At the end of the kernel boot sequence, the init process starts.
在内核引导序列的结尾，会启动init进程。
The boot sequence for Mepis is a bit different than that of Knoppix.
Mepis的引导顺序与Knoppix稍有不同。
You will change the boot sequence for the new JS20 blade server from this screen.
您将通过这一屏幕改变新的JS20刀片服务器的引导次序。
In particular, it expects user interaction for its boot sequence and configuration.
特别地，它希望在确定其引导顺序和配置时能与用户进行交互。
During the boot sequence of the AMI instance, you are asked to set the password for this user.
在ami实例启动期间，将要求您为该用户设置密码。
First you must set up the boot sequence in the BIOS.
首先你必须在BIOS中设置启动顺序。
The first thing you will want to do is change the boot sequence of the JS20 blade server from Hard disk to CD-ROM.
首先要做的是，将JS20刀片服务器的引导次序由Harddisk改为CD-ROM。
The init process — the focus of this article — is the first process created as the kernel boot sequence is completed.
init进程——本文的重点——是内核引导过程完成时创建的第一个进程。
The technique achieves this by allowing the latter part of the boot sequence to be run in parallel, rather than in the traditional serial fashion.
这种方法允许系统在启动服务时启动顺序中靠后的部分服务并行启动，而不是以传统的串行方式启动，以实现引导的加速。
Select Set Boot Sequence: Configure as 1st Boot Device.
选择设置引导顺序：配置为第一引导设备。
Select Set Boot Sequence: Configure as 1st Boot Device.
选择设置引导顺序：配置为第一引导设备。
应用推荐