The increased metabolic cost of possessing higher body mass contributes to the increased overnight mass loss.
更大的体重意味着代谢成本增加,导致了夜间体重损失增加。
The mathematical model can be used to predict the variations of temperature and mass loss for understanding the mechanism of vacuum cooling.
数学模型可以准确预测真空冷却过程中的温度变化和质量损失,将有助于进一步理解和研究真空冷却机理。
On an equal footing, the average bone mass loss of man is bigger than that of woman.
在同等条件下男性平均骨量丢失的程度大于女性。
Mathematical models based on the mineralization mechanism were built for the mass loss and carbon loss.
建立了符合土壤有机质分解机制的重量损失和碳损失的数学模型。
In addition, mass loss rate was not the only parameter influencing heat release rate in cone calorimeter for agaric.
同时,木耳的质量损失速率不是影响其热释放速率的惟一因素。
The method for measurement of reduction degree in iron ore—coal pellet by mass loss during fast heating is described.
提出了用失重法测试快速加热时铁矿—煤球团还原度的方法。
The results show that the mass loss rate increases with increasing the vacuum thermal cycles, and becomes flat after 48 cycles;
试验结果表明,随真空热循环次数的增加,质损率增大,并经约48次真空热循环后趋于平缓;
The varying tendencies of mass loss rate, temperatures of each point, and CO concentration were all consistent with heat release rate.
质量损失速率、各点温度以及产物一氧化碳浓度变化曲线均与热释放速率曲线的变化趋势保持一致。
The experimental results show that with increasing duration of exposure to a corrosive environment, the steel mass loss increases appreciably.
实验结果表明:随着在腐蚀环境暴露时间的增加,钢筋的质量损失加剧。
The mass loss of ablative material caused by physical, chemical and mechanical factors under high temperature affects properties of the material.
烧蚀材料在高温环境中因物理、化学和力学因素造成质量损失,影响其性能。
Based on these, the mass loss rate, coherent length and pumping mechanism have been discussed and the results agree with the observations very well.
并讨论了质量流失、相干长度和抽运机制等问题,结论与观测符合。
The variation of the mass loss, packing density, surface area, distribution of pore diameter, amount of ash with the cyclical Numbers were researched.
考察了活性炭的失重率、堆密度、比表面、孔径分布及灰分含量随活化次数的增加而变化的情况。
The mass loss after impact-wearing was measured, the morphology on the wear surface of the steel was analyzed by SEM, the microstructure was observed by OM.
对冲击磨损试验后试样进行了失重测量,并用SEM分析磨损表面形貌,用OM观察金相组织。
The uncertainties associated with current stellar models lie in the input physics: atomicdata, convection theory, mixing in radiative regions, and mass loss.
当前恒星模型中的不确定性来自于输入的物理参数:原子数据、对流理论、辐射区的混合和质量丢失。
The reduced concentration of E2 in serum could induce the increase of MMP-8 in serum, strengthen the catabolism of bone and cause the bone mass loss at last.
雌激素水平下降,导致MMP-8升高,骨分解代谢增强,是过度训练导致低骨量的原因。
The spectral slopes, infrared luminosities and mass loss rates of central stars, as well as the mass loss times from infrared or radio radiation are calculated.
计算了光谱斜率和红外光度,同时从红外及射电幅射得出了中心星质量损失率及质量损失历经时间。
The increase in the fluctuation intensity of gas temperature will further enhance the instantaneous particle mass loss during the coal devolatilization processes.
随着气相温度脉动强度的增加,这种加快颗粒瞬时质量下降即挥发分释放的趋势更为明显。
The inhibitive action of isopropyl amine, n-butyl amine and n-octyl amine on aluminium corrosion in hydrochloric acid solutions was studied using mass loss technique.
采用失重法研究了异丙胺、正丁胺、正辛胺在盐酸介质中对铝的缓蚀性能,发现正辛胺是一种较好的缓蚀剂。
The wear mass loss is high when the abrasive medium has high hardness, multilayer coating shows better wear properties than single-layer coating in the effect of biggish load.
磨料的硬度较高时,涂层的磨损质量损失较大,与单层涂层相比,多层涂层在较高载荷作用下具有较好的抗磨损性能。
Polarization curve and neutral atmosphere salt corrosion test showed that the corrosion resistant property of BT20 Ti alloy is excellent, and mass loss of both is not obvious.
极化曲线和中性盐雾腐蚀实验表明:钛合金耐腐蚀性能良好,腐蚀失重不明显。
The electrochemical corrosion behavior of plain carbon steel in two-phase medium with coal and water was studied with mass loss measurements and electrochemical polarization tests.
采用失重及电化学方法研究了碳钢在煤水两相介质中的腐蚀行为。
For external radiation ignition manner, a series of small-scale fire tests were conducted in a cone calorimeter in accordance with ISO 5660. Heat release rate and mass loss rate were measured.
外部辐射着火的方式采用符合ISO 5660标准的小型锥形量热计来实现,测量其热释放速率及质量损失速率。
The effect of pyrolytic temperature on the microstructure changes, mass loss and H/C ratio of polyarylacetylene was studied by thermal gravity analysis, element analysis and X ray diffraction.
根据热失重曲线、元素分析和X射线衍射分析了芳基乙炔聚合物炭化过程中的结构变化。
Observational evidence for stellar winds obtained from radio, infrared, visible, UV and X-ray regions are given. And two important parameters, terminal velocity and mass loss rate, are discussed.
在观测方面,给出了从射电、红外,可见光、紫外和X射线各波段得到的观测证据,并介绍了星风的两个重要参数、星风的终速和质量损失率。
It can evaluate the mass loss caused by evaporation in vacuum, obtain a saturated vapor pressure-temperature equation, and provide a means to verify saturated vapor pressure at normal temperature.
为预测其在真空下长期使用中的蒸发损失量,以及验证在常温下的饱和蒸气压指标提供了一种方法。
The correlativity between neutral salt spray accelerated test and atmospheric corrosion test in Shijiazhuang was studied by the mass loss determination of 45 steel, A3 steel, 20 steel and gun steel.
以45钢、A3钢、炮钢、20钢为金属试样,研究它们在中性盐雾加速试验及石家庄大气环境暴露试验中腐蚀失重与时间的变化规律。
The correlativity between neutral salt spray accelerated test and atmospheric corrosion test in Shijiazhuang was studied by the mass loss determination of 45 steel, A3 steel, 20 steel and gun steel.
以45钢、A3钢、炮钢、20钢为金属试样,研究它们在中性盐雾加速试验及石家庄大气环境暴露试验中腐蚀失重与时间的变化规律。
应用推荐