Insulation transformer output current and input current completely separated.
使输出电流与输入电流完全分离。
With voltage measurements, the input current is ideally zero; thus, any input current represents an error.
对电压测量来说，理想的输入电流应为零，所以，一切输入电流都代表误差。
Themeasured input current THD is 4.26%. Power Factor attains 0.998. Theprototype realizes the expectation.
该样机在实验中测得输入电流总谐波畸变率（THD）为4.26%，功率因数为0.998，达到了预期的设计效果。
It is found that the input current produces distortion even if the three-phase input voltages are balanced.
也发现即使三相输入电压平衡，输入电流也存在失真现象。
Continuous input current is ensured, which mitigates the impact on DC source and improves DC voltage utilization.
同时该拓扑还保证了输入电流连续，减小了对直流源使用寿命的影响，提高了直流侧电压利用率。
One of the problems of the most diode rectifiers is that they include large harmonic contents in its input current.
输入电流谐波含量高是多脉波二极管整流电路的一大缺点。
The harmonic characteristic of input current in single-phase voltage source PWM converter is analyzed theoretically.
从理论上分析了单相电压源pwm变流器输入电流的谐波特性。
When electric power coupling transformer at input current is less than rated value, public winding can be also overload.
电力自耦变压器在其输入电流均小于额定值时，其公共绕组也可能过负荷。
Thus, the output voltage is a measure of input current, and overall sensitivity is determined by the feedback resistor RF).
所以输出电压可以用来度量输入电流，总的灵敏度由反馈电阻器（RF）决定。
The paper gives two kinds of approaches to measure the ripple current in input current of DC-DC converter or DC-AC inverter.
文中叙述了直流—直流变换器或直流—交流逆变器输入电流中纹波电流的二种测量方法。
This thesis illustrates the theory in how interleaving technology solves the problem of input current zero-crossing distortion.
本文对交错技术解决输入电流过零畸变的原理进行了说明。
As the heart of the power factor correction circuit, the gain modulator gets a high power factor by controlling the input current.
增益调制器作为功率因数校正电路的核心电路，通过控制输入电流来得到一个高的功率因数。
The major shortcomings of CMOS Digital Integrated Circuit concentrate on two primary parameters: input current and supply current.
CMOS数字集成电路的各种缺陷集中地反映在输入电流和电源电流这两个参数上。
Power Factor Correction (PFC) technique make input current waves sine, improve efficiency of the system and reduce harmonic waves.
功率因数校正技术对输入电流进行校正，提高设备利用率，减少谐波对电网的污染。
The temperature is higher, the change of input current I_F according to the same change in value of the base-emitter voltage V_ (BE) is smaller.
温度越高，发射结正向压降v _ (BE)变化相同数值所对应的输入电流i_f的变化越小。
In order to study the strategy of input current modulation, the simulation model of matrix converter under unbalanced input is built with MATLAB.
通过参数设定、输入电压相位计算、控制算法实现和开关接口等环节设计，实现了输入电流偏置角动态调整的控制策略。
This paper describes a new method used for controlling convert power supply, which can make the input current to be sinus waveform, and the power factor to be 1.
提出一种新的整流电源控制策略，它可以使整流电源工作时，从电网输入的电流近似为正弦波，功率因素接近1。
In the second one, the input current displacement Angle is dynamically modulated as a function of positive-and negative-sequence components of the input voltages.
第二种控制策略中，输入电流矢量根据输入电压正、负序成分进行动态调制。
The effects of actuating frequency, proportional valve input voltage and MR damper input current on the vibration characteristics of seat were experimentally studied.
试验研究了激励频率、比例阀输入电压及磁流变减振器输入电流对座椅振动特性的影响规律。
This thesis analyzes the zero-crossing distortion, and points out that the major causes are the inductor and the phase displacement between the input current and the input voltage.
本文对产生输入电流过零畸变的各种原因进行了定量分析，指出电感和输入电流与输入电压间的相位差是影响高频输入下输入电流过零畸变严重的根本原因。
To reduce the inductor and the phase displacement between the input current and the input voltage simultaneously, Multi-level (ML) converters are adopted as the PFC topologies in this thesis.
为了同时减小电感和输入电流与输入电压间的相位差，本文提出采用多电平变换器作为PFC变换器的拓扑。
Simulation and experimental results show that the proposed converter has sine wave input current and output voltage, low harmonic content, adjustable power factor, and zero voltage commutation.
仿真和实验结果表明：所提出的变换器输入电流和输出电压为正弦，谐波小且输入功率因数可控，并可实现零电压换流。
The simulation and experimental results show that this system can restrain harmonics of three-phase rectifier of AC-side input current, reduce the output voltage ripple and decrease the volume.
仿真和实验结果表明该系统能够有效抑制三相整流电路交流侧输入电流的谐波，降低输出电压纹波，减小整机体积。
In hydraulic synchronizing lifting technology for oversize structure, computer output PWM signal as the input current of proportional valve is used to control the velocity of hydraulic cylinder.
在大型构件液压同步提升技术中，采用了计算机输出的脉宽调制信号作为电液比例流量阀的输入电流信号控制液压提升器的速度。
Experiment result showed, the topology can make the device get to high Power Factor (PF), low Total Harmonic Distortion (THD) of input current, low ripple of output voltage, and high efficiency.
实验结果表明，应用该电路拓扑的实验装置，其功率因数较高，输入电流的总谐波畸变较低，输出电压纹波小，而且整个装置的效率也比较高。
Simulation results demonstrate: the chaotic modulation signals generated from the four kinds of chaotic sources can all reduce the peak level of the input current and the output voltage spectrums.
仿真结果表明：四种混沌源调制生成的混沌开关调制信号，均能够降低电源的输入电流及输出电压的频谱峰值。
Simulation results demonstrate: the chaotic modulation signals generated from the four kinds of chaotic sources can all reduce the peak level of the input current and the output voltage spectrums.
仿真结果表明：四种混沌源调制生成的混沌开关调制信号，均能够降低电源的输入电流及输出电压的频谱峰值。
应用推荐