The over Voltage protection should be tested at other load rating.
过压保护测试是在其它定额负载时测试。
The Short Circuit protection should be tested at other load rating.
短路保护测试是在其它额定负载时测试。
Note:The over current protection should be tested at other load rating.
短路保护测试是在其它额定负载时测试。
The specialized bearings have the performance of large load rating and compactness.
这些专用轴承具有载荷大、结构紧凑等特点。
Features: Strong nylon body, Soft urethane treads, High load rating, Quiet mobiliy.
特点：聚氨酯与尼龙材料，坚固耐磨，静音效果好。
To radial or axial basic dynamic load rating of basic dynamic load rating based on the predicted life...
以径向基本额定动负荷或轴向基本额定动负荷为基础的寿命的预测值。
In other words, the Basic Dynamic Load Rating provides a basis of Life Calculations based on the size and type of ball screws.
换句话说，基本额定动载荷提供了一个基于丝杠类型和尺寸来计算寿命的基础。
From analysis of combined needle roller bearing, the estimating formula of basic dynamic load rating for above bearing is derived.
从滚针组合轴承结构分析着手，推导出滚针组合轴承的基本额定动负荷估算公式。
To obtain a fixed set with the basic rating life of the corresponding radial axial dynamic load, or the basic dynamic load rating for equiva…
为了得到与给定额定寿命相应的基本额定径向动负荷或基本额定轴向动负荷，适用于当量动负荷的修正系数。
As a result, the bearings show a significant increase in the basic dynamic load rating and, under the same operating conditions, in the basic rating life.
因此，轴承表明，在基本额定动载荷下，大幅度增加相同的工作条件，并在生活的基本评价。
Hertz contact theory and dynamic load rating theory are used to study flexible bearing life assuming that the life is coincident with Weibull distribution.
假设柔性轴承的寿命符合韦布尔分布，应用赫兹弹性接触理论和滚动轴承额定动负荷理论进行柔性轴承的寿命分析。
The design Engineer shall determine whether the design justification of the standard component support is to be by "design by Analysis" or by "Load Rating".
设计工程师负责明确采用以下哪种数据作为标准管架的设计依据，即，分析设计，或额定载荷。
On the single row angular contact bearings, radial load rating of bearing rings relative to each other purely radial displacement of the load of the radial component.
对单列角接触轴承，径向额定负荷为引起轴承套圈彼此相对纯径向位移的负荷的径向分量。
To obtain a fixed set with the basic rating life of the corresponding radial axial dynamic load, or the basic dynamic load rating for equivalent dynamic load correction factor.
为了得到与给定额定寿命相应的基本额定径向动负荷或基本额定轴向动负荷，适用于当量动负荷的修正系数。
With greater axial and radial load rating capacity, good replaceability of components. The shaft can be adjusted through external hexogan then to adjust the axial part dimension.
轴承径向和轴向的承载能力都比较大，各配件可替换性强。轴承通过调节偏心外六角来调整芯轴位置进而达到调整侧滚轮轴向尺寸的目的。
The parabolic gear is characterized by a new-type tooth profile, which may ensure very great load rating and fairly good unyielding, anti-sticking and wear - resisting properties.
抛物线齿轮是我们新近研究出来的一种新齿廊，它具有很高的抗接触、抗弯曲、抗胶合与抗磨损的能力。
For example, the segment loading indicator may be operative to provide an indication of a loading of the load segment output with respect to load rating of the load segment output.
例如，分段负载指示器可作用以提供对负载分段输出的相对于负载分段输出的额定负载的负载的指示。
Standard &Poor’s still has a negative rating because revenue and cash flow have been lower than expected, and the large debt load looms.
标准普尔仍然对Sabre的股票给出了负面的评级，因为该公司的总收入和现金流都低于预期，而且其沉重的债务负担已经日益严重。
Since there are weld defects in welds, using traditional strength theory based on no defect and no crack to design, crane's security in rating load can't be insured.
由于在焊缝部位存在焊接缺陷，采用传统的建立在构件无缺陷、无裂纹基础上的强度理论进行设计计算时，往往不能确保起重机在额定载荷下使用的安全性。
Depending upon the utilization rating of each node, load was transferred between nodes and the cluster was balanced. The module worked like this.
根据每个节点的利用额，将负载在节点之间转移以平衡集群。
Load factor the load factor is the ratio of the average load to the generator set power rating.
负荷系数负荷系数指的是机组的平均负荷与额定功率之间的比率。
Constant radial load (constant axial load center), in the load, the bearing can withstand 1 million transfer theory, the basic rating life.
恒定的径向负荷(恒定的中心轴向负荷)，在该负荷下，滚动轴承理论上可以经受1百万转的基本额定寿命。
NHTSA proposes to require a more stringent endurance test and to add a new high speed test for several heavy load range tires for vehicles with gross vehicle weight rating of more than 10,000 pounds.
国家公路交通安全管理局提出对一些车辆毛重超过10，000镑的载重胎要有一个更严格的耐久性试验和一个新高速测试。
Assuming a 12v system in which all the components are properly specified, these circuits can survive load dumps, thanks to the 76v absolute maximum rating for the IC's input-power terminal, VIN.
假定一个12v系统中的所有部件都完全确定，由于集成电路输入端电压VIN最高可以达到76v，因此这两个电路有负载抑制。
When evaluating a UPS, consider that most vendors give the peak efficiency rating it can deliver at full load.
在评估ups时，考虑大多数厂商给出的UPS在满载情况可提供的峰值额定效率。
When evaluating a UPS, consider that most vendors give the peak efficiency rating it can deliver at full load.
在评估ups时，考虑大多数厂商给出的UPS在满载情况可提供的峰值额定效率。
应用推荐