装船速度是多少？
Maximum loading rate 100tonnes per hour.
最大装货速率是每小时100吨。
Do not exceed loading rate of 200tonnes per hour.
装货速率不要超过每小时200吨。
Higher pressure loading rate may cause higher green density.
加压速度快可获得高压坯密度。
Shall we get down to the loading rate now if you do not mind?
如果您不介意的话，我们现在来谈谈装船率如何？
So the regeneration of high loading rate sludge was noneffective.
对于高负荷污泥的再生是无效的。
Different loading rate gives different uniaxial tensile strength.
加荷速率不同，单轴抗拉强度值也不同。
Scatter and fracture surface roughness increases with loading rate.
分散性和断裂表面的粗糙度随加载率而提高。
And there exists a ductile to brittle fracture transition caused by loading rate.
存在由加载速率变化引起的韧脆断裂转变。
The greater the loading rate is, the stronger the charge-induced signal strength is.
加载速度越大，所产生的电荷感应信号越强、越丰富；
The acoustic emission energy signals become stronger with the increase of loading rate.
加载速率越大，声发射能量最大值也越大。
The design method was implying the new concept of Loading Rate both on fill phase and react phase.
该设计方法引入了“进水期污泥负荷”和“反应期污泥负荷”两个概念。
This paper presents an active generation scheduling method, which takes the Loading rate into account.
本文给出考虑负载变化率情况下有功发电分配的最佳方法。
The change of strength with loading rate is primarily due to the variation of cohesion with loading rate.
且强度变化主要是由于粘聚力随加载速率变化引起的。
The effect of loading rate on concrete splitting tensile strength for different lateral stresses is studied.
系统地探讨了有侧应力作用时，混凝土在不同加载速率下的劈拉强度规律。
It prefers cohesive failure at high temperature, otherwise it tend to interface failure at high loading rate.
提高温度有利于出现内聚破坏，而提高实验速度则易于出现界面破坏。
The result shows that the dynamic fracture toughness is affected by both the loading rate and the specimen size.
测试结果表明，岩石的动态断裂韧度同时受到加载率效应和尺寸效应的影响。
There is a fracture transition caused by loading rate. Through thermal activation analysis, a quantitative relationship was found.
通过热激活分析，获得了断裂激活能以及与温度和加载速率相关的定量化关系。
The experimental result has been revealed that the dissolved oxygen limiting is the main reason for high loading rate bulking problem.
试验结果表明高负荷引起的污泥膨胀是由于溶解氧限制所造成。
The results show that the method is simple and convenient, and can be used for measuring the crack propagation speed at high loading rate.
结果表明本文建立的方法简便易行，可用于高加载速率下裂纹扩展速度的测定。
The paper disclosed first a ductile to brittle fracture transition of PVC caused by increasing loading rate at several constant temperatures.
展示了聚氯乙烯（PVC）在不同温度下由试验速率增加而引起的韧脆性转化。
The effect of loading rate, test temperature and pre-plastic deformation on hydrogen induced apparent yield stress reduction have been investigated.
研究了变形速度，试验温度以及预先塑性变形程度对氢致表观屈服强度下降的影响。
A quantitative relationship between dynamic fracture toughness and temperature and loading rate has been obtained through thermal activation analysis.
通过热激活分析，可以获得定量描述动态断裂韧性、温度及加载速率之间的关系。
In column experiment during 21 days, it was observed that the granulated fly ash could continuously remove the phosphorus under high hydraulic loading rate.
还进行了为期21天的连续过滤试验，发现滤床在高水力负荷条件下能持续地去除景观水中的磷。
By means of parametric analysis, the effect of loading rate and anchor embedment on suction force and limit value of total tension resistance are discussed.
进而通过变动参数分析，讨论加载速率和埋深对吸力和总抗拉力极限值的影响，并给出排水和不排水加载条件对应的临界加载速率。
In this paper, a new type of sludge bulking problem caused by high loading rate is described, the control measures for this kind of problem has been studied.
提出一类高负荷的丝状菌污泥膨胀现象，并对高负荷引起的污泥膨胀控制进行试验研究。
The digester has a good resistance to fluctuation of organic loading rate and on different organic loading rate levels, however, the resistance is different.
消化器对有机质负荷率的波动具有良好的抗性，但所处的有机质负荷率水平不同，抗性各异；
An increase in the removal rate of formaldehyde resulted from elevated inlet formaldehyde loading rate by increasing formaldehyde concentration or flow rate.
在吊兰耐受范围内，通过提高入口气体甲醛浓度或流量增加甲醛负荷，均可增加吊兰对甲醛的净化速率。
The experimental investigation of the effect of loading rate on the tensile properties of PC/ABS and the analysis of the test results has been given in the paper.
从简单的拉伸试验着手，研究了应变加载速率对PC/ABS 高分子材料拉伸性能的影响，并对试验结果进行了详细分析。
Here, an approximate formula educed by dimensional analysis is presented, which involves fracture velocity and loading rate, to calculate kinetic energy increment.
而动能增量可由量纲分析法推导的能反映裂缝扩展速度和加载率影响的计算公式表示。
应用推荐