requirements.
钻孔使用配套冲击电钻。钻孔时，孔洞间距与孔洞深度应满足设计要求。
Only by controlling fairly the hole spacing, secondary grouting time interval, number of secondary grouting and seal around gro...
要提高施工工艺水平，应掌握好布孔间距、复灌间隔时间、复灌次数及注浆管周围封堵等环节。
But when according to the site conditions determined to crack a drilling section with oblique relations, hole spacing can enlarge exploration.
但当根据现场条件确定的钻探剖面与地裂缝呈斜交关系时，勘探孔间距可以适当放大。
Only by controlling fairly the hole spacing, secondary grouting time interval, number of secondary grouting and seal around grouting pipe can the...
要提高施工工艺水平，应掌握好布孔间距、复灌间隔时间、复灌次数及注浆管周围封堵等环节。
According to deep hole blasting practice, the wide hole spacing small burden technology is studied because the technology can improve quality of blasting.
根据深孔爆破工程实践，对宽孔距小抵抗线爆破技术进行了研究，该技术可改善爆破质量。
The quantity of explosives and the blast-hole spacing are dependent upon the type and structure of the rock and the diameter and depth of the blast holes.
用药量和炮眼间距取决于岩石的范例和布局以及炮眼的直径和深度。
In light of the results calculated by maximum hole spacing in freezing horizon, The freezing wall should be enclosed, however, hydrological hole don t leak.
本文就冻结工程施工中遇到的冻结层位最大孔间距计算出冻结壁已交圈，但水文孔不冒水的问题结合了作者的施工经验进行了深入的分析。
After the test road, summarizes the slab grouting technique for composite pavement, determines the grouting pressure, hole arrangement, hole spacing and other key indexes.
通过试验路的实践，总结了适用于复合式路面的压浆工艺，确定了压浆压力、布孔方式、孔距等关键参数。
By varying the groove spacing, the diameter of the single or double diameter hole, and the rear air cavity depth and content, one can obtain absorption over a wide variety of frequencies.
通过改变槽间距，直径的单人或双人直径孔，与后方空气腔的深度和内容，就可以得到吸收超过各种各样的频率。
An example is a bolt hole circle, in which the diameter of the bolt circle, the spacing of thebolt holes, and other parameters must be specified.
例如螺栓孔圆形，螺栓圈的直径，其中必须指定螺栓孔和其他参数的间距。
The tube spacing cattle brand products have reached the theoretical limit of 61 mm, inner tube hole connection is only 7mm.
目前牛牌产品的管间距已达到理论极限—61毫米，内胆管孔连接处仅为7mm。
The type of explosive used, rock properties, and method of loading and sequence of firing the holes, affect hole depth, diameter, alignment and spacing.
采用的炸药的类型、岩石的特性、装岩方法、各个钻孔的起爆顺序，这些都影响着钻孔深度、直径、排列和间距的确定。
When plant spacing and row spacing were too small or seedling Numbers per hole was too much, 2nd internode lodging index for two rice varieties increased and resistance ability decreased.
株行距过小或插植苗数过多时，水稻基部第2节间的倒伏指数增大，抗倒伏能力下降。
The result indicates that the arrangement defect controls the deformation, stability and rock mass failure when the scales of crack, fissure, cavity, spacing, hole are coexisting in rock masses.
研究结果表明，当裂缝、裂隙、微裂隙、孔隙等不同尺度、不同层次缺陷并存时，高层次缺陷对岩体的变形、稳定、破坏起着主导控制作用。
A spacing piece is arranged at the portion close to the back of the installation rod, and the outer edge of the spacing piece leans against the chassis outside the through-hole.
在安装条上靠近后端的部位设置限位片，该限位片的外边缘倚靠在通孔外的底座上。
A spacing piece is arranged at the portion close to the back of the installation rod, and the outer edge of the spacing piece leans against the chassis outside the through-hole.
在安装条上靠近后端的部位设置限位片，该限位片的外边缘倚靠在通孔外的底座上。
应用推荐