The fan operates at a set speed until the inlet air temperature exceeds the lower set point (see Table 1).
如果环境空气温度不超过最低设置温度，风扇一直以设定温度转动(见表1)。
It is an adiabatic, humidification, and cooling process for gas turbine inlet air by water spray evaporative cooling.
对燃气轮机的进气采用喷雾蒸发冷却的方式降温是一个绝热加湿冷却过程。
The comparison among each cylinder's quantity of inlet air was made using the average value of the max pressure of each cycle.
通过比较各缸压力的最大平均值及其变动系数，分析了各缸的进气量差异。
Result: the damp proof effect enhanced with the increase of inlet air temperature and the decrease of flow rate and air pressure.
结果：微囊防潮效果随着进风温度的提高、供液速度的降低、雾化气流速的降低而增强；反之则减弱。
While the effect of engine speed on the required inlet air temperature for autoignition is different for different octane Numbers.
而发动机转速对自燃所需进气温度的影响则随所用燃料辛烷值的大小而异。
The cold energy of LNG can also be used to cool the inlet air of gas turbine to increase the output of electric power during warm seasons.
在高温季节，还可以利用LNG冷能冷却燃气轮机的进口空气，以增加电厂出力。
The objective is to evaluate various methods of cooling the inlet air. The comparison of technology & economy between them was also given.
介绍和讨论了燃气轮机进气冷却的各种方法，并对各种冷却方法进行了技术经济比较。
Vortexs are observed after the beams, which greatly influence the inlet air-flow of fan, reduces the air-flux, causes noise and wastes energy.
支承结构造成的流体绕流现象在风机进口处形成涡流，造成风机风量减少，噪声增加，浪费能源。
The simulated results showed that by preheating the inlet air, natural gas can realize the self-ignite in the separated chamber and burn quickly.
模拟计算结果表明，在采取进气预热措施后，天然气在分隔室燃烧室中可以可靠着火，并能迅速燃烧。
Via testing, the effect of condensing inlet air temperature on the refrigerating capacity of the self contained air conditioning set is researched.
通过试验，研究了冷凝进风温度对单元式空调机组制冷量的影响。
The utility model is equipped with a deodorizer on an ordinary water closet. The deodorizer comprises a blower, an inlet air duct and an outlet air duct;
本实用新型是在普通抽水马 桶上安装有除臭器，该除臭器包括风机、进气管道和出气管道；
The relations of thrust and specific impulse to inlet air flow and temperature are derived from theoretical analysis of solid fuel ramjet (SFRJ) performance.
在固体燃料冲压发动机性能分析基础上，推导了某发动机的推力和比冲与入口流量和温度之间的关系式。
This paper calculates the temperature of inlet air, and analyzes precedence of gas turbine inlet air-cooling by water spray evaporative cooling in Xinjiang area.
对进气空气的温度进行分析计算，并通过计算的结果分析在我国新疆地区燃气轮机采用喷雾蒸发冷却方式冷却进气空气的优越性。
The damper configuration on inlet air duct to coal mills in pressurized direct pulverizing coal systems is analyzed and the optimized design schemes are presented.
分析正压直吹式制粉系统磨煤机进口风道的风门配置，得出最优化风门配置方案。
Effects of inlet air flow and inlet feed concentration on enrichment rate were predicted by the model. The results had good agreement with the experiment observations.
模型预测了进料浓度和进气速度对富集比的影响，结果表明，模型预测结果和实验结果基本一致。
The experimental study was focused on the effects of inlet air temperature, inlet air flow rate and accelerating pipe length on ISCs volumetric evaporative coefficient.
实验主要研究了空气进口温度、空气进口流量、液滴加速管的长度对ISC容积蒸发系数的影响。
Results show that the flow resistance will be decreased and the collection efficiency of the porous solar wall will be increased with a decrease in the inlet air velocity.
