Energy variation principle is a good method to solve the shear lag effect.
能量变分法是求解剪力滞问题的一个有效方法。
复合剪切面破坏。
A fluid cannot withstand a shear.
流体不能承受切应力。
剪切性能好。
Accurate shear is an important unloading method.
精密剪切是重要的下料方法。
There will be no shear on this surface.
在该表面上没有剪切作用的存在。
And osteoblast is most sensitive to shear stress.
其中成骨细胞对剪切应力最敏感。
The frame shear-wall system is adopted in design.
工程结构采用了框架-剪力墙体系。
Also, consider throughput rate and shear sensitivity.
此外，还要考虑产率和剪切敏感性。
The concept of constant shear strain point was proposed.
提出了常剪切应变点的概念。
The behaviour is general turbulence when shear is small.
切变较小时为普通湍流形态；
The pumps must be of the low shear Archimedes screw type.
泵必须是低剪切力的阿基米德螺旋式泵。
Every spring they shear off the sheep's wool and sell it.
每年春天他们都要剪下羊毛去卖。
At last, the calculation of shear failure Angle is derived.
最后对土体剪切破裂角的计算进行了推导。
It can transfer shear to the base from the column baseplate.
能满足钢结构柱脚向基础传递较大水平力的要求。
The Rayleigh wave speed is very close to the shear wave speed.
瑞利波波速与横波波速极为接近。
Extra high shear resistance and adhesion, can bear great force.
极高的抗剪切强度和粘接强度，可承受很大的外力。
The shear flow of two melts approximately obeyed the power law.
两试样熔体的剪切流动大体上服从幂律。
Tie beam is an important element in frame-shear wall structure.
连梁在框架-剪力墙结构中，也是很重要的一个构件。
Therefore, Kanggur gold deposit is not that of shear zone type.
因此，康古尔金矿不能被称为剪切带型金矿。
The shear cliff at Yosemite is an example of such rock breakage.
优胜美地的断崖就是这样一种岩石碎裂的例子。
You might be more familiar with a different shear-thinning fluid.
你可能会更熟悉不同的剪切稀化流体。
The research emphasis of this paper is on channel shear connectors.
本文研究的重点是槽钢剪力连接件。
Vertical wind shear is only one of the many factors that cause CAT.
垂直风切变仅仅是产生晴空颠簸的众多因素之一。
It is shown that the bumps can supply sufficient shear strength for use.
由实验结果可知钎料凸台可以提供足够的剪切强度。
When the shear rate is relatively high, this influence obviously weakens.
当剪切速率在比较高的范围内，这种影响明显减弱。
Ductile shear zone type gold deposit is an important type of gold deposits.
韧性剪切带型金矿是一种非常重要的金矿床类型。
Now the achievements of study in bending theory keep ahead of shear theory.
目前碳纤维抗弯加固理论的研究已远远领先于碳纤维抗剪加固。
The results show that there is a near uniform stress state in the shear zone.
结果表明，双剪切试样受剪区域的应力状态基本为均匀分布且随蠕变时间变化很小。
The results show that there is a near uniform stress state in the shear zone.
结果表明，双剪切试样受剪区域的应力状态基本为均匀分布且随蠕变时间变化很小。
应用推荐