In this paper, an adaptive fuzzy sliding mode control scheme is proposed for nonlinear vibration systems.
本文针对非线性振动系统提出了一种模糊自适应滑模控制方案。
Therefore, reducing the chattering is the key to improve the accuracy of position tracking in sliding mode control system.
因此，有效削弱滑模控制系统的抖振是提升系统跟踪精度的关键。
This paper presents a novel high-performance adaptive sliding mode control scheme for high precision mechanical servo systems to asymptotically track a specified reference model.
针对高精度机械伺服系统，提出一种高性能的新型自适应滑模控制方法，使闭环系统渐近跟踪给定的参考模型。
Sliding mode control is insensitive to parameters, and has the advantages of good robustness to external disturbance and fast dynamic response etc. So, it has been applied in motor control.
由于对参数变化不敏感，对外部扰动的鲁棒性强，且动态响应快，滑模控制已经在电机控制中得到了很好的应用。
The controller is UC3846 current mode control chip.
控制器为UC 3846电流型控制芯片。
Sliding mode control of singular linear systems is studied.
研究广义线性系统的滑动模控制问题。
It is suitable for both current - and voltage-mode control methods.
它同时适用于电流和电压模式控制方法。
A new method of reducing chattering in sliding mode control is proposed.
提出一种抑制抖振的新方法。
A strategy for integral separation PID sliding mode control is proposed.
提出一种积分分离pid滑模控制策略。
Sliding mode control method for the design of roll autopilot was proposed.
提出了一种滑模变结构滚转驾驶仪的设计方法。
A fuzzy neural network integral sliding mode control approach was proposed.
提出了一种基于模糊神经网络的积分滑模控制算法。
Under the forecasted traffic conditions, a multi-mode control is also proposed.
提出根据预测的路网状况，采用多模控制方式。
DC PWM servo system is controlled by this kind of discrete sliding mode control strategy.
针对一个具体的直流pwm伺服系统，采用这种离散滑模控制策略进行控制。
An adaptive fuzzy sliding mode control scheme was proposed for a class of complex systems.
对一类复杂过程对象给出了模糊控制系统的设计方法。
A kind of new sliding mode control method for current type power amplifier is put forward.
提出了一种为电流型功率放大器所用的新的滑模控制方法。
The sliding mode control method for chaotic systems based on pole-replacement is presented.
提出了基于极点配置的混沌滑动模态控制方法。
An automatic seam tracking system of welding robot based on double-mode control is presented.
该文提出了一种基于双模控制的焊接机器人焊缝自动跟踪系统。
An adaptive sliding mode control technique is presented for the control of high speed feed drives.
自适应滑模控制方法可适应于控制高速进给传动。
In chapter four, indirect fuzzy sliding mode control for a class of nonlinear systems is discussed.
第四章：研究了一类非线性系统的间接自适应模糊滑模控制方法。
A dynamical sliding mode control approach is proposed for the output tracking of wheeled mobile robots.
针对轮式移动机器人的输出跟踪问题，提出一种动态滑模控制方法。
The principle and implementation of the average current mode control was deeply analyzed in this thesis.
本文中对于平均电流模式控制的工作原理和具体实现进行了深入分析。
A nonlinear sliding mode control method is presented for single inverted pendulum position tracking control.
针对倒立摆的位移控制，提出一种非线性滑模变结构控制方法。
A cascaded slide mode control scheme is designed for permanent magnetic synchronous machine ac servo system.
针对永磁同步电机交流伺服系统，提出了串级滑模控制方案。
The sliding mode control is a robust control design method, but chatterings sometimes occur in applications.
变结构控制具有良好的鲁棒性，但是在实际应用中往往会引发抖振。
Then the fuzzy sliding mode control strategy is proposed to improve the power Angle stability of the system.
然后基于该线性化数学模型再设计以改善系统功角稳定为目标的模糊滑模变结构控制器。
The dynamical sliding mode control was applied on the output control of wheeled mobile robots made for Robocon.
针对轮式移动机器人的输出控制问题，提出了一种利用动态滑模控制解决输出控制的方法。
Disconnect the vacuum harness connector from the back of the heater-A/C mode control switch on the control panel.
从控制仪表板上的空调暖气模式控制开关上断开真空线束接头。
An algorithm for fuzzy sliding mode control was proposed for AC speed drive with a slip frequency vector control.
针对滑差频率矢量控制交流调速系统，提出并设计一种模糊滑模控制算法对速度环进行控制。
Phased array radar detection range depends on radar technical parameters and radar operation mode control parameters.
相控阵雷达作用距离决定于雷达技术参数与雷达工作方式的控制参数。
Phased array radar detection range depends on radar technical parameters and radar operation mode control parameters.
相控阵雷达作用距离决定于雷达技术参数与雷达工作方式的控制参数。
应用推荐