According to usage the top of flange surface minor faults proceed experiment and study, thought it do not affect HR H-beam.
通过对热轧H型钢翼缘端部表面瑕疵进行试验、研究，认为翼缘端部表面瑕疵不影响热轧h型钢的使用。
Caution: the sealing surface for the diaphragm on the top flange of the valve body receives special factory preparation to enhance sealing with PTFE diaphragms.
警告：用于阀体法兰上的隔膜的密封面在工厂受到特殊的处理，以强化聚四氟乙烯隔膜的密封性能。
The formulas for calculating top limitation of drawing originated from the deformation limits on the flange and the wall of cylindrical articles are developed.
从圆柱形零件的凸缘上和壁上的允许变形出发，获得了极限拉伸程度的计算公式。
This paper researches the plane stiffness of new composite structure for slab on the lower flange, which is compared with the traditional structure for the slab on the top flange.
本文研究了将楼板置于钢梁下翼缘的新型组合结构平面刚度，并和传统的将楼板置于钢梁上翼缘的结构形式的平面刚度和极限承载力作了比较。
At the top flange there would be enough slack so that no relative twist of any significant magnitude would be introduced into the girder web.
在上翼缘处有足够的松动，因而在主梁腹板上并不会引起很大的相对扭转。
Time for the third kind of closing well is so long that flange steel ring groove on the top of casing-head is heavily corroded in M4 well being situated in Tarim basin.
位于塔里木盆地的M4井，由于三类封井时间较长，造成套管头上部法兰钢圈槽严重腐蚀。
The top flange of an extension stem, plug shaft diameter, and distance across flats on plug shaft are the same size as the valve selected.
订购时，请指明阀门尺寸、规格型号，以及从阀门法兰到延长件法兰顶部的准确距离（用户指定的长度如右图所示）。
Visual observations showed that a horizontal displacement in the longitudinal direction of the bridge developed between the tie girder and the top flange of the floor beam at the end connection.
肉眼观察表明：在端节点处的系梁和横梁上翼缘之间产生一种沿桥梁纵向的水平位移。
The at least one web extends vertically from at least one of the top and bottom of the header pipe and is connected to the flange.
至少一个腹板从集管管道的顶部和底部中至少一个竖直延伸并连接到凸缘上。
With the valve in the fully closed position the stem length shall protrude a distance of at least twice that of the stem diameter above the top of the mounting flange.
在阀门完全关闭状态下，阀杆在连接法兰顶端上方需高出至少相当于阀杆直径两倍的长度。
When ordering, specify valve size, figure number, and the exact distance from the valve flange to the top of extension flange (customer-specified length shown at right).
订购时，请指明阀门尺寸、规格型号，以及从阀门法兰到延长件法兰顶部的准确距离(用户指定的长度如右图所示)。
This method will avoid the problem that the result is too conservative when the neutral axis lies in the top flange of the steel member as the traditional method dose...
当中性轴住于钢梁上翼缘时该方法能够给出计算简便且与试验值吻合较好的计算结果。
This method will avoid the problem that the result is too conservative when the neutral axis lies in the top flange of the steel member as the traditional method dose...
当中性轴住于钢梁上翼缘时该方法能够给出计算简便且与试验值吻合较好的计算结果。
应用推荐