When failures happen, have software quickly identify those failures and retry requests.
发生故障时，让软件快速识别失败并重试请求。
You can also set the connection retry interval.
您还可以设置连接的重试时间间隔。
Best practice indicates that exception handling should include retry logic (where possible) or routing the task to an administrator to resolve.
最佳实践表明，异常处理应该包含重试逻辑(如果可能)，或者将任务路由给管理员处理。
If the retry fails, then custom DLQ rules should be used to forward or remove the messages as needed.
如果重试失败，则应该使用自定义的DLQ规则，根据需要转发或删除消息。
This section explains how to view and edit this retry setting, and describes special conditions when this setting is ignored.
本部分阐述如何查看和编辑此重试设置，并介绍忽略此设置时的特殊条件。
The difference between these numbers is the flow's maximum retry count).
这些数值之间的区别在于消息流的最大重试计数）。
And then, of course, there are those cases where the client notices the error response code; you can't simply retry.
然后，当然，也有一些情况下，客户端注意到错误的相应代码；您不能简单的重试。
You might need to promote properties that enable administrative control over, for example, invocation style, alternate routing, and retry configuration.
您可能需要提升那些能够对调用方式、备选路由和重试配置等等启用管理控制的属性。
If interference is detected, they back off and retry.
如果发现干扰，就会回退并重试。
The number of retries and the retry interval is configurable.
重试的次数和间隔是可配置的。
Which steps required a retry, and how many retries?
哪些步骤需要重试以及要重试多少次？
Then retry the build operation and it will complete successfully.
然后重试构建操作，就会成功完成了。
After a communication failure, random delays are introduced before retry to frustrate certain classes of attacks.
通信失败后，在重试阻止某些攻击类之前引入随机延迟。
If the API of a dependent service is idempotent, that means it is safe to retry failed requests.
如果所依赖服务的API是幂等的，那就意味着可以安全地对失败请求进行重试。
If you mess up, it will tell you to retry.
如果你做错了，它会提示你重试。
This enables the use of "retry" logic if necessary.
这支持在必要时使用“重试”逻辑。
备用连接重试。
The runtime support uses this retry to automatically resend the request to a service that responds with a failure.
运行时支持使用此重试将请求自动重发到响应为故障的服务。
A last requirement for the TCS is to implement retry and recovery for when transactions fail.
TCS的最后一个需求是在事务失败时实现重试及恢复。
The TCS may also implement retry semantics.
TCS也可以实现重试语义。
Make any necessary changes, confirm them, and click Configure to retry the configuration.
执行一些必要的更改，然后确认并单击配置以重试配置。
In addition to specifying the timeout, you can specify a retry count with an optional delay.
除了指定超时以外，您还可以通过可选的延迟来指定重试计数。
While DRS will attempt to retry the send of the session, it might eventually fail if the congestion still exists with each retry.
虽然DRS将尝试重新发送会话，但如果在每次重试时仍然存在拥塞，可能最终会失败。
The duration does not take into account the retry delay, since this is not part of the execution time.
其持续时间没有考虑重试延迟，因为这没有包含在执行时间中。
Retry support has been added, allowing a retry count to be specified on the primitive.
增加了重试支持，允许在原语上指定重试计数。
To retry indefinitely, use the value -1.
要进行不确定性重试，可以使用值-1。
Automatic retry of download across all available sources.
在所有可用资源范围内自动重试下载。
The retry is used in case a concurrency exception does occur in the query table execution and the query table engine needs to retry the claim operation.
重试仅用于查询表执行时出现并发异常且查询表需要重新申明的情况下。
Retry on: Determines whether, and how, fault responses cause a retry. The following values are valid
Retryon（重试条件）：确定错误响应是否导致重试以及导致重试的方式。
Retry delay: Sets the delay (in seconds) between retry attempts.
Retrydelay(重试延迟)：设置重试尝试之间的延迟(秒)。
应用推荐