The appearance of the large SiC particles resulted in the decrease of fracture strength.
大颗粒碳化硅的出现造成了试样断裂强度的降低。
The fracture strength of circular diamond film was measured by a burst pressure technique.
利用压力爆破技术测量了圆形金刚石膜的断裂强度。
The real fracture strength is restrained by both stresses caused by outside load and residual stresses after grinding.
实质断裂强度性能受到了外加载荷与磨削残余应力的组合应力的制约。
In this paper, the influence of the surface residual stresses of ceramics grinding on fracture strength has been studied.
探讨了陶瓷磨削表面残余应力对断裂强度的影响。
Physicochemical properties optimal fiber fracture strength, modulus moderate, elongation, spinning weaving performance is good.
物化性能优纤维断裂强度、模量适中，伸长大，纺纱织造性能好。
Conclusion the aesthetic effect, margin fitness and anti-fracture strength are excellent in gold galvanized porcelain fused crown.
结论金沉积烤瓷冠具有良好的美观效果，边缘密合度好，抗折强度高。
Results show that the open porosities are decreased and fracture strength is increased with the increase of the sintering temperatures.
结果表明；随着烧结温度的升高，开口气孔率降低，断裂强度升高。
Besides, minimum radius and radius ratio of particle, especially the latter, have adverse effects on fracture strength factors of rock.
岩石颗粒最小粒径与颗粒半径比均对断裂强度因子有不利影响，且颗粒半径比的影响较大。
The SCC is a delayed failure, it means the crack initials and propagates at a slow strain rate until the stress reaches the fracture strength.
应力腐蚀开裂是一种延迟失效，它意味着裂纹的缩写，并在一个缓慢的应变率传播，直到应力达到断裂强度。
Conclusion the fracture strength of premolar teeth filled with light curing composite resin was higher than filled with amalgam after root canal therapy.
结论根管治疗后用光固化树脂充填前磨牙的各类洞，牙体的抗折强度优于用银汞充填者。
The fracture strength of rectangular plate with inclined crack is analyzed considering two failure modes of elastic fracture and fully plastic failure respectively.
对具有中心穿透斜裂纹在弹性断裂和完全塑性断裂两种破坏模式下的断裂强度进行了分析。
Through the analysis of mechanical properties of the specimens, the relationship between the fracture strength and bulk density was characterized in a linear equation.
通过对试样力学性能的分析可知，推导出了材料断裂强力与体积密度的关系式。
Fracture strength of meat ball increased slowly with tripolyphosphate contents increasing, but the fracture displace increased at 0.1% dosage and leveled off after that point.
肉丸破裂强度随三聚磷酸钠添加量的增加而较缓慢地增加，其破裂点距离在高于0·1%的添加量后不再增加。
It is pointed out that, at the same tempering degree, the fracture strength increases with the increasing of the thickness of tempered glass, but does not for untempered glass.
指出在相同的钢化程度下，热钢化玻璃的断裂应力随玻璃厚度的增加而提高，而非钢化玻璃的断裂应力并不受玻璃厚度的影响。
The SMA plate with the high content of impurity have two-step fracture phenomenon, whose ultimate fracture strength is higher than the normal one, however, its plasticity is worse.
杂质含量高的板材出现两次断裂现象，其最终断裂强度比普通板材高，但塑性差；
With no yielding up to its fracture strength of CFRP, the stress of CFRP at the maximum shear loading is found to be the key parameters in determining shear strength of the columns.
由于碳纤维布无屈服现象，故达到最大荷载时碳纤维布的应力是确定加固后柱受剪承载力的关键参数。
For the green body containing a certain size of SiC powders, the carbon particle should be less than a certain size, or else, the density and fracture strength of RBSC decrease wit...
对于一定粒度的碳化硅粉而言，加入到生坯中碳粉粒度应小于一定尺寸，否则，陶瓷的断裂强度和密度将随碳粉粒度的增大而降低。
The experimental results show that the fracture strength and strain first increase and then decrease with increasing the Ti content, and reaching the maximum value when Ti content is 5 at. %.
试验结果表明，随ti含量增加，合金的断裂强度及断裂应变先增后降，在Ti含量为5at。%时达到最大值。
Through the design of the different resin injection technology the author discovers that the usage of assisted vacuum degree during RTM injection process can increase fracture strength from 1.
通过设计不同的辅助真空压力树脂注入工艺 ，发现在RTM制造过程中 ，有效地利用真空技术 ，可使产品的断裂强力分别由1 。
Conclusions: on fixation of femoral neck fracture, the smaller volume of implant should be chosen based on assuring the fixation strength.
结论：在行股骨颈骨折内固定时，在保证内固定强度的前提下，应选用体积尽可能小的内固定物。
Under the action of tensile stress and tensile stress, the bolt with relatively low strength will crack first, and then the fatigue fracture will occur.
在拉应力和应拉力交替的作用下，强度相对较低的螺栓会先产生裂纹，进而发生疲劳断裂。
Ongoing research will serve to refine the best modalities for assessing the bone strength of children and to determine the key clinical variables that influence fracture risk independent of bone.
接下来的研究会致力于改进儿童骨骼强度评估的最佳方式并对会影响骨折风险的、不依赖于骨骼本身的临床变量进行测定。
Also it has been determined that fracture spacing, aquifer strength and skin factor have insignificant effect on water coning in fractured reservoirs.
另外，裂缝间距、蓄水层强度和表皮系数在裂缝型油藏中的水锥现象也起重要作用。
The paper discusses over the influence exerted by welding residual stress on the static strength, brittle fracture and stress-corrosion cracking of metal structure.
本文介绍了焊接残余应力对金属结构的静强度、脆性断裂以及应力腐蚀开裂的影响。
When the applied load exceeds the limit strength of the material as a result of parts breaking overload fracture.
当外加载荷超过材料强度极限而造成零件断裂称为过载断裂。
The results showed that multiple solution and aging treatment had a significant effect on increasing plastic property and fracture toughness, although had little effect on strength.
结果表明：多重固溶时效热处理可以显著提高合金的塑性和断裂韧度，而对强度的影响不大。
The results showed that multiple solution and aging treatment had a significant effect on increasing plastic property and fracture toughness, although had little effect on strength.
结果表明：多重固溶时效热处理可以显著提高合金的塑性和断裂韧度，而对强度的影响不大。
应用推荐