This paper provides a rigorous solution by the method of superposition.
本文以叠加法提供一个精确解。
Then, this paper introduces a new calculation method of superposition theory.
在此基础上，提出了本文的叠加理论计算公式。
Although we may analyze a continuous beam by several methods, only the method of superposition is practical.
虽然我们可以用几种方法来分析连续梁，但是只有迭加法是切实可行的。
This paper presents an exact solution for a free rectangular plate on elastic foundation by the method of superposition.
本文以叠加法提供在弹性地基上的自由矩形板的精确解。
By using the concept of generalized simply supported edge together with the method of superposition, we can solve this problem.
用广义简支边这个概念及叠加法，就可以解这类问题。
It is shown that this approach much more efficient than the conventional one, such as energy method, moment-area method, method of superposition and finite difference method.
这种方法优于传统的能量法，力矩面积法，叠加法，差分法等方法。
In this foundation, the method of curve superposition proposed by this article may easily obtain the total HRR curve and peak value of HRR by computer when a fire occurs in the room.
在此基础上，根据本文提出的曲线叠加法采用计算机就可以容易地得到发生火灾时室内总的热释放速率曲线和热释放速率峰值。
The dyadic Green's functions of two-layered earth are derived by the method of scattered superposition.
用散射、叠加方法推导出两层大地的并矢格林函数。
Then the linear superposition method is used to simulate irregular wave, and is verified by the autocorrelation method of wave spectrum estimation.
为模拟不规则波，采用了线性波浪叠加法。利用相关函数法进行谱估计，以检验不规则波造波效果。
In this paper, linear wave theory and wave superposition method are used to study dynamic behavior of oil or gas production risers on the offshore platform.
本文应用线性波理论，通过波浪叠加法，探讨了海洋平台油气生产立管系统的动力性质。
The viscoelastic damping control of steady-state harmonic response of stiffened plate is studied by using modal superposition method.
应用模态叠加法研究了用粘弹性阻尼控制加筋板的稳态简谐响应。
Finally, in dynamic research, the impulsive loads of the frame are studied and dynamic response of the typical process is calculated and analyzed with modal superposition method.
最后进行了动态分析，对冲击载荷进行了研究，采用模态叠加法对典型工艺的动态响应进行计算。
The proposed approach can offer an exact solution for dynamic response of base-isolated structure, through using the complex mode superposition method.
利用复数振型叠加法，这种求解方法能够得出结构动力响应的精确解。
The DC superposition method was mainly utilized because it was ripe theory about On-line Insulation Monitoring on the XLPE power cable, in addition of the DC partial current method.
本系统电缆绝缘在线监测理论，以比较成熟的直流叠加法为主，加上直流分量法作为理论基础。
Rationality of the method is proved in theory of(linear)circuit superposition principle.
通过电路叠加原理从理论上证明了该方法的合理性。
This method is different from usual method, we use the concept of electric flux and principle of superposition for the electric field.
与一般方法不同，本文利用电通量概念及电场叠加原理，推导出电场能量密度的普遍表达式。方法简明。
Prandtl-Vesic of ultimate bearing capacity of strip foundation belongs to the plane strain problems, which adopt step superposition method to obtain the formula of ultimate bearing capacity.
勃郎特-维西克研究的条形基础极限承载力属于平面应变问题，采用分步叠加法，求得地基极限承载力公式。
In the structure, the (equal) integration area method was used to determine the control switch Angle, and the sinusoidal voltage wave was obtained by means of the concatenate superposition.
该结构利用积分面积相等的原则确定开关角，通过串级叠加的方法得到标准正弦波输出。
This paper presents a method to use Nonlinear Superposition Design, which can improve start characteristic of lift car.
本文主要介绍作者在实践的基础上提出的采用非线性迭加的方法改善调压调速电梯的起动性能。
This paper presents a new method with driver transformation for the kinematic analysis of the planar mechanisms in high class, based on the Assur group theory and kinematic superposition principle.
本文依据阿苏尔杆组理论及运动迭加原理，提出了一种新的高级机构运动分析方法——变换原动件法。
Light scattering matrix of random oriented two spheres system is studied extensively by using the t matrix method and the principle of superposition.
本文用T矩阵与场方程叠加相结合的方法，系统研究任意方位双球粒子体系散射矩阵各元素随两球球心的间距变化规律。
The generalized concepts on superposition method in mechanics of materials are elaborated.
阐述了“叠加法”在材料力学中较广义的概念。
Numeral superposition method of temperature and stress field in the rotor of steam turbine is studied in the paper.
探讨了汽轮机转子温度、应力场的数值叠加算法。
Generated a finite element mesh in existence numerical method, node superposition of concrete and reinforcement element is difficult to curved tendon box girder.
现有有限元数值分析方法在单元划分时，要求预应力钢筋单元与混凝土单元节点必须重合，这对曲线布束的箱梁很难满足这一要求。
The superposition method of single-open chain is a new method which is quite convenicnt for doing the type synthesis by computers.
单开链迭加法是一种适应于在计算机上进行的机构类型综合的新方法。
With regard to the nonlinear kinetics problems of a rotor system the direct integration method is more effective than the modality superposition method.
对于转子系统非线性动力学问题，直接积分法比模态叠加法更为有效。
To predict the wheel's noise radiation, a FEM analysis model of the wheel is developed. Based on the modal superposition method, the radial receptance of the wheel is calculated.
为了预测车轮辐射的滚动噪声，本文建立了车轮有限元模型，对车轮进行了模态分析，并运用模态叠加方法计算了车轮的径向导纳。
The modal superposition method is often used for computing the Perturbation of eigenvectors in the modification for structural and correCtion for model.
模态展开法是计算特征向量摄动量的常用方法之一，但当高阶模态被截断时。
In the present paper, the superposition method of the complex stress function is extended to calculate the general problems concerning radial cracks emanated from the multiple circular holes.
本文将复变应力函数的迭加解法进一步推广应用于求解一般的多孔边裂纹问题。
In the present paper, the superposition method of the complex stress function is extended to calculate the general problems concerning radial cracks emanated from the multiple circular holes.
本文将复变应力函数的迭加解法进一步推广应用于求解一般的多孔边裂纹问题。
应用推荐