It is the maximum load before failure.
这是最高负荷前失败的。
The maximum load dosage was 160.89 rad.
超剂量照射人员中，最大累积吸收剂量为160.89拉德。
The maximum load of the lorry is one ton.
这卡车的最大载重量是一吨。
The maximum load for this lorry is one ton.
这辆卡车最大载重量是一吨。
The maximum load of each generator will be 90%.
每台发电机组最大运行功率为90%。
Turn off think time for maximum load generation.
关闭考虑时间，以便获得最大的负载产生。
Regulation load must within 30% to 70% of maximum load.
稳压测试负载必须在最大负载的30%至70%之间。
The condition and distribution of maximum load was determined.
确定最大载荷工况和载荷的分布情况。
The cast iron rod bushing provides maximum load bearing support.
铸铁连杆衬套提供最大承重的支持。
For example, a four-CPU system would have a maximum load average of 5.
例如，一个4CPU的系统可以承受的最大平均负载为5。
The longer bronze rod bushing provides a maximum load bearing support.
时间越长青铜连杆衬套提供最大承重的支持。
The longer cast iron rod bushing provides maximum load bearing support.
铸铁的时间越长连杆衬套提供最大承重的支持。
So that we can calculate the bone can withstand the maximum load is how much.
这样我们就可以计算出骨骼可以承受的最大负荷是多少。
Maximum load is being limited by the think time or by the number of virtual users.
考虑时间或虚拟使用者数目限制了最大的负载。
Copies the contained elements, hash function, predicate, maximum load factor and allocator.
复制所含的元素、散列函数、谓词、最大负载因子和分配器。
This is done by running regression tests against the application at a specified maximum load.
这个可以在运行回归试验时，通过加载特定的最大限度的负载来实现。
The maximum load on a bearing should always be smaller than the relief load in order to avoid scuffing.
为了避免划伤，轴承上的最大负荷应该总是小于其卸载负荷。
The maximum load that can occur on a bearing should be used in the calculation of the equivalent static bearing load.
应使用轴承可能承受的最大载荷计算轴承当量静载荷。
Load capacity contained by calculating safety factor that resistant to fatigue damage caused by the maximum load force.
负载能力通过计算抵抗最大负载力造成的疲劳毁损的安全系数得出。
The maximum load that the models can bear in the test meets the design load according to the structural similar theory.
试验结果与根据结构相似理论得出的结果相比较表明，模型受力性能较稳定，能承受最大荷载与理论计算的结果较吻合。
By analyzing different connection modes for load transfer, a model of the maximum load capability based on N-1 principle is given.
在线路满足N - 1原则的前提下，着重考虑主变n - 1原则下所能提供的最大负荷，给出了城市中压配电网最大供电能力的数学模型。
For a given specimen and notch configuration, maximum load is always dependent on the crack length and independent of the material.
对于特定的试样和裂口几何形状，最大荷载与裂纹长度有关，而与材料无关。
Model experiment shows that maximum load causing cracks of the masonry strengthened by expanded metal lath with mortar coat grows by 1.
模型试验结果表明，采用钢板网片水泥砂浆面层加固后的开裂荷载提高了1。
The effect of these nonlinearities can be avoided by determining compliance at the same maximum load for all crack lengths investigated.
这些非线性效应，可在测定所有裂纹长度的柔度方法时，采用最大载荷不变的方法予以消除。
The power supply efficiency shall be greater than65% under rated input voltage. It will be measured at the typical load and maximum load.
在额定输入电压，最大负载和额定负载条件下，电源的效率大于65%。
And according to the maximum load on the bolt, the method for designing the bolt is worked out, and an example of calculation is presented.
根据螺栓最大载荷，得出了螺栓的强度条件和设计方法，并举实例作了计算。
And according to the maximum load on the bolt, the method for designing the bolt is worked out, and an example of calculation is presented.
根据螺栓最大载荷，得出了螺栓的强度条件和设计方法，并举实例作了计算。
应用推荐