These bearings have a larger contact angle and no filling slots.
这些轴承有更大的接触角和无填充槽。
Contact Angle and XPS were employed to evaluate grafting effects.
并通过接触角、XPS等方法对接枝效果进行检测。
The properties of a class of curve shortening flows with contact Angle is studied.
对一类带接触角的曲线收缩流的性质进行了研究。
Two common measuring methods of fiber contact Angle were introduced in this paper.
介绍了两种常用的纤维接触角测定方法。
The existence of MPS is examined by thermogravimetric analysis and contact angle testing.
热重分析和接触角测试验证了粒子表面MPS的存在。
The change of CL conformation in water was analyzed with dynamic contact Angle measurement.
动态接触角分析说明了CL接触水相时构象的变化。
The contact Angle hysteresis indicated the Chemical heterogeneity on the oxidized PE surfaces.
氧化后聚乙烯表面上的液体接触角滞后是由于表而化学不均匀性所致。
The contact angle (CA) evaluated from the model is in good agreement with the value from experiments.
结果表明，当表面粗糙因子取最大值时，所得接触角的理论值都与实验值相符。
The raceways of both the inner and outer rings of this bearing type are made with a set contact Angle.
双方的这种类型的轴承内圈和外圈的滚道是由一组与接触角。
As a result, the contact Angle of CFs with respect to epoxy resin was found to be remarkably decreased.
结果表明，经过氧化和氨化方法处理后碳纤维与环氧树脂的接触角降低。
The effect of the esterification on contact angle is obviously bigger than that of graft copolymerization.
酯化处理所产生的接触角增大作用要比接枝共聚所产生的作用大；
The properties of the copolymer were studied by IR, TG, moisture-protection and contact Angle measurements.
通过IR、TG、防潮试验、接触角测试研究了共聚物膜的性能。
Contact Angle is one of the handiest and most widely used methods, which are used to identify solid surface.
接触角是最方便、应用最广泛的表征固体表面的标准方法之一。
The study on nuclear process indicates that super saturation and contact angle has obviously influence on nuclear speed.
对成核过程的分析表明，过饱和度以及表面接触角对于成核速率有着明显的影响。
An alternate experimental approach which does not require the direct measurement of contact Angle appears to be promising.
有一种可选用的试验方法看来很有希望，它不要求直接测量接触角。
The test results show that both the height method and pressure method can be used for measurement of powder contact angle.
试验结果表明，压力法和高度法均可用于粉末接触角的测定。
The property changes of foam rubber surface before and after the treatment were studied by XPS and contact Angle measurement.
通过X射线光电子能谱分析和接触角测定，研究了处理前后泡沫橡胶表面性质的变化。
The polymer structure was investigated by using FTIR, X-ray diffraction, electron diffraction and contact Angle measurements.
通过热失重，红外光谱、X -射线衍射、电子衍射和接触角测定等，研究聚合物结构与性能。
Design a variety of radial clearance and the contact Angle, to meet different application requirements of load and deflection.
设计有多种径向游隙和接触角，满足不同的应用负荷和偏斜要求。
The sessile drop technique is used to measure the contact Angle between molten aluminum and graphite or copper coated graphite.
采用改进的座滴法分别测定了铝熔体与石墨、镀铜石墨的接触角。
Contact Angle measurement indicates modified membranes are more hydrophobic and of higher benzene solubility than unmodified one.
接触角测量结果表明，改性膜的亲苯性和疏水性均增强。
With increasing the content of PEG in block copolymer, the surface contact Angle and the adhered bacteria on surfaces of polymers decreased.
PEG嵌段在共聚物中的含量越高，材料表面接触角越小，黏附的细菌越少。
FAG single row angular contact ball bearings of series 72b and 73b have a contact Angle of 40. They can therefore accomodate high axial loads.
FAG单列角接触球轴承72b和73 B系列有一个40度的接触角，因此它们能够提供较高的径向载荷。
In terms of viscosity, osmosis time, contact angle and oil absorption this paper evaluates the effect of surface modification of mineral filling.
本文主要介绍改性石英填料的粘度、 浸润性能（渗透时间、浸润角、浸润点等）等指标，以及表面改性效果的评价方法。
Due to their contact Angle, single-row angular contact ball bearings are better suited to sustaining high axial loads than deep-groove ball bearings.
由于其接触角，单列角接触球轴承比深沟球轴承更适合维持高轴向负荷。
Based on the measurement of the contact Angle of differently treated ITO, the surface energy and polarity were calculated using the harmonic mean method.
在测量ito接触角的基础上，应用调和平均法计算了不同表面处理ITO阳极的表面能和极性度。
The relationship between the morphology and the dynamic contact Angle of polypropylene fibers treated by plasma was found out through comparative analysis.
通过比较分析得出了等离子体处理后丙纶纤维的表面形态和表面接触角的关系。
Surface properties of PVC were characterized by the contact Angle, surface tension, X-ray photoelectron spectroscopy (XPS) and electron spin resonance (ESR).
等离子体改性前后pvc的表面特性通过接触角、表面张力、X -光电子能谱(XPS)、电子自旋共振(esr)表征。
Many properties of material were tested, such as mechanical property, surface water contact Angle, water absorption rate, infrared spectrum and ESCA analysis.
测试了材料的力学性能、表面接触角、吸水率，同时对材料进行了表面电子能谱(esca)分析。
Chemical roughening method was applied to treat plastic surface, roughness and contact Angle of plastic surface were determined before and after it was treated.
采用化学糙化法对塑料表面进行处理，测定了处理前后表面的粗糙度及接触角。
应用推荐