Sparks of molten steel dash in all directions.
钢花乱迸。
The Calcium Oxide is used to mix oxygen with the molten steel.
这些生石灰是用来将氧混合在熔化的钢水中。
The cleanliness of molten steel is a key factor for thin slab casting.
洁净钢的生产是薄板坯连铸的关键问题。
The hydrogen in molten steel is also determined with satisfactory results.
另外还测量了钢液中的氢含量，得出满意的结果。
Ze-Gen, based in Massachusetts, gasifies waste by injecting it into molten steel.
马萨诸塞州的Ze-Gen公司把垃圾倾入高温的钢水中使垃圾气化。
Molten steel leakage by binding is often related to the properties of mould powder.
粘结漏钢往往与所使用的结晶器保护渣性能有关。
The molten steel temperature is one of important parameters of continuous casting process.
连铸钢水温度是连铸生产工艺的重要参数之一。
A full set of processes of rapid solidification of molten steel into a uniform particle emissions.
一全套过程有对快速凝固后的钢水成均匀的颗粒排放。
Molten steel is poured into a refinery furnace. Many of these machines were brought in from France.
融化的钢水被倒进了精炼炉。这些装置中有许多来自法国。
Solid solubility model of vanadium element in molten steel is established after theoretical analysis.
通过理论分析建立了钒元素在马氏体不锈钢中的固溶度模型。
The tundish metallurgy played an important role in purifying molten steel and stabilizing CC operation.
连铸中间包在最后净化钢水和稳定连铸的操作中起重要作用。
The oxygen activity of converter molten steel directly influences the yield of alloy and quality of steel.
转炉钢水中的氧含量直接影响合金收得率和钢水的质量。
During the measurement, the immersion period of the sublance in the molten steel should not exceed 8 seconds.
测量时要按要求控制好探头在钢水中停留的时间，一般不大于8秒。
This paper analyzes the influence of calcium treatment on the castability of continuous casting molten steel.
分析讨论了钙处理对连铸钢浇注性能的影响。
This paper introduces water model experiments of molten steel flow field in tundish and its practical application.
介绍根据安钢三炼钢条件进行的钢水中间包流场水力模型实验及其应用。
Due to good slagging, stable melting and less molten steel spilling, thus enhance molten steel yield rate about 1%.
由于化渣好、冶炼平稳、减少钢水喷溅，从而可以提高钢液收得率1%左右。
Formation mechanism of sticking breakout and basic principle of molten steel leakage prediction system are explained.
阐述了粘结漏钢的形成机理和漏钢预报系统的基本原理。
Replacing an original analog instrument, the new system responds readily and accurately the O-content in molten steel.
该系统代替原来的模拟仪表，能使钢水中的氧含量快速准确地反映出来。
The melting characteristic of premelted refining slag and deep desulfurization of molten steel are experimentally studied.
在实验室条件下进行了预熔精炼渣熔化特性测定及钢水深脱硫实验研究。
It becomes a very urgent problem to establish a reasonable temperature system and accurately control molten steel temperature.
如何建立合理的温度制度、精确控制钢液温度，是一个迫切需要解决的课题。
The result indicates that the large grain brittle inclusion in the molten steel is the key factor can lead to brittle fracture.
通过对高碳帘线钢线材断口试样的检验分析，认为钢中大颗粒脆性夹杂物是导致脆断的重要原因。
Numerical results also showed that convective transfer of molten steel is the key factor to influence the inclusion distribution.
数值结果还表明钢液的对流输运是影响夹杂物分布的重要因素。
Some typical technology and their current advancement associated with the drive and control of molten steel flow are illustrated.
给出了钢精炼和连铸过程中若干典型的钢液流动驱动与控制工艺过程及相关现象研究进展。
The taphole of UHP-EAF should stand severe molten steel corrosion, slag erosion, oxidation and temperature change during operation.
超高功率电弧炉出钢口在使用过程中要经受钢液的冲刷、渣液的侵蚀、氧化和温度的剧烈变化。
The processing technique of centrifugal grainy equipment and water quenching method for molten steel slag was studied in this paper.
本论文以液态钢渣为研究对象，研究液态钢渣的离心粒化设备水淬法处理技术。
The major equipments are the ladle and the mould. a ladle is a container to hold the molten steel tapped from the steel making furnace.
主要的铸锭设备有盛钢桶和钢锭模。盛钢桶是用来盛装从炼钢炉放出的钢液的容器。
During smelting steel and iron, the temperature of molten steel and liquid iron is one of the most important parameters in steel trade.
目前，在炼钢、炼铁的行业中，钢水或铁液的温度是决定炼钢或炼铁的重要参数之一。
By analyse the veracity and representative of the molten steel sample, the methods improving quality stability of billet were proposed.
分析了连铸中间罐试样的代表性和准确性，提出控制质量稳定性的建议。
Using flow field software PHOENICS and water model, this paper describes the flow field of molten steel in continuous casting billet mold.
应用流场计算软件PHOENICS及水力模型，模拟了方坯连铸结晶器内钢液的流场和流动分布。
Using flow field software PHOENICS and water model, this paper describes the flow field of molten steel in continuous casting billet mold.
应用流场计算软件PHOENICS及水力模型，模拟了方坯连铸结晶器内钢液的流场和流动分布。
应用推荐