A pulse constant-current source based on capacitor discharge was developed for LIA accelerator.
针对大型直线感应加速器单次工作的特点，研制了一种电容放电式脉冲励磁电源。
The problem of splash is more serious in capacitor discharge projection welding than in ac welding.
电容储能凸焊的喷溅问题比交流凸焊更为突出，研究影响喷溅发生的因素就显得更为重要。
The ignition of capacitor discharge is a process of oscillation by capacitor discharging to RL circuit set.
电容放电点火过程实质是电容对RL电路的振荡放电过程。
This particular system is different from the conventional magnetic inductive system and is called Capacitor Discharge Ignition (CDI).
这种点火方式与传统的通过电磁感应产生高电压点火方式不同，被称为电容放电点火(CDI)。
The effect of electromagnetic force on the splash, joint strength and welding process of capacitor discharge projection welding is studied.
研究了焊接过程中焊接电流产生的电磁力对电容储能凸焊喷溅、接头强度及焊接工艺的影响。
The results show that the welding of TC4 can be realized by capacitor discharge welding. The joint microstructure consists of nugget zone and semi-melt zone.
结果表明：储能焊能够实现TC4钛合金薄板的快速凝固焊接，焊接接头由熔核和熔核向母材过渡的熔合区（线）组成。
After a capacitor is disconnected from a discharge circuit, a residual charge remains on the capacitor, so a voltage is re-established across the capacitor terminals.
电容器从放电电路断开以后，电容器中保持剩余的电荷，从而在电容器的端子之间重新建立起电压。
The quality of electrolytic capacitor was judged by self-discharge voltage.
用自放电电压的高低来判定电容器的质量。
This paper tries to predict the insulation ageing of power capacitor according to the pole-to-case partial discharge test.
本文试图根据电容器极对壳绝缘的局部放电试验结果，对其绝缘老化进行判断。
These reverse-biased photodiodes discharge a capacitor at a rate proportional to the photon flux.
这些反偏压发电二极管在一种均衡的速率下释放一个电容器给光子通量。
This article also analyzes the discharge characteristics of a kind of pulse capacitor with the capacitive resistor divider.
该文用阻容型分压器分析了一种脉冲电容器的放电特性。
Test result of dielectric strength, partial discharge and endurance property are analyzed and contrasted between solid dielectric is two film and tree film in model capacitor elements.
本文比对分析了极间介质为两层膜和三层膜的模型电容器元件的介电强度、局部放电性能以及耐久性能的试验结果。
A fast discharge rare gas halide excimer laser with symmetric geometry pumped by glued and hot pressed capacitor is introduced.
本文介绍了一台以热压胶合双层平板电容器泵浦的对称结构快放电稀有气体卤化物准分子激光器。
The normally closed contact of the Model 7169A serves to discharge the capacitor after it has been measured.
在测量完成以后，7169A型的常闭接点使电容器放电。
With the technique, a reset circuit of automatic discharge for energy captured in the turn-off snubber capacitor is also presented.
结合此技术，还提出了关断缓冲电容器能量的自动放电复位电路。
The estimating methods of the values of the discharge capacitor and limiting resistance in design of the constant current source are also given.
在恒流源设计上，本文简略给出放电电容和限流电阻的估算方法。
There are fire retardant components, discharge components as well as self-protection components in the internal of capacitor.
电容器内部设置阻燃元件，放电元件以及自保护元件。
The partial discharge can be generated continuously in the short oil capacitor under lower voltage, which finally leads to the damage of capacitor.
电力电容器缺油会在较低电压下产生持续局部放电，最终破坏电容器。
This thesis gives a detailed introduction of a pithy formula, which applied to estimate discharge energy and discharge resistance of shunt capacitor, with the help of experience coefficient.
介绍了用经验公式估算无功并联电容器的放电能量和放电电阻的口诀。
The first USES the light falling on the photodiode to discharge the capacitor, turning off the device once the required light output has been generated.
第一种方式是透过光电二极体上的光源减少来对电容器进行放电，一旦所需的光源输出被产生之后就关闭装置。
Suitable for instantaneous discharge after electrifying capacitor for pluse circuits.
适用于电容器充电后瞬间放电的脉冲电路中。
In this paper, the aging failure mechanism of HV ceramic capacitor under high frequency discharge and recharge is studied and a series improving methods are put forward.
本文对高压陶瓷电容器在较高频率充放电作用下的老化破坏机理做了较为深入的研究，并提出一定的改进措施。
In this paper, the aging failure mechanism of HV ceramic capacitor under high frequency discharge and recharge is studied and a series improving methods are put forward.
本文对高压陶瓷电容器在较高频率充放电作用下的老化破坏机理做了较为深入的研究，并提出一定的改进措施。
应用推荐