The thermal decomposition products were characterized by the powder X-ray diffraction (XRD) and transmission electron microscopy (TEM).
运用X -射线粉末衍射(XRD)、透射电镜(TEM)等技术对碱式碳酸铜热重分解产物进行了表征。
The mineral composition and contents in soils can be quantitatively determined by X-ray powder diffraction analysis.
利用粉晶X射线衍射分析方法，能定量地测定土壤矿物组成和含量。
X-ray diffraction and transmission electron microscope experiments indicate the powder sample is amorphous and also show the average particle size and crystallization products.
射线衍射和透射电子显微镜实验不但证实它的非晶性，而且给出它的平均颗粒度大小和晶化产物。
The data of X-Ray Powder Diffraction have proved these phosphors 'structure and their pure crystal composition.
射线粉末衍射数据确证了其晶体结构，证明这些荧光粉晶相组成纯净。
X-ray powder diffraction showed that crystals prepared by cooling and dilution crystallization were of the same structure.
通过X -射线粉末衍射证明了溶析结晶与冷却结晶得到的晶体结构相同。
Method: The formation of the complex was confirmed by IR spectrum and powder X-ray diffraction.
方法：采用红外光谱及粉末X-射线衍射验证复合物的形成。
The failure of the powder metallurgy valve seat was analyzed by optical microscopy, scanning electronic microscopy, X-ray energy spectrum and X-ray diffraction.
采用力学、物理性能测试，金相、扫描电镜、能谱和X衍射分析研究了气门座圈产品失效的主要原因。
Its chemical composition and structure are characterized by the chemical analysis, elemental analysis, IR patterns and X-ray powder diffraction.
经元素分析、X -射线粉末衍射、中红外、远红外光谱进行表征，确定了配合物的组成和结构。
The hydration properties of limestone powder in a complex binder system were studied by using scanning electron microscopy, X-ray diffraction and energy dispersive spectrometer.
用扫描电镜、X射线衍射和能谱技术研究石灰石粉在复合胶凝材料中的水化性能和水化产物。
METHODS The powder X ray diffraction analysis was used by spectrum X ray diffraction analysis. The characteristic marked peaks of talcum was found for identification.
方法应用粉末X射线衍射方法，对取自我国主要滑石产区的药用滑石粉样品进行衍射研究（衍射图谱分析及特征标记峰鉴别）。
The samples' structures were characterized by using powder-X-ray diffraction (XRD) and the samples' morphologies were observed with SEM and the adiabatic temperature changes were determined directly.
用粉末X射线衍射表征材料的相组成，用扫描电镜(SEM)观测样品形貌，用直接法测量材料的绝热温变。
X-ray powder diffraction(XRD), scanning electron microscopy(SEM), transmission electron microscopy(TEM) and photoluminescence spectra were used to characterize the resulted BAM phosphor.
通过X射线粉末衍射（XRD）、扫描电镜（SEM）、透射电镜（TEM）以及荧光光谱对获得的试样进行了表征。
The structures of RDX/RF aerogel were characterized by atomic force microscopy(AFM), scanning electron microscopy(SEM), X-ray powder diffraction(XRD), and BET method.
用原子力显微镜（AFM），扫描电子显微镜（SEM），X 射线粉末衍射仪（XRD），BET 比表面积分析仪对其结构进行了表征。
Phase ratio, particle size and thermal analytical character of the powder have been studied by DTA, particle size analyzer and X-ray diffraction.
应用DTA热分析仪、颗粒度分析仪和X光衍射仪研究分析了粉末的热分解特性、颗粒大小和分布以及相组成。
Methods: FTIR, Raman spectroscopy, thermal analysis and powder X-ray diffraction were applied to study the crystal forms of tegaserod maleate.
方法：运用傅立叶变换红外光谱、拉曼光谱、热分析和粉末x -射线衍射法研究马来酸替加色罗的晶型。
The reaction process was followed by X-ray powder diffraction, TEM and UV-Vis spectroscopy.
