XE--- Rack shift coefficient for adjustment of tooth thickness.
按照字面是：调节齿厚的齿条位移系数。
Gear tooth thickness at the site are unilateral wear, so gear can be rotated 180 degrees to use.
齿轮在齿厚部位都是单侧磨损，所以可将齿轮翻转180度使用。
Machining Tolerance is the permissible variation in actual space width or actual tooth thickness.
加工公差是花键的实际齿槽宽和实际齿厚的允许的变动量。
And finally a new norm is put forward for selecting backlash and tooth thickness deviation of gears.
最后，提出了一种新的侧隙和齿厚偏差选择规范。
There is only approximate way to work out the normal chordal tooth thickness of worm and wormwheel at present.
目前所见到的圆柱蜗杆蜗轮分度圆弦齿厚计算公式均为近似公式。
Deviation measurement of tooth thickness and conical point of straight bevel gear by using steel bail was studied and approached.
对钢球法测量直齿圆锥齿轮齿厚及锥项位置误差检测进行了研究和探讨。
Formulas are given in many mechanical manuals to calculate the tooth thickness at only the reference circle of worm and worm wheel.
蜗轮蜗杆的分度圆齿厚在大部分机械手册中都给出了计算公式，但在其它任意半径处的齿厚计算很少有资料涉及。
This article mainly introduces the method that adopts gear caliper to measure the median diameter normal tooth thickness of double-line trapezoidal thread.
本文主要介绍了采用齿轮卡尺测量双线梯形螺纹中径法向齿厚的方法，同时也测量出螺距产生的误差。
There is no common normal in the conical involute gear and the fixed chordal tooth thickness can not be measured accurately because of the coexistence of helix angle and taper.
渐开线锥形齿轮由于同时存在锥度和螺旋角，使得其固定弦齿厚无法精确测量，也没有公法线。
Because of the tooth thickness of the dedendum is larger than that of the common involute gear and the Pitchs do not contact each other, the beam strength and surface strength of tooth are increased.
由于该齿轮的齿根厚度比普通渐开线齿轮的齿根厚，并且节点附近不相接触，因此，其轮齿弯曲强度和接触强度都提高。
Because of the tooth thickness of the dedendum is larger than that of the common involute gear and the Pitchs do not contact each other, the beam strength and surface strength of tooth are increased.
由于该齿轮的齿根厚度比普通渐开线齿轮的齿根厚，并且节点附近不相接触，因此，其轮齿弯曲强度和接触强度都提高。
应用推荐