Adjusting delay time and gas pressure can reduce the warpage of the part.
工艺上可以通过调整延迟时间和气体压力来减小产品的变形量。
In addition, the laser pulse width decreases as the gas pressure increases.
另外，激光脉冲宽度随气压的升高而减小。
A precision pressure regulator maintains the carrier-gas pressure constant.
精密压力调节器可以维持载汽压力恒定。
The gas pressure should be considered to calculate the settlement for landfills.
提出了在填埋场沉降计算时考虑气压影响的必要性。
The stability of gas pressure is crucial to assure the quality of ductile cast iron pipes.
煤气压力的稳定性是保证球墨铸管退火质量的关键。
The number of light emission spikes of discharge increases with the gas pressure increasing.
随气压的增加，放电的光信号脉冲数不断增加。
Reducing the gas pressure also brings about a sudden drop in temperature, typically from 10c to -30c.
减低气压也会带来温度的骤降，通常是从10度降至零下30度。
A pressure control manifold then controls the gas pressure that is fed to the process or application.
压力控制管控制着输入到生产过程或应用的气体压力。
The optimum buffer gas pressure for LIF emission increases with the temperature of the heat pipe oven.
使发射达到最大值的最佳缓冲气压随热管炉温度的增加而增加。
In addition, the stability of the plasma radiation was not affected by the higher nebulizer gas pressure.
另外，使用较高的载气压力并不影响等离子体辐射的稳定性。
(aeronautics) having a form maintained by a rigid keel-like structure as well as by internal gas pressure.
(航空学)其外形由坚固的、龙骨状的结构以及内部气压两者同时支撑。
The feedback system, composed stepper motor and pressure sensor, stably controls and adjusts gas pressure.
步进电机和压力传感器组成的反馈系统，能稳定地控制和调节气压。
This paper presents a method of keeping press of mixing gas pressure constant with the use of fuzzy control.
本文介绍了利用模糊控制技术对混合煤气加压机这种非线性系统进行恒压控制的方法。
In this region, its thickness and potential fall are mainly determined by discharge current and gas pressure.
在这一区域内，阳极位降、阳极位降区厚度主要由放电电流和气体压强所决定。
The gas pressure within vacuum interrupter has a direct effect upon the properties of vacuum circuit breaker.
真空灭弧室的内部气体压力直接影响真空断路器的性能。
It is shown that the plasma density increases with increasing workpiece voltage, source voltage and gas pressure.
结果表明，随着工件阴极电压、源极电压和气压的增加，等离子体密度增大。
A sufficiently large and dense core can overcome the outward force of gas pressure to collapse under its own weight.
够广大且够致密的云核，会以自身的重量克服向外的气体压力而崩塌。
The gas pressure and electrical stack temperature of the system can be set at any value required in an actual experiment.
此控制系统的气体压力值和电堆温度值可以任意设定在具体实验要求的某一数值。
To measure gas pressure is always a difficult problem, especially mensuration in coal bed is more difficult to guarantee.
瓦斯压力测定一直是个难题，尤其在煤层里测定更是难以保证。
(aeronautics) designating an airship having a shape maintained only by internal gas pressure and without a supporting structure.
(航空学)指飞艇或者飞船，其外形只由内部气压所支撑，没有支撑结构。
Chief factor of influence nitriding is temperature, the grain size of material, the component of alloy, gas pressure and purity.
影响增氮的主要因素有：温度、物料的粒度、合金成分、气体压力和纯度。
The effects of various factors on the desulphurization of melt were studied by changing gas species, gas pressure and melt polarity.
通过改变气体种类、压力和熔体极性，研究了各种因素对熔体脱硫的影响。
It USES a fast actuated nozzle to follow the exhaust pulse, reducing the turbine inlet area periodically to increase exhaust-gas pressure.
涡流增压器采用了一个快速响应喷头来跟踪尾气脉冲，减少内燃机的进气周期，从而增加尾气排放压力。
The experimental results show that the mean pore diameter decreases with increasing solidification pressure (the overall gas pressure).
结果表明，随着凝固压力(气体总压)的增大，气孔平均直径不断降低。
Thevariational curve of burning gas pressure as the time measured in the base bleed unit coincides with the curve calculated by the above model.
实测的底排装置内的燃气压力随时间变化曲线与利用上述计算模型计算出来的曲线吻合得较好。
This resulted in the Soviets being able to increase gas pressure through a preheater something american rocket scientists thought was impossible.
这就导致了苏联火箭可以通过加装一个预热器，来增加气体压强。 着在美国科学家看来是个不可能的事情。
To realize high precision control of top pressure, the dynamic mathematical model of top gas pressure recovery turbine (TRT) system was researched.
为实现高炉顶压的高精度控制，提出了高炉煤气余压透平装置(TRT)系统炉顶压力的动态数学模型。
During fracture propagation driven by detonation gas in oil well, dynamic response of crack surface under the gas pressure results in fast fracturing.
油井爆生气体对岩石劈裂作用过程，是裂缝面对动态荷载响应并使其发生动态扩展的过程。
This paper presents a process of a "Portable Testing Instrument for Train Brake Pipe Gas Pressure", including hardware design and software development.
本论文完成的工作包括便携式列车管气体压力测试仪的硬件设计与软件开发。
This paper presents a process of a "Portable Testing Instrument for Train Brake Pipe Gas Pressure", including hardware design and software development.
本论文完成的工作包括便携式列车管气体压力测试仪的硬件设计与软件开发。
应用推荐