When the magnetic field is measured using a Hall probe, the measurement error due to the self-producing magnetic field by the Hall probe must be taken into account.
在采用霍耳探头测磁场时,必须考虑到探头的自生磁场所引起的测量误差。
The factors affecting the measurement error are also discussed.
对测量误差的影响因素进行了讨论。
Error was analyzed in detail and corresponding methods to reduce the measurement error were given.
详细分析了系统误差并提出了减小误差的相应措施。
The retardation of the Fresnel rhomb phase retarder was measured with the measurement error less than 0.3%.
经过对菲涅耳菱体型相位延迟器件的测试,测量误差小于0.3%。
Objective To implore the application of Item Responses Theory in estimating the measurement error of medical scales.
目的探讨项目反应理论在医学量表测量误差估计中的应用。
Liquid concentration measuring experiments and verifying experiments show that the measurement error is less than 0.14%.
对其进行了浓度测量实验和验证实验,测量误差小于0.14%。
The mechanical process is analyzed by using method of mechanical impedance and the measurement error equations are given.
利用机械阻抗方法分析这类传感器工作的力学过程,给出压电式传感器的测量误差表达式。
The digital lock-in technique is used to rather extract the effective signal from the noise and reduce the measurement error.
采用数字锁相技术从噪声中提取有效信号,以减小测量误差。
The theoretical and experimental analyses show that the measurement error of this method is lower than the one recommended in gb4288-84.
经实验与分析,该法的测量误差小于GB4288—84推荐的测量计算方法。
Firstly the paper describes the composition of the GPS system, the measurement error of GPS in the source and the corresponding solutions.
文章首先介绍了GPS系统的组成,GPS测量过程中的误差来源和相应的解决办法。
By this method the sensor drift can be detected accurately and the measurement error caused by sensor drift may be corrected at the same time.
该方法能够对传感器漂移故障做出判定,同时可实现测量误差的修正。
By using a double phase lock in amplifier to measure the AC strain, the measurement error can be decreased to 0.4% of the total measurement range.
如果使用双相位锁相放大器测量交变的被测量,误差将减小到全量程的0.4%以内。
In each step of the measurement process, the data can't be measured until the hydrophone array is still, in order to minimize the measurement error.
为了减小测量误差,在测量中的每一步都需要等待水听器阵列完全静止再进行采集。
The main factors determining the measurement accuracy are respectively discussed based on the analyses of the measurement error of angular displacement.
对角位移干涉测量系统进行了误差分析,讨论了影响角位移测量精度的主要因素。
It is known that the measurement error for the interior temperature always causes the numerical solution of the inverse heat conduction problem unstable.
众所周知,内点温度的测量误差往往导致导热逆问题计算的不稳定。
Error analysis showed that the measurement error is usually less than 10% for low void fraction flow. So this is a lowcost and accurate measurement method.
误差分析表明,这种测量方法在低空泡率条件下测量误差一般不超过10 %,它是一种低成本、高精度的绝对测量方法。
By analyzing the measurement error of this system, it is known that the precision of detecting feature point is a decisive factor affecting the measurement.
通过对系统数学模型的误差分析,确定标志点的检测精度是影响测量误差的主要因素。
The result of experiment shows that the measurement error from fluid temperature changes can be almost removed, and the accuracy for this system can be improved.
试验结果表明:采用该方法进行温度补偿后,可以基本消除流体温度变化引起的测量误差,提高系统的测量精度。
To obtain high measurement precision, it is necessary to analyze the testing system and build the relationship between the measurement error and system structures.
为了得到较高的检测精度,必须对检测系统进行分析,建立测量误差和系统结构的关联度。
At last, emulated data shows that the measurement error is below 0.15%, the data obtained by emulation shows the high precision of this measurement instrumentation.
仿真数据显示测量误差在0.15%以内,证明了该焦距测量系统对大口径长焦距反射镜焦距有很高的测量精度。
Considering the effect of intensity eliminates the measurement error, which is produced by the variation of distance between the sensor and the object to be checked.
颜色检测中考虑光强影响,消除被测物体与传感器之间距离变化带来的测量误差。
The paper discusses the principle of internal sphere diameter measurement on line, composition of the measuring device and the method of the measurement error correcting.
论述了大型内球面直径在线测量的原理、测量系统的组成及误差修正方法。
The error analysis shows that the measurement error is caused by the noise of the accelerometer, discrete double integration, noise of beacon and frequency characteristic error.
对线加速度计辅助惯性姿态角测量的误差分析表明,测量误差由加速度计噪声、二次积分离散化、信标噪声和加速度计频率特性误差组成。
By using signal latching technique on temperature contrcller, the measurement error caused by electric network fluctuation induced by start-up and shut-off motor can be eliminated.
对控温信号采用了锁存技术,可以消除电机起动与停止导致电网波动所引起的采样误差。
The technology of contactless temperature measurement based on CCD is an important method for high temperature measurement. It is important to reduce the measurement error effectively.
基于CCD的非接触式测温技术是高温检测的重要方法,减少其测温误差有重要意义。
According the error processing criterion, if the measurement error is 3 times larger than the standard error, the singular data can be deleted and substituted with arithmetic average value.
依据拉依达准则,剔除测量误差大于3倍标准差的奇异数据并以算术平均值代替,简便易行。
According to metrological characteristics of diffraction grating, the measurement error models are built up and the equations between installation and measurement errors of grating are deduced.
根据衍射光栅的计量特点,建立了正交衍射光栅测量误差模型,推导了光栅安装误差与测量误差之间的关系。
According to metrological characteristics of diffraction grating, the measurement error models are built up and the equations between installation and measurement errors of grating are deduced.
根据衍射光栅的计量特点,建立了正交衍射光栅测量误差模型,推导了光栅安装误差与测量误差之间的关系。
应用推荐