Optimum combination of tolerance levels and basic deviation of each element are given.
给出了各元件的基本偏差及公差等级的优化组合。
A system formed by both the tolerance zone of the shaft with definite basic deviation, and that of the hole with different basic deviations.
一定的轴的公差带与不同基本偏差的孔的公差带形成各种配合的一种制度。
In this method, the machining tolerance of parts can be enlarged several times according to the allowable deviation of assembly precision requirement.
这种方法零件的加工公差按装配精度要求的允许偏差放大若干倍，对加工后的零件测量分组，对应的组进行装配，同组可以互换。
The test result shows that maximum tolerance of the simulated ambient pressure deviation is about 14% under which the engine thrust uncertainty remains less than 1.0%.
试验结果表明，在保证推力不确定度优于1.0%的条件下，拉瓦尔喷管发动机高空模拟试验的模拟偏差容限约为14%。
The coaxiality tolerance assesses the deviation of the axis from the datum axis, while the radial run-out tolerance assesses the deviation of the circumference line from a coaxial circle.
同轴度公差评估的是轴线相对于基准轴线的偏差，而径向跳动公差则评估的是圆周线相对于同轴圆的偏差。
Major cause of deviation of bottom added from the axis of the cell with iron can were structure imperfection of iron can and processing tolerance.
引起铁壳电池加底偏心的主要原因是铁壳结构缺陷和加工误差。
This paper presents the tolerance range displacement method, with which the basic deviation of a hole is determined and therefore the basic hole system becomes the basic shaft system.
提出了公差带位移法，以此来确定孔的基本偏差，使基孔制变成了基轴制，并给出计算实例。
The design guideline of the plastics products with insert film decoration and the position deviation experience tolerance of the film pre-form process are discussed.
同时讨论了模内复膜产品设计原则以及装饰膜的预成型工艺及其公差经验值。
With two meters by ruler of wall structure, inspection, shall not exceed 5 mm maximum deviation, cut or out-of-tolerance part should be picked with a than three repair cement mortar leveling.
对结构墙体，用两米靠尺检查，最大偏差不得超过五毫米，超差部分应剔凿或用一比三水泥砂浆修补平整。
With two meters by ruler of wall structure, inspection, shall not exceed 5 mm maximum deviation, cut or out-of-tolerance part should be picked with a than three repair cement mortar leveling.
对结构墙体，用两米靠尺检查，最大偏差不得超过五毫米，超差部分应剔凿或用一比三水泥砂浆修补平整。
应用推荐