Increases in the inlet flow rate or the particle concentration both increase the filter pressure drop.
此外，随来流流量和颗粒浓度的增加，过滤压降增加。
To achieve better separation effect with lower power consumption, the hydrocyclone should be put into operation with minor inlet flow rate.
为了在较低能耗下获得较好分离效果，应使旋流器在较小进口流量下工作。
The effects of the air inlet flow rate and the rotor rotating speed on powder materials dispersion in turbo air classifier are investigated by the experiment.
通过实验研究涡流空气分级机分级中进口风速和转笼转速对机内粉料分散的影响。
The results show that the increase of the air inlet flow rate is conducive to the materials dispersion in the classifier, and more effective for fine part than that for coarse one.
结果表明，风速增加有助于机内粉料的分散，但风速的增加对机内细粉料分散的改善优于对机内粗粉料分散的改善。
Effects of inlet air flow and inlet feed concentration on enrichment rate were predicted by the model. The results had good agreement with the experiment observations.
模型预测了进料浓度和进气速度对富集比的影响，结果表明，模型预测结果和实验结果基本一致。
The experimental results show that in the process of flow excursion the mass flow rate and the inlet temperature decreases, while the exit temperature increases smoothly.
研究结果表明：在发生静态流量漂移时，系统循环流量下降、加热段的进口温度下降而出口温度上升；
Several calculating methods for determining the air-flow rate, the exhaust temperature, the compressor outlet pressure and the turbine inlet pressure are compared.
对四冲程柴油机增压系统的空气流量，排气温度、压气机出口压力和涡轮进口压力的若干种计算方法进行了分析。
T he flow rate regulation range was too narrow, and the change of heat removing capacity depended on the change of inlet temperature.
揭示了液体流率受管道结构等条件的限制，合理调节范围较窄，服装温度比效率不会很高，应主要靠调节进口液温来改变服装的散热量。
The experimental study was focused on the effects of inlet air temperature, inlet air flow rate and accelerating pipe length on ISCs volumetric evaporative coefficient.
实验主要研究了空气进口温度、空气进口流量、液滴加速管的长度对ISC容积蒸发系数的影响。
The effects of system parameters such as system pressure, mass flow rate, heat flux and inlet sub-cooling are significant on both DWO and PWO.
系统压力、质量流速、热负荷和进口过冷度等参数对不稳定性有显著的影响。
Inlet conditions, discharge pressure, flow rate, and operating range must all be satisfied.
进气道的条件，排放的压力，流速，和经营范围都必须得到满足。
The parameters of water inlet conduit of the time-accumulating sediment sampler are one of the key factors for the flow rate at water inlet.
积时式悬沙采样器进口管路的结构和几何参数是影响采样器管嘴进口流速的关键因素之一。
Gas composition, volume flow rate, axial power, pressure and temperature of inlet and discharge gases of the compressor have been evaluated with the international general standard.
采用国际通用标准对压缩机气体组成、容积流量、轴功率、进排气压力和进排气温度等指标进行了测定。
The control options include inlet pressure control, discharge pressure control and flow rate control.
控制方式包括进站压力控制、出站压力控制和流量控制。
Result: the damp proof effect enhanced with the increase of inlet air temperature and the decrease of flow rate and air pressure.
结果：微囊防潮效果随着进风温度的提高、供液速度的降低、雾化气流速的降低而增强；反之则减弱。
In this article, the main influencing factors on condensation heat transfer include air flow rate, coolant flow rate, coolant inlet temperature and mixed gas velocity.
在本课题中，影响传热过程的因素主要有空气含量、冷却水流量、冷却水温度及混合气气速。
When more than one feed opening is required, the flow rate of each feed inlet must be carefully adjusted so as not to exceed the total capacity of the conveyor.
当需要开启一个以上进料口时，必须小心地调节限制每个进料口的流量，以使其总量不要超过输送机的设计能力限。
The results show that the effects of the Froude number, the dimensionless height of the particle bed and the inlet gas flow rate on mixing characteristics of the stirred bed reactor are significant.
结果表明，弗鲁德数、无因次装料高度及通气速率对混合特性有明显的影响。
Through experiments of changing the inlet air flow rate, we can adjust the hot air outlet temperature as high as possible, which helps to reduce the heat loss and improve the collector efficiency.
通过改变集热管进口空气流量来获得尽可能高出口温度的热空气，从而降低热损系数，提高集热效率。
An increase in the removal rate of formaldehyde resulted from elevated inlet formaldehyde loading rate by increasing formaldehyde concentration or flow rate.
在吊兰耐受范围内，通过提高入口气体甲醛浓度或流量增加甲醛负荷，均可增加吊兰对甲醛的净化速率。
Some parameters, such as the inlet air humidity and temperature, the regeneration temperature, the air mass flow rate, which may affect the performance of the desiccant wheels, were also analyzed.
实验研究发现在相同工况下，氯化锂转轮的显热效率、潜热效率均高于硅胶转轮。运行参数中再生温度、处理空气进口湿度对转轮除湿性能影响比较大。
Oil mist density and flow rate increase with the increase of pressure difference between inlet and outlet, and the atomization performance is enhanced significantly.
增大喷嘴进出口压差可以明显地提高油雾浓度和喷嘴的流量，喷嘴的雾化性能得到显著提升。
An effective method for maintaining the vacuum in condenser is to change the flow rate of circulating water according to its different inlet temperature.
在不同循环水进口温度条件下，合理改变循环水流量是维持凝汽器真空的有效办法。
The dryness and mass flow rate of inlet pulp have much effect on distribution of dried plant fibers, so the suitable preceding water content ratio is 376%.
进入干燥系统的竹纤维浆料含水率和载带率对干燥后竹纤维原料的分散性影响较大。
Inlet valve and seat, due to open and close more frequently, the liquid flow rate is high, sealing will soon expire.
进液阀芯和阀座，由于开启关闭比较频繁，液体流速高，密封很快就会失效。
The influences of the arrangement and diameters of inlet and outlet, the Oring layout, and the chamber height on the optimal for flow rate working frequency were studied experimentally.
测定了压电泵的进出口布置方式、进出水管管径、密封圈布置方式、腔体高度对压电泵流量最佳频率的影响规律。
The ratio of flow rate in the left fuel inlet to the right one affects significantly the temperature field and the most optimized ratio is 60%:40%.
两个喷嘴燃料流量的比例对阳极炭块的温度场影响很大，计算结果表明当左右两个燃料入口处燃料的流量比例为60%：40%时为最优工况。
The volumetric mass-transfer coefficient in packing increases with gas flow rate and rotating speed raises. Liquid flow rate and concentration of SO2 in inlet gas influences less on it.
转速和气体流量对旋转床填料层内的体积传质系数影响较大，流体流量和气相中二氧化硫浓度影响不大。
The volumetric mass-transfer coefficient in packing increases with gas flow rate and rotating speed raises. Liquid flow rate and concentration of SO2 in inlet gas influences less on it.
转速和气体流量对旋转床填料层内的体积传质系数影响较大，流体流量和气相中二氧化硫浓度影响不大。
应用推荐