The article introduces a new kind of method of reactive power compensation.
介绍了一种新型的无功补偿方法。
The reactive power compensation is an important project in the power system.
无功功率补偿是电力系统中的一项重要工程。
The different modes of reactive power compensation were discussed correspondingly.
文中针对不同的无功补偿方式进行了相应的探讨。
The article analyzes reactive power compensation and harmonic restraining in power electronic system.
对电力电子系统的无功功率与谐波抑制方法进行分析。
Reactive power compensation is an effective measure to reduce power system loss and improve its efficiency.
无功补偿是降低电网损耗、提高输配电效率的有效手段。
This paper proposes a new approach to reactive power compensation according to the principle of power balancer.
本文利用功率平衡器的原理提出了一种新的无功补偿方法。
The problem of applying bifurcation theory in influence of reactive power compensation upon voltage stability etc.
分析研究了分叉理论应用于无功补偿对电压稳定性影响等问题。
It is very important to have reasonable reactive power compensation for power transmission and distribution system.
合理的无功功率补偿对于对输配电系统非常重要。
In a word, reactive power compensation and harmonic current restrain have become one of the most important problems.
总之，无功功率的补偿和谐波电流的抑制已经成为港口电气系统设计中最重要的问题之一。
It became necessary means that reactive power compensation devices were installed in proper position of power network.
在电网中的适当位置装设无功补偿装置成为满足电网无功需求的必要手段。
It became necessary means that reactive power compensation devices were installed in proper position of electric network.
在电网中的适当位置装设无功补偿装置成为满足电网无功需求的必要手段。
To solve problem of harmonics and reactive power compensation, researchers have proposed many control strategies in recent years.
为了解决电力电子装置的谐波和无功功率污染问题，近些年来国内外学者提出了很多控制方案。
The effectiveness of the sensitivity information is verified by comparing the amount of reactive power compensation at each location.
那个灵敏性资料的效力，由比较无功补偿在每个位置的数额来验证。
In most substations, detecting the voltage and current and shunt capacitors is the method used for local reactive power compensation.
变电站无功补偿控制一般方法是通过检测母线上电压电流值，控制投切电容器组实现电网无功补偿。
In order to do well the grid reactive power compensation, reliable operation of reactive power compensation capacitor must be assured.
为了做好电网的无功补偿，必须保证补偿电容器的安全可靠运行。
For example, power flow, reactive power compensation, voltage stability, frequency stability, and analysis of long terms dynamic process.
比如，潮流计算、无功补偿规划、电压稳定、频率稳定及长期动态过程的分析等。
According to the requirement of reactive power compensation, the paper presents a software and hardware design method of the STATCOM based on DSP.
根据配电网无功功率补偿的工程要求，提出了一种基于DSP的静止同步补偿器(STATCOM)软硬件设计方法。
The controller can achieve the functions such as survey the power grid, reactive power compensation, harmonic control, remote communication and so on.
该控制器集电网监测与无功补偿于一体，同时完成谐波治理和通信功能。
Based on these relations, a general control strategy for harmonic elimination, reactive power compensation and asymmetrical load balance can be devised.
在此基础上，就可以建立满足各种条件下系统的谐波抑制、无功补偿及不对称负载平衡衡量化的统一控制策略。
One of the traditional methods of reactive power compensation is to use compensating capacitors, therefore, compensation device is widely used in power network.
设置补偿电容器是补偿电网中无功功率的传统方法之一，无功补偿装置在电网中应用相当普遍。
In chapter two, the theory and superiority of reactive power compensation is analyzed and a practical mathematic model of optimal capacitor placement is set up.
第二章分析了无功补偿的原理及优势，并建立了较符合实际的配电网并联电容器优化配置模型。
This paper presents a methodology to determine the adequate reactive power compensation for restoring power flow solvability in the unsolvable severe contingencies.
本文提出了一种方法，以确定适当的无功功率赔偿来恢复在无法解决的严重意外中的潮流解。
The specific assignment of the task is to provide control system for the equipment about reactive power compensation, to ensure the system run steadily and reliably.
本课题的具体任务是为无功补偿装置提供控制系统，以保障系统稳定、可靠的运行。
Different combination pattern of reactive power compensation capacitors with series reactors in substations has different influence on harmonics in the power system.
变电所无功补偿电容器与串联电抗器的不同组合对系统谐波的影响不同。
In order to overcome the disadvantage of the single phase passing zero control in the reactive power compensation device, fuzzy control is put forward in this paper.
针对目前无功补偿装置中采用的单相过零投切方法存在的缺点，本文提出采用模糊控制的方法。
The method of optimal reactive power compensation is analysed, a applicable approach of optimal reactive power compensation is presented in the regional power network.
通过对无功补偿优化配置方法的分析，提出了适合地区电网无功补偿优化配置的方法。
This paper presents a design method of reactive power compensation and harmonics restraining device and a method for calculating the parameter of all parts of this device.
提出了一种无源无功补偿与谐波抑制装置的设计方法以及装置中各部分的参数计算方法。
It is thoroughly considered in this new method that harmonic attenuation, reactive power compensation, mistuning, background harmonic and resonance with power line impedance.
该方法较全面地考虑了谐波治理、无功补偿、背景谐波、失谐、与电网阻抗的串并联谐振等问题。
The configuration program of incoming loop, bus coupler circuit, feeder circuit, motor circuit, reactive power compensation and the control power in switchgear was described.
阐述了开关柜中受电回路、母联回路、馈电回路、电动机回路、无功补偿和控制电源的配置方案。
The configuration program of incoming loop, bus coupler circuit, feeder circuit, motor circuit, reactive power compensation and the control power in switchgear was described.
阐述了开关柜中受电回路、母联回路、馈电回路、电动机回路、无功补偿和控制电源的配置方案。
应用推荐