The system inlet temperature is less than the lower warning threshold.
系统进气孔温度低于下限警告阈值。
The system inlet temperature is less than the lower critical threshold.
系统进气孔温度低于下限临界阈值。
The system inlet temperature is greater than the upper critical threshold.
系统进气孔温度高于上限临界阈值。
The effects of inlet temperature and inlet velocity were taken into account.
实验考虑了进气速度、进气温度对贫油熄火油气比的影响。
Inlet temperature distortion is one of the key factors effecting engine stability.
发动机进口温度畸变是影响发动机稳定性的关键因素之一。
Whereas, the heat transfer of turbulence liquid film flow is not sensitive to liquid film inlet temperature.
湍流时，热量传递对液膜进口温度的反应不如层流敏感。
The article analyses the best inlet temperature of false twister in polyester distortion technique by examples.
通过举例说明在聚酯变形工艺中最佳的假捻器入口温度。
The effects of the cooling water and freezing water inlet temperature are also predicted. The results are reasonable.
对地下水源热泵机组的性能随着冷却水、冷冻水入口水温的变化情况做了预测，结果合理。
The inlet temperature and internal temperature of exhaust catalyst for two stroke moped are tested under different vehicle driving speed.
在不同车速行驶工况下对二行程轻便摩托车用尾气催化剂的入口及中心温度进行了测量与分析。
The higher the normal load, the smaller the effect of the lubricating oil inlet temperature and rolling speed on the traction coefficient.
随着载荷增大，入口油温和滚动速度对拖动系数的影响减小；
The measures to solve these problems in heating transport with PPD and lowering the mini - mum inlet temperature for Daqing Oil are proposed.
提出了加降凝剂进行热处理输送、适当降低规程中的大庆原油最低进站温度等改进措施。
An effective method for maintaining the vacuum in condenser is to change the flow rate of circulating water according to its different inlet temperature.
在不同循环水进口温度条件下，合理改变循环水流量是维持凝汽器真空的有效办法。
Cooling towers' influence on the inlet temperature of circulating water was also considered to determine optimum running mode of circulating water pumps.
同时考虑闭式循环水系统中冷却塔对循环水入口温度的影响，确定出循环水泵最优运行方式。
This paper discusses the effect of compressor inlet temperature on its performance, thereby puts forward some measures to keep the inlet temperature constant.
本文分析了压气机性能试验中压气机进口温度变化对性能的影响，提出了保持进口恒温的一些措施。
With the increase of the turbine inlet temperature of high performance aero-engine day by day, the turbine coating blade coating technology has been widely used.
随着高性能航空发动机涡轮进口温度日益提高，涂层技术在涡轮叶片上得以广泛应用。
Higher gas inlet temperature, lower steam pressure or pinch point temperature difference lead to lower exhaust gas temperature, larger evaporation and higher efficiency;
提高进口烟气温度、降低蒸汽压力或减小节点温差，均可显著降低设计出口烟气温度，从而增大蒸发量，提高热效率；
Table 1 contains the recommended temperature that the heatsink base test point or the air inlet temperature should remain below during the thermal evaluation of a system.
表1含有进行系统热量测量时散热器基座测试点或空气入口温度应该低于的推荐温度值。
Based on the heat exchange theory between air and rock, the feasibility of decreasing air inlet temperature by temperature regulating action of shallow ground is discussed.
根据空气与岩体的热交换原理，探讨了利用浅部地层调温作用来降低深井入风温度的可行性。
Based on the research on the heat exchange regularity between air and rock in air-inlet temperature-regulating system, a new method for improving mine ventilation is presented.
通过研究矿井入风调温系统的空气与岩体热交换规律，提出了改善矿井通风的一种新方法。
A first order lagging equation is used to acount for dynamic effects. This model can simulate the compressor response to inlet temperature transients and find the critical stage.
该模型可以模拟进口温度（或压力）瞬变下压气机的逐级响应，寻找首先失速的关键级。
The factors such as superheat, inlet temperature which influence the flash evaporation are studied base on the experiment. The mechanism of the flash evaporation was also analysed.
本文对影响闪蒸过程的因素：过热度、进口温度等进行了实验研究，并对闪蒸机理进行了分析。
The calculation example shows that if the inlet temperature of fluid is low and the flux is small, the amendatory value and coefficient are great when the other conditions are fixed.
计算实例表明，其他条件一定时，流体进口温度越低，流量越小，则修正值和修正系数越大。
The world vertical upward flow round critical heat flux experimental database is analyzed based on the slice method, similarity measure, heat balance and inlet temperature verification.
采用切片法、相似度概念和热平衡以及进口温度检验法，对收集到的圆管垂直向上流动临界热流密度实验数据库进行了分析。
The performance of a gas turbine is related to environmental temperatures and its output decreases with the increase of gas inlet temperature, which can be solved by cooling the inlet gas.
燃气轮机的性能与环境温度有关，其出力随燃气进气温度升高而降低的问题可通过冷却燃气进气来解决。
Reducing the inlet temperature of cooling water and increasing its mass flow are favorable to increase refrigerant performance coefficient, and can decrease optimal pressure at high pressure side.
降低冷却水进口温度和提高其质量流量不仅有利于提高制冷性能系数，而且能降低最佳高压侧压力。
This paper introduces the parameter estimation research for the turbine inlet temperature and compressor exit pressure by using the engine variables measured under the different flight conditions.
本文研究利用不同飞行状态下测量的发动机变量估计涡轮进口温度和压气机出口压力。
The performance of gas turbine has relation with the environmental temperature and its output is reduced with increase of gas inlet temperature, which can be solved by means of cooling the inlet gas.
燃气轮机的性能与环境温度有关，其出力随燃气进气温度升高而降低的问题可通过冷却燃气进气来解决。
Temperature distortion on inlet flow of engine is more important than pressure distortion for engine stability.
进口流场的温度畸变对军用飞机发动机稳定性具有比压力畸变更大的影响。
Temperature distortion on inlet flow of engine is more important than pressure distortion for engine stability.
进口流场的温度畸变对军用飞机发动机稳定性具有比压力畸变更大的影响。
应用推荐