Construction drawing of "Main transformer installation".
《主变压器安装》施工图纸。
Main measures for electricity saving of buildings in terms of equipment selection, lines control modes, reactive compensation mode and transformer selection etc. were introduced.
从设备的选型、线路的控制方式、无功补偿方式、变压器的选择等方面介绍了建筑电气节电的主要措施。
The article introduces the critical technical parameters, structure and design features of this main transformer and smoothing reactor.
本文介绍了这种主变压器和平波电抗器的主要技术参数、结构和设计特点。
By integrating the main transformer and output inductor with magnetics integration technique, an ACFC with high efficiency and high power density was obtained.
对变换器中的主变压器和输出电感进行集成,得到高效率、高功率密度的有源箝位正激变换器。
This paper introduces the application of The 'SP' synthesization foam spray fire extinguishing device for a main transformer in the substation.
介绍了“SP”合成型泡沫喷淋灭火装置及其在变电所主变压器消防中的应用。
The application of Balancing Transformers as a main transformer in tractivesubstation to supply power to electrified railway is nowadays an advanced technique of power supply in the world.
应用平衡变压器作为牵引变电所中的主变压器向电气化铁道供电,是当今世界上先进的供电技术。
The article introduces the control and management system of a small water power station. Th is station uses distributed control with four groups of generator and one group of main transformer.
本文所介绍的控制管理系统的控制对象是一个小型水电站,该电站由四台水轮发电机组和一台主变压器组成,全站采用分布式控制。
The omnibus bar of each set is connected with main transformer through its omnibus bar cave.
每台机组母线通过各自的母线洞与主变压器连接。
In engineering design of integrated automation of substation, the display of tap changing switch position for main transformer is to add position transducer in the conventional scheme.
在变电站综合自动化工程设计中,对于主变压器分接开关位置的显示,常规方案是需加装档位变送器。
The uses, operating principle and main requirements of the current transformer for differential relay with high impedance were described.
叙述了高阻差动继电器用电流互感器的用途、工作原理和主要要求。
Company main products: Voltage stabilizer, high low pressure transformer, reactance implement.
公司主要产品:稳压器、高低压变压器、电抗器。
Prefer those with knowledge about the main components such as transformer, converter, gear box, motor, traction system, train control system etc.
熟悉主要部件如变压器,电机,变流器,齿轮箱,牵引系统及列车控制系统等。
In this paper, main influential factors on dielectric surface discharge in transformer oil are discussed.
介绍了影响固体绝缘材料在变压器油中沿面放电特性的主要因素。
Voltage sags due to line faults, transformer energizing and induction motor starting are main interference sources.
输配电线路故障、变压器投运、感应电动机启动是引起电压凹陷的主要原因。
The leakage inductance of power transformer is one ofthe main interference sources in the circuit.
作为开关电源核心部件的功率变压器的漏感是高频开关电源的主要干扰源之一。
Synopsis: The main contract of this design is the excogitation for protection of 110/6.3KV transformer.
本设计的主要内容是110/6.3KV降压变压器的继电保护设计。
Winding distortion may happen during transformer operation. Frequency response and short impedance are the main methods to test winding distortion.
变压器在运行中可能发生绕组变形,测试绕组变形的方法主要有频响法和短路阻抗法。
The basic working principle, hardware structure and main technical features of a micro computer based control system for transformer economic operation is presented in this paper.
介绍了一种微机双绕组变压器负荷经济运行控制系统的基本工作原理、硬件结构框图和主要技术特点。
It is well known that transformer is one of the main equipments in the power system.
变压器是电力系统中重要设备之一,承担着传输和分配电能的重要任务。
The onsite electric power system consists of the main generator, the unit station transformers, the common station service transformer, the diesel generators and the electric distribution system.
厂内配电系统由主发电机,主变压器,厂用变压器,柴油发电机和相关的配电设备组成。
The cause of the DC bias of the main transformer in the full bridge inverter has been analyzed.
分析了全桥逆变器功率变压器产生直流偏磁的机理;
Electricity is then carried from the transformer to a main entry point for the building. This entry point is called the service point, or the distribution point.
然后把电流从变压器输入建筑物的总输入点。这个输入点叫做供电端点或配电端点。
Impedance transformer is one kind of main equipment of track circuit in electrification district.
扼流变压器是电化区段构成轨道电路的主要设备之一。
It is the existent of magnetizing inrush current in transformer that differs transformer differential protection from differential protection of other main equipments and transmission lines.
由于变压器励磁涌流的存在,使得变压器差动保护有别于其他主设备及线路的差动保护。
The defect of transformer inner insulation is the main element causing the part discharge of the transformer.
变压器内部绝缘的缺陷是引起变压器局部放电的主要原因。
Characteristics and generation mechanism of noise from transformer are explained in this paper. The main measures to attenuate transformer noise is described.
本文简述了变压器噪声的特点及产生机理,并介绍了降低变压器噪声的主要措施。
The revision history of IEC 60296 transformer oil standard, the main revised contents of IEC 60296-2003 and the developing tendency of transformer oil at home and abroad are introduced.
介绍了IEC 60296变压器油标准的修订历程,IEC 60296- 2003变压器油的主要修改内容及国内外变压器油的发展趋势。
In the thesis we only count the failure that leads the transformer to quit operation, regarding the transformer as Non-repairable system whose main index is failure rate.
本文只统计造成变压器必须退出运行的故障,研究这类失效应把变压器看成是不可修复系统,其最主要的指标是失效率。
The thesis only counts the failure that leads the transformer to quit operation, regarding the transformer as Non-repairable system whose main index is failure rate.
本文只统计造成变压器必须退出运行的故障,研究这类失效应把变压器看成是不可修复系统,其最主要的指标是失效率。
This paper collects and analyzes the harmonic signals of the CO2 welding machines main transformer, by which researches the effect of welding power source on the main.
对晶闸管CO2焊接电源焊接过程主变压器一次侧产生的谐波信号进行采集分析,以此研究焊接电源对电网的影响。
应用推荐