The results we obtained prove that the power function curve can not only improve the service life of the backup roll but also benefit the profile and shape control of hot rolled strip.
经试验验证，采用幂函数的辊形优化曲线可提高支撑辊使用寿命，并有利于板凸度和板形控制。
The hot rolled BZ37 steel plate is mainly used for cold stamped camion wheel.
BZ 37热轧钢板主要用于冷冲压加工汽车车轮。
Roasting roller is an unavoidable part in the production of hot rolled silicon steel.
烫辊是热轧硅钢片生产不可避免的环节。
Production hot rolled ultra thin strip can bring good benefits, but increase the difficulties of rolling.
生产热轧薄带在给企业带来丰厚效益的同时，也使生产难度增加。
The width of laser welds on the top and bottom surfaces of hot rolled plates after laser welding was measured.
测量了激光对接焊后热轧钢板正背表面焊缝宽度，分析了激光焊的焊接速度对热轧钢板焊缝成形和质量的影响。
The edge-masking technology can ease the edge waves of the cooled hot rolled strip with low carbon and thin gauge.
边部遮挡技术能够有效消除低碳钢、薄规格带钢冷态时的边浪。
In the present article, the feasibility of the production of hot rolled TRIP steels using TSCR process was analyzed.
本文就薄板坏连铸连轧生产热轧TRIP钢的可行性进行了分析和讨论。
HP295 hot rolled plate is one of the major materials used for the Liquid Petrol Gas (LPG) steel cylinder of automobiles.
HP295热轧钢板是机动车用液化石油气(LPG)钢瓶的主要材料之一。
A hot torsion test was used in this study for measuring and comparing the hot plasticity curve of as-cast and hot rolled HSS.
本研究采用热扭转法测定和比较了铸态与轧态高速钢的热塑性特征曲线。
The structure and installation of the pipe nozzles have important effect on the cooling process of hot rolled strip and plate.
冷却集管及喷嘴的结构和安装对于热轧板带层流冷却效果有重要的影响。
The microstructure of iron oxide scales, as one of the essential factors, is important to pickling quality of the hot rolled strips.
氧化铁皮的显微结构是决定热轧带钢酸洗性能的本质因素之一。
Edge heating process can uniform the temperature of hot rolled stip and then benefit the property and dimension precision of the strip.
边部加热对于均化热轧带钢横向温度分布、提高产品性能及尺寸精度具有重要影响。
It represents the trial manufacture of grade X80 pipelines steel hot rolled coil with characteristic of acicular ferrite at BaoSteel Mill.
简要介绍了宝钢试制的以针状铁素体组织为特征的X80级管线钢热轧板卷。
Alloy steel, die steel, tool steel. Processing materials for the user model and the cold drawing hot rolled round steel bar. Can be long-term stock.
合金钢，模具钢，工具钢。可为用户加工生产材质型号热轧圆钢及冷拉圆钢。并可长期现货供应。
U-shaped control model for coiling temperature was put forward to improve the high strength and low plasticity of head and tail of hot rolled strip.
针对热轧带钢因卷取后钢卷内外圈与芯部的冷却速度不同，导致带钢成品头尾强度高、塑性低的问题，提出了卷取温度凹型控制模式。
The effect of annealing temperature on fibrous texture of cold rolled IF steel sheet rolled from strip hot rolled in ferrite region was investigated.
研究了铁素体区热轧if钢经冷轧后，不同退火温度对丝织构的影响。
In order to eliminate the red scale on surface of hot rolled strip, the descaling and rolling experiments in lab and industrial trials were carried out.
为了解决热轧卷板生产中出现的表面红色氧化铁皮问题，进行了实验室除鳞热轧实验以及调整轧制工艺的工业性试验。
The article introduces the main composition, characteristics and operating principle of intensified cooling system used for hot rolled strip application.
介绍热轧带钢加密冷却装置的主要结构组成、特点、工作原理。
SEM and XRD results show that the composite that is hot rolled after vacuum forming, has relatively high density and can avoid being oxidized effectively.
结果表明，采用真空热压后热轧工艺制备的碳纳米管铜基复合材料的致密度较高且能有效地防止被氧化。
The results showed that high cooling rate of hot rolled billet resulted in abnormal microstructure formation and high hardness, which caused shear cracking.
结果表明，原材料热轧后冷速过快，造成组织异常，硬度偏高，导致了剪切开裂。
The cold bending property is one of the important targets for the hot rolled strip, the cold bending test is required inspection item stipulated in the standards.
冷弯性能是热轧中薄板带材的重要指标之一，冷弯试验是标准规定的必检项目，但在实际生产中经常出现冷弯不合格现象。
A mathematical model for level adjustment on the finishing train is set up on the basis of analysis on the side camber and single edge wave of the hot rolled strip.
本文解析了热轧带钢侧弯及单边浪板形，在此基础上建立了精轧机组进行水平控制的数学模型。
The results show that when the nitrogen content is decreased, the yield strength of hot rolled plate decreases, which meets the requirement of cold-rolled base stuff.
指出了钢中氮质量分数的减少可降低热轧板屈服强度，且满足供冷轧基料的要求。
The results show that these cracks are caused by the inclusions of rare earth sulphur oxides and alumina distributing in mass in base steel for hot rolled wide strips.
结果表明：管坯裂纹是因热轧宽钢带基材中存在大量聚集分布的稀土硫氧化物和氧化铝夹杂所致。
The causes of the head size over tolerance of large size hot rolled ribbed bars are analyzed. By improving the structure bearing bracket, this problem was resolved well.
分析了在横列式轧机轧制大规格热轧带肋钢筋时头部葫芦状尺寸超差的产生原因，通过改进轴承座结构，有效地解决了这一问题。
Effect of martensite volume fraction on deformation dislocation structure and fracture for hot rolled dual-phase steel of the same composition was studied by using SEM and TEM.
利用SEM、TEM研究了同一成分的热轧双相钢的马氏体体积分数对形变位错结构和断口组织特征的影响。
This paper introduces the contrast test of wear resistance of hot rolled low - carbon high strength bainite steel plate to ordinary steel plate on QLK800.32 bucket wheel reclaimer.
本文介绍了热轧低碳贝氏体高强钢板在qlk800.32型斗轮取料机上与普碳钢板进行耐磨性对比工业试验的情况。
The paper introduces the character of a number of control and combination mode of hot rolled strip profile in foreign country, and its configuration and application in Finish Mill.
对目前国外几种热轧带钢板形控制组合方式的特点及在精轧机上的配置和应用进行介绍。
Computer modeling of microstructural changes and the relationships between mechanical properties of hot rolled steel products has been under active development in the research community.
对热加工过程中微观组织变化的计算机模拟以及组织与力学性能关系进行的研究最近已成为本学科研究领域的热点之一。
Computer modeling of microstructural changes and the relationships between mechanical properties of hot rolled steel products has been under active development in the research community.
对热加工过程中微观组织变化的计算机模拟以及组织与力学性能关系进行的研究最近已成为本学科研究领域的热点之一。
应用推荐