All tests are performed on current source inverter.
本文是以电流源型逆变器进行系统试验的。
Generating UML diagrams based on the current source code, using UMLGraph.
使用UMLGraph生成当前源代码的UML图。
An ideal PV cell can be modeled as a light-induced current source in parallel with a diode.
理想PV电池的模型可以表示为一个感光电流源并联一个二极管。
The current source adopts cascade structure to improve power supply rejection ration (PSRR).
电流源采用共源共栅结构，提高了电源抑制比。
The ohmmeter USES an internal current source and electrometer voltmeter to make the measurement.
欧姆计使用内部的电流源和静电计电压表来进行测量。
Collect the controller to the constant current source of each panel lights when dimming is needed.
调光时需将调光控制器安装至每个需调光的平板灯的恒流源对应接口。
In the current source transduce, LC filter is the best structure to filter the switching harmonic.
电流源变流器中，L C滤波器是滤除开关谐波的最佳结构。
The relationship between the control voltage and the current output by the constant-current source may shift.
控制电压和由恒流电源输出的电流之间的关系改变可能会产生漂移。
It shows in theory that the frequency domain sounding in near zone of the line current source is possible.
通过对计算结果的分析，在理论上说明了线源频率域近区测深的可行性。
Computer aided analysis and design flow chart and program for current source inverter circuit are presented.
提出了该逆变器的通用计算机辅助分析与设计框图和源程序。
A new and practical power factor control strategy for three phase PWM current source rectifier was proposed.
提出了三相电流型PWM整流器的一种新型实用的功率因数控制方法。
First, we obtain an instance of type IInformationControlCreator from the current source viewer configuration.
首先，我们从当前源代码查看器配置中获得了一个IInformationControlCreator类型的实例。
It consists of a voltage-controlled current source, a voltage-controlled voltage source and a voltage source.
该模型由一个电压控制电流源、一个电压控制电压源和一个电压源构成。
This paper describes the principle of sin voltage source and current source that can be programme controlled.
文章主要介绍程控正弦功率电压源和电流源校表仪的原理。
The key to improving the measurement accuracy of Hall magnetometer lies on highly accurate control current source.
提高霍耳磁强计磁场测量精度的关键之一是需要高精度的控制电流源。
Figure 2-39 shows an electrometer connected to a current source that consists of a voltage source in series with a resistor.
图2 - 39所示为静电计和由电压源及电阻器串联组成的电流源相连接。
In this method, shown in Figure 1-20, a current source generates current (I), which flows through the unknown resistor (RX).
在图1 - 20所示的这种方法中，电流源产生的电流(I)流过未知电阻器(RX)。
It consists of a nonlinear voltage-controlled current source, a nonlinear voltage-controlled voltage source, and capacitance.
该模型由一个非线性电压控制电流源、非线性电压控制电压源、电容构成。
If you do not specify an argument, the tool displays the five source code lines before and after the current source code line.
如果没有指定参数，此工具将显示当前源代码行之前和之后的五个源代码行。
This suggests that it is safer to clean the build outputs first so you know you are using the run-time version of the current source.
所以安全起见，建议您先将输出结果清空，以保证您在重新构建后所使用的是对应于当前源文件的运行期版本。
The converter 1 is controlled as a fundamental sinusoidal current source, and the converter 2 is controlled as a voltage source.
变换器1被控制为一个基波正弦电流源，变换器2被控制为一个可控电压源。
The change cannot be committed into the current source tree for some reason, such as a breaking change, that would affect the build.
出于某些原因，更改无法提交到当前源代码树中，比如将会影响编译的重大更改。
From the stability formula of the base circuit, the stability expression within constant current source and assistant power is discussed.
从基本电路的稳定度公式出发，讨论了采用恒流源负载和辅助电源的稳定度表达式。
In the circuit design, unit current source arrays and digital synchronizing cells are used to improve the matching and dynamic range of DAC.
电路设计中使用单位电流源阵列和数字同步控制单元来提高电流源的匹配性和动态范围；
If using a separate current source and voltmeter to make low resistance measurements, each instrument must be checked for non-ohmic contacts.
如果使用分离的电流源和电压表来进行低电阻测量，则必须检查每台仪器的非欧姆接触情况。
The field length analysis is an analysis of whether or not current source systems can map correctly at the field length level of our target model.
字段长度分析是分析当前的源系统是否能在字段长度上与目标模型映射。
But fundamental loop analysis method can not be used for approaching the loop analysis problems of the loop containing current source branch.
但是基本的回路分析法不能用于处理含有电流源支路的回路分析问题。
And the resistors have to be omitted while meeting series-connection resistors connected with current source in the application of node analysis.
在应用结点电压法分析电路时，如遇到与电流源串联的电阻，电阻必须省略。
And the resistors have to be omitted while meeting series-connection resistors connected with current source in the application of node analysis.
在应用结点电压法分析电路时，如遇到与电流源串联的电阻，电阻必须省略。
应用推荐