A fuzzy control system of plasma energy transfer is designed to make the plasma torch work best.
研究设计等离子体能量传递模糊控制系统，使等离子体炬工作在最佳状态。
In chapter 4, design and stability analysis methodologies of adaptive fuzzy control system are discussed.
第四章探讨了自适应模糊控制系统的设计与稳定性分析方法。
This paper introduces the fuzzy control system of microwave stove based on the 8051 single-chip processor.
介绍了一种基于8051单片机的微波炉模糊控制系统。
We adopt a rule of three steps fuzzy control system applying to temperature control of vacuum sintering furnace.
采用了一种三段规则的模糊控制策略，对真空烧结炉的温度进行控制。
This paper presents a switched reluctance motor (SRM) fuzzy control system based on digital signal proces-sor (DSP).
提出了一种基于数字信号处理器(dsp)的开关磁阻电动机模糊控制系统。
A fuzzy controller for the greenhouse is designed, and the fuzzy control system of the greenhouse temperature is built up.
设计出模糊控制器，并建立温室温度的模糊控制系统。
A fuzzy control system of fuel injection quantity for diesel engine based on virtual instrument technology was established.
基于虚拟仪器技术设计了一个柴油机喷油量模糊控制系统。
This paper introduces the principle and structure of the intelligent fuzzy control system of material flow of the belt conveyer.
介绍了带式输送机物流流量的智能模糊控制系统的工作原理和构成。
Adaptability is the target for fuzzy control system. Two kinds of ship steering motion adaptive fuzzy control system are proposed.
自适应的模糊控制器是人们追求的目标，本文提出了两种船舶操纵自适应型模糊控制系统。
A self - organized fuzzy control system used for a dual wavelength frequency stabilized CO2 laser with high precision is presented.
报道了一种用于高精度双波长稳频CO2激光的自组织模糊控制系统。
The fuzzy self-tunning PID control system consists of two parts which are parameter adjustable PID system and fuzzy control system.
PID参数模糊自整定系统主要由参数可调整PID控制器和模糊控制器两部分组成。
And we can establish the fuzzy control system, confirm PID parameter control model, and enable the control to achieve the desired effect.
建立模糊控制系统，确定模糊自整定PID参数控制模型，使控制达到最佳效果。
With fuzzy control software development platform, the design quality of fuzzy control system is improved and the design period is cut down.
应用该家用电器模糊控制开发平台大大提高了模糊控制系统设计质量，缩短设计时间。
The design of an expert fuzzy control system which applies expert system theory and fuzzy control theory to temperature control process is described.
将专家系统和模糊控制的理论应用到温度控制过程中，介绍了这类专家模糊控制系统的设计方法。
In order to effectively control the piston displacement of a linear refrigerator compressor, a new fuzzy control system based on self-adjusting was proposed.
为了有效地控制直线冰箱压缩机的活塞位移，提出了一种以活塞上死点位移为控制目标的可自调整规则的模糊控制系统。
This paper describes the method of description function in detail in the analysis of stability on the hybrid fuzzy control system and gives an actual example.
本文针对混合模糊控制系统，详细地描述了其稳定性分析的描述函数法，并给出了应用实例。
The two methods can eliminate quantization errors and adjusting dead zone thoroughly, and provide a new way for designing fuzzy control system with high accuracy.
这两种方法可完全消除量化误差和调节死区，为设计高精度模糊控制系统提供了一种新途径。
Emphasis is put on the fuzzy logic control, neural network control, and both crossed neural network with fuzzy control system along with its application and design.
文章着重介绍模糊逻辑控制、神经网络控制以及它们的交叉结合的神经网络-模糊控制系统及其应用与设计。
This paper simulates the forecast process as a"fuzzy control system", takes the forecast factors as the input data , and the forecast quantities as the output data.
本文将预测过程模拟成一个“模糊控制系统”，以预测因子作为系统的输入，预测量作为系统的输出。
Based on switch mode sensor of relative wind direction, we present a kind of tracing wind fuzzy control system with constant sample cycle and variable control cycle.
基于开关式相对风向传感器，提出一种固定周期采样、变周期控制的风向随动模糊控制系统。
In a direct torque fuzzy control system of electric vehicle, when the voltage model is used as stator flux observer, the system's low speed performance becomes poor.
电动汽车直接转矩模糊控制系统中，定子磁链观测器采用电压模型时，系统低速性能变差。
Inthis paper a fuzzy control system for cooling water system is introduced. By simulation the results show that the design of this fuzzy control system is reasonable.
本文介绍一种采用模糊控制技术调节冷却水系统冷却水量的方法，经仿真验证，控制效果良好。
The basic structure and operational principle of the test bench for fuel injection pump are described briefly and the basic design of fuzzy control system is analyzed.
简述了喷油泵试验台的基本结构和工作原理，分析了模糊控制系统的基本设计。
This paper introduces a temperature fuzzy control system of electric furnace. The basic theory design method and experimental results of fuzzy controller are described.
本文介绍了微机模糊控温系统。阐述了模糊控制器的原理与设计。给出了实验结果和结论。
The result of experiment shows that this method eliminated steady state error of the system inherently, and improved performance of steady state of fuzzy control system.
实验结果表明：此方法能从本质上消除系统的稳态误差，明显地改善了模糊控制系统的稳态性能。
Several main random noises of arc furnace are identified by fuzzy cluster analysis method. A fuzzy control system of arc furnace is designed, and good control result has got.
用模糊聚类分析的方法对电弧冶炼炉的几种主要随机干扰进行辨识，并在此基础上设计了电弧冶炼炉模糊控制系统，取得了良好的控制效果。
Several main random noises of arc furnace are identified by fuzzy cluster analysis method. A fuzzy control system of arc furnace is designed, and good control result has got.
用模糊聚类分析的方法对电弧冶炼炉的几种主要随机干扰进行辨识，并在此基础上设计了电弧冶炼炉模糊控制系统，取得了良好的控制效果。
应用推荐