计算结果表明，降低空气入口流速，可减小空气流动阻力，提高多孔墙的集热效率；附加玻璃通道的太阳能多孔墙可减小长波辐射损失，并且具有收集热空气的作用。
The system uses a vent fan, a manually adjustable backpressure damper, a differential pressure-sensing gage, and an inlet air filter high differential pressure alarm switch.
此系统用一个排气扇，手动调节反压闸，压差传感器和一个进气过滤器压差高报警开关。
The utility model discloses an auxiliary atomizing power increasing device for inlet air of an engine, which belongs to the improvement of an air intake system of an engine.
本实用新型公开了一种发动机进气辅助雾化动力增加装置，属于对发动机进气系统的改进。
Reliable and proven inlet air control valves and purge valves assure years of reliable shifting of towers and proper dryer operation (Lifetime Warranty) LF Series 25-620 CFM.
可靠的和经过验证的进气控制阀和清洗阀可靠保证年和适当的塔机操作(终身保修)LF系列25- 620立方英尺转移。
The paper analyzes the effect of geometrical parameter variations of helical port due to some tolerances in manufacturing, configuration on the inlet air flow characteristics.
本文分析了螺旋进气道在生产过程中的偏差而导致气道几何参数的变化对气道流动特性的影响。
Analysis showed that: inlet air injection technical solutions were adopted more easily without the need for damage of the turbocharger structure; it's more suitable for buses.
分析表明：进气道补气的技术方案改装方便，无需破坏涡轮增压器结构，更适合于公交车使用。
We will target the reasons for the low efficiency of low-pressure cylinder, Focus on the inlet air flow field and their organization's performance in this regard were analyzed.
在此主要针对低压缸效率偏低的原因，着重从低压进汽流场以及其气流组织的好坏这方面进行了分析。
As the shut-off valve is seated, a passage 41 in its stem connects with ports 42 in the guide bushing 37 so as to allow inlet air to pass though the valve stem to a housing port 44.
在关闭阀是坐在座位上，一个通过41个在其干连接与港口42轴套在指南37，使空气入口，虽然通过的阀干，一个住房端口44。
The performance and cost-effectiveness of different inlet air cooling systems is compared and analyzed, which have been installed on machine units in Beijing, Harbin, Shanghai and Guangzhou.
不同的进气冷却系统的性能和成本效益进行比较和分析，在北京，哈尔滨，上海，广州已安装在机组。
With the increase of inlet air temperature of the condenser, evaporation pressure, condensation pressure increase, but supercooling and superheat degree, refrigerating capacity and COP decrease.
随着冷凝器进口空气温度的升高，蒸发压力、冷凝压力升高，而过冷度、过热度、制冷量和COP均线性下降；
The results show that all kinds of inlet air cooling technology for gas-turbine may improve its output and efficiency, but it is necessary to combine with the concrete conditions to select the...
结果表明，不论采用何种进气冷却技术都可以有效地提高燃气轮机的出力和效率，但对于不同地区、不同运行条件的燃气轮机，应根据实际条件选择进气冷却方式。
Through experiments of changing the inlet air flow rate, we can adjust the hot air outlet temperature as high as possible, which helps to reduce the heat loss and improve the collector efficiency.
通过改变集热管进口空气流量来获得尽可能高出口温度的热空气，从而降低热损系数，提高集热效率。
Some parameters, such as the inlet air humidity and temperature, the regeneration temperature, the air mass flow rate, which may affect the performance of the desiccant wheels, were also analyzed.
实验研究发现在相同工况下，氯化锂转轮的显热效率、潜热效率均高于硅胶转轮。运行参数中再生温度、处理空气进口湿度对转轮除湿性能影响比较大。
Some parameters, such as the inlet air humidity and temperature, the regeneration temperature, the air mass flow rate, which may affect the performance of the desiccant wheels, were also analyzed.
实验研究发现在相同工况下，氯化锂转轮的显热效率、潜热效率均高于硅胶转轮。运行参数中再生温度、处理空气进口湿度对转轮除湿性能影响比较大。
应用推荐