The initial adhesion and drying velocity of the modified starch are compared with those of the usual starch adhesive.
讨论了变性淀粉粘合剂的初粘力，干燥速度等并与普通淀粉粘合剂作了比较。
The electronic moisture analyzer and the constant temperature and humidity equipments were used to study the influences of humidity to alfalfa drying velocity.
采用红外水分分析仪和恒温恒湿箱研究了湿度对紫花苜蓿干燥速率的影响。
The influences of the velocity and temperature of hot air and drying time on the drying effect were investigated.
考察了气流速度、温度以及干燥时间对物料干燥效果的影响，并与烘箱干燥试验数据进行对比。
The effects of temperature, velocity and time of heating on the rate of drying pelleted corn seeds were tested by means of the drying tester.
利用丸粒化玉米种子干燥试验装置，研究了风温、风速、加热时间对丸粒化玉米种子干燥速率的影响。
We have adopted the method to place a hollow rigidity axle (with hole and ridge) in the bamboo curtain reel to proceed bound drying, which can improve drying velocity and drying quality effectively.
采用竹帘卷内放置有孔棱的空心刚性轴进行束缚干燥，可以有效提高干燥速度和干燥质量；
When the length of alfalfa stems is less than 100 millimeter, the shorter alfalfa stems are, the faster drying velocity will be.
当苜蓿茎的长度小于100毫米时，越短的茎的干燥速度越快。
Lack of homogeneity of the air velocity in the tunnel dryer often seems to be the main factor that leads to poor drying efficiency and non-homogeneity of the products.
隧道式干燥机隧道内部风速和温度的分布不均匀是导致干燥效率低、干燥不均匀的主要原因。
The main factors which had influence on drying rate were found: the operating air velocity, the speed of rotating drum, the temperature of air flow, the shapes and characteristics of materials.
找出影响干燥速率的因素有：操作气速，转鼓转速，热风温度，物料形状，物料特性等。
The air velocity of the improved drier is homogeneous and the waste gas and heat energy can be recycled reasonably, and the drying can be completed once.
改进后的干燥机，热空气流动均匀，废气热能合理回收利用，能一次完成干燥。
The results show that when the velocity of cooling air and the width of inlet-cirque are changed, the effects on wall cooling and high temperature region of drying-tower must be considered.
分析了冷却风速度大小、进口圆环宽度对干燥塔内干燥介质温度场的影响。 模拟结果表明：在确定冷却风速度大小和进口圆环宽度时，应考虑它们对塔壁的冷却效果及对干燥塔内高温区域的影响。
The drying efficiency was higher on the conditions of higher temperature, higher velocity and longer time.
结果表明：风温越高，风速越大，加热时间越长，干燥速度越快。
Main factors which made influence on the efficiency of drying process, such as sorbent, superficial linear velocity, aspect ratio, regeneration method and condition, were analyzed and discussed.
对影响该工艺的主要因素，如吸附剂、空塔线速度、高径比、再生方法和条件等进行了分析和讨论。
The results show that when the velocity of cooling air and the width of inlet-cirque are changed, the effects on wall cooling and high temperature region of drying-tower must be considered.
分析了冷却风速度大小、进口圆环宽度对干燥塔内干燥介质温度场的影响。模拟结果表明：在确定冷却风速度大小和进口圆环宽度时，应考虑它们对塔壁的冷却效果及对干燥塔内高温区域的影响。
The results show that when the velocity of cooling air and the width of inlet-cirque are changed, the effects on wall cooling and high temperature region of drying-tower must be considered.
分析了冷却风速度大小、进口圆环宽度对干燥塔内干燥介质温度场的影响。模拟结果表明：在确定冷却风速度大小和进口圆环宽度时，应考虑它们对塔壁的冷却效果及对干燥塔内高温区域的影响。
应用推荐