The paper mainly focus on the experimental research on pneumatic on-off valve motor position servo control system with PCM control method and self-adjusting PID algorithm.
文章主要研究的内容为利用PCM控制技术，采用自适应PID控制算法，对开关阀式气动马达位置伺服系统进行实验研究。
This paper give an advice that we can realize closed cycle control of feeding shaft by proportional valve and linear grid ruler instead of servo amplifier and servo motor.
利用比例阀和线性光栅尺配合使用替代伺服放大器和伺服电机实现进给轴的闭环控制。
So instead of using Nd-Fe-B Alnico motor to reduce the size of the torque, but also on reducing the size of the servo valve, a reduction of quality, cost savings.
这样用钕铁硼代替铝镍钴就缩小了力矩马达的体积，也就可以缩小了伺服阀的体积，减少质量，节约了成本。
This instrument can output 3v power to servo valve and is convenient for testing servo valve and oil motor at site.
本仪器可输出3V电源给伺服阀，便于伺服阀和油动机现场调试使用。
A weighing sensor (5), the stepper motor driving the digital servo valve and the coder (10) on the digital valve (1) are respectively connected with the PLC (7) by signal circuits.
所述的称重传感器(5)、驱动数字伺服阀的步进电机以及数字阀(1)上的编码器(10)分别通过信号线路与所述的PLC(7)连接。
The design concept of the relative frequency amplitude ratio and the relative frequency width of toque motor stiffness of electro-hydraulic servo valve are proposed.
提出了利用相对频率幅值比和相对频宽的电液伺服阀力矩马达的设计概念。
In this paper, the electro-hydraulic servo system is valve-controlled motor, mainly include electro-hydraulic servo valves, amplifier, hydraulic motors, and other feedback components.
本文中电液伺服系统为阀控马达系统，主要包括电液伺服阀、放大器、液压马达、反馈元件等。
The most important character of this system is using AC timing motor to replace electro-hydraulic servo valve.
它最重要的特点就是使用交流调速电动机代替传统的伺服阀。
Utilizing GMM to design new-type actuator, replacing traditional actuator such as the torque motor or the force motor, will enhance the response speed and precision of electro-hydraulic servo valve.
利用GMM设计新型的电—机转换器，取代传统型电—机转换器，如力矩马达或力马达等，可提高整个电液伺服阀的响应速度和控制精度。
This system was composed of industrial control computer, PCL-832 servo-type motor control board, servo-type amplifier, servo-type valve and hydraulic motor.
该系统主要由工业控制计算机、PCL—832三轴伺服马达控制板、伺服放大器、伺服阀、液压马达等组成。
This system was composed of industrial control computer, PCL-832 servo-type motor control board, servo-type amplifier, servo-type valve and hydraulic motor.
该系统主要由工业控制计算机、PCL—832三轴伺服马达控制板、伺服放大器、伺服阀、液压马达等组成。
应用推荐