The fuel system only has several major parts such as fuel tank, fuel pump, fuel filter, carburetor, intake manifold, etc.
燃料系只有这样几个主要部件，如燃油箱、输油泵、燃油滤清器、化油器、进气歧管等。
Position locknut over top of fuel pump module.
将锁定螺帽放在燃油泵模组上。
The poor lubricity of low sulfur diesel fuel results in the bad wear of fuel pump.
低硫柴油的润滑性差，导致燃油泵严重磨损。
The electric fuel pump is an important part of the automobiles fuel-supplying system .
电动燃油泵是汽车燃油供给系统的重要组成部分。
The mechanical fuel pump is used on many vehicles with carburetors and driven by the camshaft.
机械驱动燃油泵用于许多化油器式车辆，它由凸轮轴驱动。
BOOST pump, an electrically operated fuel pump for fuel supply from the airplane fuel tank to the fuel manifold.
增压泵，从飞机油箱向总油管提供燃油的电动泵。
Mode analysis system for oil fuel pump spouted by electricity is a multi-way input and output status analysis system.
电喷燃油泵模态分析系统是一套多路输入输出分析系统。
Combined with 3 typical fuel pump control circuits, this paper introduces their working principles and maintenance methods.
结合3种典型的燃油泵控制电路，分别介绍了燃油泵控制电路的工作原理和检修方法。
QUICK-ATTACH-DETACH, a clamp for attaching accessories (hydraulic pump, fuel pump, starter) to the engine accessory gearbox.
快速装卸，用以将附件(如液压泵，燃油泵，起动器等)接到发动机附件齿轮箱上的夹具。
Some cars have an electric fuel pump. This pump mounts in the fuel tank with the fuel pickup and the fuel-gauge-sending unit.
一些汽车采用电动汽油泵，汽油泵安装在油箱上，附带有油量传感器和燃油表油量传送装置。
In addition, the camshaft has an eccentric to operate the fuel pump and a gear to drive the ignition distributor and oil pump.
此外，凸轮轴还带动一个驱动燃料泵的偏心轮和一个带动分电器和油泵的齿轮。
A typical fuel-supply system consists of a fuel tank assembly, fuel lines, or fuel pump, and outlet filter. The fuel tank stores a supply of fuel.
典型的燃料供给系统由油箱总成、油管、燃油泵和汽油滤清器组成。油箱用于存储汽油。
Finally, another set of controller based on TMS320LF2407A DSP is also discussed and designed to satisfy the development tendency of aero fuel pump system.
最后，文中还探讨和设计了一套基于TMS320 LF 2407 ADSP为控制核心的燃油泵用无刷直流电动机控制驱动器设计方案。
Remember that even a trace of dirt in a carburetor or fuel pump can cause fuel-system and engine trouble. be very careful about dirt when repairing these units.
化油器或燃料泵中的小点污迹都可造成燃料系统和发动机的故障。在检修这些部件时，务必小心。
This model took the parameters of engine speed, fuel pump rack position, pedal, LPG(injection) time, cooling water temperature and torque as the input variables.
模型将转速、油泵齿条位置、油门开度、LPG喷气时间、冷却水温度、转矩作为输入变量。
Listen for any audible air leaks, unusual noises, fuel pump buzz (a noisy pump may not be an indication of poor operating condition), engine rattles or knocks. E.
听是否有空气泄漏声，油泵嗡嗡声(油泵有声音并不意味着工作不良)，发动机卡嗒卡嗒声或爆震声。
The fuel system consists of the fuel tank, fuel pump, fuel filter, carburetor, intake manifold, and fuel lines, or tubes, connecting the tank, pump, and carburetor.
燃料系统包括汽油箱、汽油泵、汽油滤清器、化油器、进气歧管以及连接油箱、油泵和化油器的油管。
Electric fuel pump is an important part of automobile fuel feed system, which absorbs fuel from fuel tank and provide it to the air crocks of engine by fuel injection.
电动燃油泵是汽车燃油供给系统的重要组成部分，其功用是将燃油从油箱内泵出并通过喷油器供给发动机各个气缸。
The fuel pump rig test and troubleshooting system can achieve its purpose of test and troubleshooting by monitoring the working performance and parameter of the fuel Pump.
该试验台通过对高压柴油泵的工况性能及参数的测试，达到对高压柴油泵进行校正和故障诊断的目的。
Using numerical simulation technology, we study a method for predicting the structural fatigue life of a fuel pump bracket(FPB) that contains rubber cushion for vibration reduction.
针对一类含橡胶减振垫燃油泵托架出现疲劳断裂的现象，研究利用数值仿真技术预测结构疲劳寿命的方法。
This paper mainly introduces two inspecting methods of fuel pump controlling current on BUICK NEW CENTURY car: one is inspecting with multimeter; the other is inspecting with scanner.
本文主要介绍了别克新世纪轿车燃油泵控制电路的工作原理和检测方法，一是用万用表检测，二是用扫描仪检测。
The physical model and mathematical model of fuel pump were created in the performance simulation mould. Factors affected performance and the simulation output are analyzed and discussed.
在性能仿真模块中建立了油泵产品的物理模型和数学模型，并对仿真结果及影响油泵产品性能的因素进行了分析。
This text researches the testing equipment with computer and metal pipe float sensor and SCM, so that it can replace the traditional PT fuel pump test-bed measuring the oil with the glass float.
介绍了用微机与金属管浮子传感器和单片机组成测定装置，代替用玻璃浮子量油的传统PT燃油泵试验台，解决了目前PT燃油泵试验台现存的量油系统误差大的问题。
In this paper, we analyze the shortcomings of hierarchical structure, and build product model with extended entity relationship (EER) approach. A product model of fuel pump is shown as an example.
该文分析了递阶结构表达方式的不足，利用扩展的实体关联(eer)表达方式建立了产品的数据模型，并以油泵产品为例建立了产品数据模型的展开结构。
By adjusting dynamic fuel pump rack position, closed loop of engine speed in suddenly changing of load was realized in this model. It could keep engine speed stability in different status of engine.
通过动态调整油泵齿条位置实现对柴油机突变负载下转速的闭环控制，从而保证在不同工况下转速的稳定性。
Electric Fuel Pump, Air-Flow Meter, Sensor, Switch.
电动燃油泵，空气流量计，传感器，开关。
Combination Switch, Electric Fuel Pump, Shock Absorber.
组合开关，油泵，减振器。
Combination Switch, Electric Fuel Pump, Shock Absorber.
组合开关，油泵，减振器。
应用推荐