Also applies to a variety of mixing low-viscosity materials.
也适用于各种低粘度物料的混炼。
In any case, only good quality thin sections prepared by impregnating the sandstone with coloured low-viscosity plastic should be used.
在任何情况下，都只能用浸染过有色低粘性塑料的砂岩所制成的高质量薄片。
They can be dispersed in water, producing low-viscosity slurries that can be easily mixed and pumped, even at concentrations of greater than 35%.
它们可在水中分散，即使在浓度高于35％时，也生成易混合和泵送的低粘度浆液。
The ALICE experiment has confirmed the quark-gluon plasma is a ultra-low viscosity liquid at these energies.
ALICE实验已经确认了在这样的能量下，夸克——胶子等离子体是一种超低粘度的液体。
The melted rock has a low viscosity, and it flows easily up through the overlying rock.
被融化的岩石由于粘性较低，因此能轻易流到岩石层上方形成火山锥。
It must choose the sizing agent with high concentration, low viscosity and high fluidity, so can guarantee the constant sizing rate and suitable coverage and soakage.
必须选择高浓度、低粘度和高流动性的浆料组合，以保证恒定的上浆率和比例恰当的被覆与渗透。
Priming coating demands low viscosity and high saturation.
底层涂料要求低粘度，高浸润性。
A by product of the alleged collapse of HTA, which is equally surprising, is the existence of intermolecular multi quantum coherences (MQC) in low viscosity liquids such as water.
与声称的HTA失效同样令人惊讶的是其副产品之一，即认为在低粘度液体如水里，存在分子间的多量子相干(MQC)。
The effect of turbine mixer is the best to mixing the low viscosity pesticide and middle viscosity pesticide, and it is analysed in theory.
对低粘度和中等粘度的农药混配，涡轮式搅拌器的搅拌效果最好，并从理论上作了分析。
HCH-201 unsaturated polyester resin is designed for centrifugal casting molding glass pipe (HOBAS pipe) design of the structure layer resin is a low viscosity, medium reactivity of o-benzene resin.
201不饱和聚酯树脂是专门为离心浇铸成型玻璃钢管道(HOBAS管)设计的结构层树脂，是低粘度，中等反应性的邻苯型树脂。
Liquid injection molding utilizes low viscosity silicones which can be pumped at lower pressure and temperature, and cure in significantly less time and with less waste than solid materials.
液体侵渍模塑使用低粘度的硅树脂，在低压和低温条件下抽运，在极短的时间内固化，与固体材料相比，废弃物少。
Work with selected solvents of low viscosity of the formation of high concentration.
能与选定的溶剂形成高浓度低粘度体系。
Pale or red oils of low viscosity produced from dewaxed oils by distillation.
由脱蜡油蒸馏生产的低粘度浅色或红色油。
HCH-208C unsaturated polyester resin of a low viscosity, pre-casting used for unsaturated polyester resins.
208c不饱和聚酯树脂一种低粘度、预促进浇铸用不饱和聚酯树脂。
The adhesive has high cohesive strength, low nitrogen content and low viscosity.
该粘结剂具有粘结强度高、低氨、低粘度等优点。
Very low viscosity, Unfilled clear epoxy resin casting or impregnating material, has excellent physical and electrical properties.
无填充料、透明、低粘度的环氧树脂灌注材料，具有优良的物理、气性能。
Suitable for all low viscosity paints.
适合喷涂各种低粘度涂料。
The results indicated that low viscosity of SSOS with certain dextrose equivalent would be potential wall materials for microencapsulation of lemon oil.
研究结果表明一定葡萄糖值的低粘度ssos作为微胶囊壁材具有很好的包埋效果。
It is the material with low viscosity and some certain compressive strength.
为低粘度，具有一定的压缩强度的材料。
An unreinforced, low viscosity polybutylene terephthalate for injection molding. It has high flow characteristics and is specifically suitable for super fast production.
一个无加强，低粘度聚对苯二甲酸丁二醇酯的注塑成型。它具有很高的流动特性，并特别适合于超快速生产。
If dispersant is added in calcium carbonate grind, either high solid content and low viscosity paste may be obtained, or energy consumption and cost is lowered.
碳酸钙研磨中加入分散剂，既可得到高固含量、低粘度的浆料，又可以降低能耗，节约成本。
Finally, the principles of the preparation of high solid loading slurry with low viscosity are discussed.
最后，讨论了高固相、低粘度陶瓷浆料的制备原则。
Low viscosity, make easy de-greasing after tapping. Chlorine-free.
粘度低，加工后的脱脂作业容易，不含氯。
A high performance resin matrix for resin transfer moulding (RTM) was prepared by applying low viscosity anhydride to cure epoxy resin.
通过选用低黏度液体酸酐为环氧树脂的固化剂，制得了一种用于rtm的高性能树脂体系。
And it has more advantages on injection delivery because of its low viscosity and targeting character.
更由于其低黏度，可直接注射，以及靶向的特性在注射给药方面显示出独特的优势。
Because of the low viscosity of emulsion, valve type orifice was used in emulsion motor and the volumetric efficiency was ensued.
针对乳化液黏度低的特点，将所设计的乳化液马达采用了阀式配流，从而保证了较高的容积效率。
Because of the low viscosity of emulsion, valve type orifice was used in emulsion motor and the volumetric efficiency was ensued.
针对乳化液黏度低的特点，将所设计的乳化液马达采用了阀式配流，从而保证了较高的容积效率。
应用推荐