Usually, 50-100 ms delay time is normal.
通常来讲，50- 100毫秒的延迟时间都属于正常的范围。
The influence of delay time on the dynamics of the system.
延迟时间对系统动力学的影响。
Adjusting delay time and gas pressure can reduce the warpage of the part.
工艺上可以通过调整延迟时间和气体压力来减小产品的变形量。
Its power dissipation and propagation delay time are a tradeoff of the two comparators.
其功耗和传输延迟时间介于两种比较器之间。
The design and fabrication of BAW delay lines with ultra short delay time are described.
叙述了超短延时声体波微波延迟线的设计和制作。
By using different inductance values in a discharge circuit, the delay time can be changed.
通过改变放电回路中的感抗值，可以改变预电离与主放电之间的延迟时间。
The crowd evacuation time in a fire includes the preevacuation delay time and the travel time.
火灾中人员的疏散时间主要包括疏散前的延迟时间和在通道上的疏散时间。
In this filter, the delay time can be given arbitrarily, which simplifies the design procedure.
滤波器的时滞时间可以任意给定，简化了设计过程。
The ignition temperature and ignition delay time decreased with the increasing radiant heat flux.
结果表明，随着辐射热能流率的增加，着火时间缩短，着火温度降低；
The advantage of the method is illustrated by the self-adaptive regulation of the system delay time.
这种方法的优越之处可以由系统延迟时间的自适应调节得以显示。
Because of its small screening radius and short delay time, graphite is chosen as the cathode material.
在电子束产生过程中，屏蔽半径应尽可能地小，且击穿延时时间较短，故选择石墨作为阴极材料。
The practice has shown that the initiation delay time is an important factor affecting cut blasting effect.
工程实践表明，微差起爆时间是影响掏槽效果的一个重要因素。
This result not change by and large when object, the length of data, embedded dimensions and delay time change.
这一结果基本不受个体、数据长度、嵌入维数以及延迟时间的影响。
Flexible setup of measurement time, number of data points for each measurement and delay time after flash trigger.
非常灵活地设置测量时间和每次测量数据点的数目及闪光触发后的延迟时间。
The shooting delay time as result of the equipped shooting gate is studied for the weapon system with shooting gate.
针对具有射击门体制的武器系统，研究其因加入射击门而产生的射击延时。
In view of the uncertainty of rolling delay time, the method of multi-objective gray state decision making is applied.
灰色局势决策方法是一种不依赖于过程模型先验知识的目标决策方法。
The strong time constraints are the time constraints when the delay time of Control Data Flow Graph (CDFG)is not satisfied.
强时间约束是指控制数据流图CDFG的延迟时间无法满足的时间约束。
For different delay time, the optimal strategies have been obtained by using the method of multi-target gray state decision.
根据不同待轧时间，采用多目标灰色局势决策方法，得出了相应合理的待轧优化控制策略。
The object of the control arithmetic is to make the traffic trunk road unblocked and the average vehicle delay time shortest.
控制算法在保证交通畅通的情况下，使车辆延误时间尽可能地短。
A concrete algorithm of selecting delay time in the state space reconstruction in the mutual information method is introduced.
介绍了相空间重构中确定重构延迟时间的互信息法理论及其具体的计算方法。
The ignition delay time was studied on the hot position bench that could stimulate combustion process of traveling grate furnace.
在可模拟链条炉中燃烧过程的热态实验台上，研究了块粒型煤的着火时间。
The time needed to reach the steady value, or the settling time, can be used to determine the proper delay time for the measurement.
达到稳定值所需的时间，或者说是稳定时间，可被用来确定合适的测量延迟时间。
There always exist long delay time in process control and good control effects may not be obtained by using traditional control methods.
工业生产过程中常有大时滞存在，用传统控制方法不能获得满意的控制效果。
The key to achieving initiative control of vibration damage by means of wave interference is to ascertain reasonable delay time interval.
用微差干扰降震法实现爆破震动灾害主动控制的关键在于确定合理的微差延期时间。
Based on LMI and delay time-derivative dependent control methods, a robust controller is designed to achieve exponential tracking stability.
本文基于线性矩阵不等式（LMI）和时延相关控制方法，设计一个控制器以实现指数稳定的跟踪控制。
The relationship of embedding dimension and delay time is discussed and a new concept namely the generalized embedding Windows is put forward.
论述相空间重构中延迟时间与嵌入维数之间的关系，提出广义嵌入窗长的概念。
There was an initial delay time at either switching the step current on or off, which was caused by the magnetizing or de-magnetizing process.
无论是在突加电流还是在去掉电流的过程中，都存在着一个由磁化或去磁过程引起的初始滞后时间。
This algorithm can overcome the infection of the digital controller's delay time to harmonic compensation and realize the real time compensation.
该算法能够克服数字式控制器所产生的延迟时间对于谐波补偿的影响，可实现谐波的实时补偿。
It is difficult to have good performance for chain boiler combustion control system due to large delay time, varying coal's quality and steam load.
大纯时延、煤种多变和蒸汽负荷频繁变化是链条炉难以进行良好燃烧控制的原因。
It is difficult to have good performance for chain boiler combustion control system due to large delay time, varying coal's quality and steam load.
大纯时延、煤种多变和蒸汽负荷频繁变化是链条炉难以进行良好燃烧控制的原因。
应用推荐