利用X射线衍射、透射电子显微镜和紫外-可见光谱等手段跟踪反应过程。
The thermal stability of these two series complexes was studied by TG, DTA, IR spectra and X-ray powder diffraction.
并利用TG、DTA、IR光谱和x射线粉末衍射等手段研究了两系列稀土杂多配合物的热稳定性；
If they have the X-ray powder diffraction patternsof materials, even if being non-expert on X-ray crystal structure, they can conveniently get the index of diffraction lines and cell parameters.
对于非专业X 射线晶体结构人员，只要得到材料衍射图谱后，能很方便计算点阵常数和衍射线指标化。
An experimental study was made on the products of anode reaction in zinc manganese dioxide dry cells after different types of discharge using X-ray powder diffraction and infrared spectrum.
干电池经不同方式放电后的负极反应产物物相，用X射线衍射和红外光谱进行了测定和研究。
A new crystal structure of Nateglinide called s - out was found and determined by X - ray powder diffraction method. The pattern, data and the crystal size were given.
用X射线衍射相分析法发现并确定降血糖新药那格列奈另一种新的晶型结构，我们称之为s型。
Based on slice identification and X ray powder diffraction, the mineral compositions in "di" of Changhua Chicken Blood Stone are systematically studied in this paper.
在野外地质调查基础上，对昌化鸡血石“地”的矿物组成进行了镜下鉴定和粉晶x射线衍射分析研究。
According to the experimental product derived from its X-ray powder diffraction peak curve bread is amorphous, glycine template no diffraction peak of copper.
根据实验所得的产物其x -射线粉末衍射曲线呈馒头峰是非晶态，没有出现模板甘氨酸铜的衍射峰。
In this paper, the X-ray powder diffraction data of unknown Crystal Systems of dipropyl-(2-hydroxy phenyl) phosphate have been indexed Successfully by the improved trail-and-error method.
本工作使用改进的尝试法成功的指标化了未知晶系粉末样品邻羟基苯基二丙基磷酸酯的粉末X射线衍射数据。
The effects of minerals (oxides) on coke microstructure are studied by adding 13 types of different oxides into coal to carbonize using optical microscopy and X-ray powder diffraction.
将十三种矿物质（氧化物）添加到煤中炭化，用光学显微镜和X射线衍射方法研究矿物质的存在对所得焦炭显微结构的影响。
Scanning electron microscopy and X-ray diffraction were used to analyze the starting tungsten powder, the carburized tungsten powder and the deposit.
采用扫描电镜和X射线衍射仪分析了原始钨粉、炭化粉末和反应沉积物的显微组织和成分。
The obtained products were characterized by powder X-ray diffraction (XRD), scanning electron microscopy (SEM), and field-emission scanning electron microscopy (FE-SEM).
利用粉末X射线衍射（XRD）、扫描电镜（SEM）和场发射扫描电镜（FE-SEM）对所得产物进行表征。
The obtained products were characterized by X-ray powder diffraction (XRD), X-ray photoelectron spectroscopy (XPS), and scanning electron microscopy (SEM).
合成产物用粉未衍射（XRD）X-射线光电子能谱（XPS）和扫描电子显微（SEM）表征。
The influence of bedding powder on phase composition and microstructure was studied by X-ray diffraction and Scanning Electron Microscope (SEM), and the optimum parameters were obtained.
采用X射线衍射仪和扫描电镜分别测定产物相组成及相对含量、显微形貌，研究了埋粉对产物相组成的影响，并确定了合成过程的最佳工艺参数。
The surface structures were characterized by laser particle size analysis, X-ray powder diffraction analysis (XRD) and gravimetric method, respectively.
用粒度分析、X射线衍射分析和重量分析法分别对机械活化闪锌矿的结构进行了表征。
The surface structures were characterized by laser particle size analysis, X-ray powder diffraction analysis (XRD) and gravimetric method, respectively.
用粒度分析、X射线衍射分析和重量分析法分别对机械活化闪锌矿的结构进行了表征。
应用推荐