First of all, notice that you are potentially doing a lot of unnecessary work when the buffer runs out, since you are processing two buffers for each loop iteration.
首先注意，当缓冲区用尽时，可能要做许多不必要的工作，因为对于每个循环迭代都要处理两个缓冲区。
You then use register 127 as your loop counter and register 126 as your base pointer, and perform convert_to_upper on each value until you get to the end of the buffer.
然后再将寄存器127用作循环计数器，将寄存器126用作基指针，并在每个值上执行convert _ to_upper，直到到达缓冲区的底部为止。
The loop buffer in this paper can achieve the management of reference frame list correctly and efficiently.
本文设计了一种循环缓冲区，能够正确而有效的实现对参考帧队列的管理和维护。
It is a full symmetrically, current feedback amplifier followed by a diamond buffer that runs open loop.
这是一个完全对称，电流反馈放大器之后，钻石缓冲开环运行。
As shown in Figure 2-9, the guard buffer significantly reduces the charging time of CSHUNT because of the open-loop gain (AGUARD), which is typically 104 to 106.
如图2 - 9所示，由于保护缓冲放大器具有典型值为104到106的开环增益，所以能够大大减少CSHUNT的充电时间。
Buffer resistance R6: playing buffer effect on spark discharge current and hindering. The parasitic vibration brought by LC distributing parameters of high-voltage output loop.
阻尼电阻r 6：对火花放电电流起缓冲作用，并阻尼高压输出回路中lc分布参数引起的寄生振荡。
Buffer resistance R6: playing buffer effect on spark discharge current and hindering. The parasitic vibration brought by LC distributing parameters of high-voltage output loop.
阻尼电阻r 6：对火花放电电流起缓冲作用，并阻尼高压输出回路中lc分布参数引起的寄生振荡。
应用推荐