Regulating pilot valve outlet pressure spring can be set.
调节导阀弹簧即可设定出口压力。
Low table by adjusting the outlet pressure control screw.
调节螺钉落在凸轮高点上。
The compressor - outlet pressure is nearly constant around the circumference.
压气机出口压力沿圆周方向接近于常数。
Detecting and displaying oil flow rate, oil temperature and purified oil outlet pressure.
数字显示通油流量、油温、净油出口压力。
Note: the outlet pressure is greater than the inlet pressure, the media will pass anti-wizard.
注：出口端压力大于进口端压力，介质会反向导通。
According to measured data, the variation of outlet pressure of building regulator is discussed.
根据实测数据探讨了楼栋调压器出口压力的波动情况。
Rotate button to the right to increase outlet pressure, rotation to the left to reduce the outlet pressure.
旋转钮向右为调高出口压力，向左旋转为调低出口压力。
Calculate the pressure difference by subtracting the desired outlet pressure from the maximum inlet pressure.
通过从最大进口压力减去所需要的出口压力来计算压差。
Calculate the pressure difference by subtracting the desired outlet pressure from the maximum inlet pressure.
基本平衡单阀座最大限度减小进口压力变化对输出压力的影响。
When turning gear from middle to maximum angle of steering gear, the suction and outlet pressure must be attention.
在将舵从中位转至最大舵角时应注意进，回油油路压力值。
In the steady state, the control room water, drainage same, the main valve opening constant outlet pressure stability.
在稳定状态下，控制室进水、排水相同，主阀开度不变，出口压力稳定。
When the valve outlet pressure to a pilot valve spring set pressure, pilot valve opens, the control room to the downstream drainage.
当阀门出口压力降到导阀弹簧设定压力时，导阀开启，控制室向下游排水。
So, when the outlet pressure to the brakes as it is set the pressure relief valve when the valve is opened, the motor is also braking.
如此，当出口处的压力增加到刹车溢流阀所调定的压力时，阀被打开，马达也刹车。
Control room to stop the drainage, when the main valve control room pressure rise and close the main valve outlet pressure will not rise.
控制室停止排水，此时主阀控制室内压力升高并关闭主阀，出口压力不再升高。
The paper analyzed the influence of the orifice ratio on maximum discharge, the inlet pressure, outlet pressure, differential pressure, ect.
文章分析了孔板的开孔率对管路最大流量、孔板前压力、孔板后压力和孔板前后压差等的影响。
In order to avoid screw pump is damaged, usually installed in the screw pump bypass relief valve outlet to a stable outlet pressure, keep the pump running.
为了避免螺杆泵损坏，一般会在螺杆泵出口处安装旁通溢流阀，用以稳定出口压力，保持泵的正常运转。
The catalyst pretreatment method ensures that the outlet pressure of the catalyst feed pump is remarkably lower, and catalyst feed is stable without blocking.
采用本发明的催化剂的预处理方法使得催化剂进料泵出口压力明显偏低，催化剂进料稳定，无堵塞。
Several calculating methods for determining the air-flow rate, the exhaust temperature, the compressor outlet pressure and the turbine inlet pressure are compared.
对四冲程柴油机增压系统的空气流量，排气温度、压气机出口压力和涡轮进口压力的若干种计算方法进行了分析。
To this end, it is detected from the simulation results that the equivalent valve damping length and decompressing chamber volume significantly affect the outlet pressure.
分析结果表明：阀内流道的等效阻尼长度和压力反馈腔体积是影响阀出口压力的重要因素。
And then the influence of the inlet flow's Mach, the outlet pressure, Angle, high velocity to the structure and major performance parameter of inlet's flow field are analyzed.
分析了来流马赫数、出口反压、攻角、高速旋转等因素对进气道流场结构及主要性能参数的影响。
Indication of inlet-outlet pressure difference between master cyclone inlet and outlet; local indication of pressure difference between high-efficiency filter inlet and outlet.
主旋风分离器进出口压差显示，高效过滤器进出口压差现场显示。
Estimates capacity and power required for compressing a gas mixture from an Inlet pressure to Desired Outlet pressure for a given cylinder diameter, rod diameter, stroke length and RPM.
此压缩机在线计算程序可计算从入口压力压缩到出口指定压力，在给定活塞直径、连杆直径、冲程长度和转速的情况下，压缩气体混合物所需的压缩机容量和功率。
Outlet pressure and flow are normally controlled by adjusting valve clearance and it causes considerable energy waste. Frequency control of motor speed is a method of solving the problem.
常规的通过调节阀门开启度来达到调节注水泵出口压力和流量的作法，会使很大一部分能量造成浪费，要解决这个问题，可以采取对注水泵进行调速的方法。
By applying black box theory inlet pressure, inlet subcooling, outlet pressure and valve opening are selected as influence factors to flow coefficient of electronic expansion valve (EEV).
根据黑箱理论提出将阀前压力、阀前过冷度、阀后压力和膨胀阀流通面积作为膨胀阀流量系数的影响参数。
It can be concluded that cavitation of hydraulic cartridge cone valve is reduced by increasing the opening stroke and the outlet pressure and changing the geometrical structure of valve spool.
研究表明：增大阀口开度，增大出口压力，并对阀芯结构进行修改后，插装型液压锥阀阀口气穴现象均可有效减弱。
USE: Argon gas flow meter are used to regulate the high pressure argon gas in cylinder for required working pressure, and ensure outlet pressure steady when input pressure and outlet flow change.
用途：氩气流量计适用于氩气气体保护焊、农业植物培养、化工等行业。输入压力可变时，流量仍可在规定范围内保持其稳定的流量值。
USE: Argon gas flow meter are used to regulate the high pressure argon gas in cylinder for required working pressure, and ensure outlet pressure steady when input pressure and outlet flow change.
用途：氩气流量计适用于氩气气体保护焊、农业植物培养、化工等行业。输入压力可变时，流量仍可在规定范围内保持其稳定的流量值。
应用推荐