The mixing time prolonged by introducing a draft tube.
增加导流筒可以使液相混合时间延长。
The liquid mixing time is of importance for the agitation process.
液相混合时间是搅拌过程的重要内容。
The factors affecting the mixing time and segregating index were analyzed.
分析了影响混合时间和分隔指数的主要因素；
Mixing time was an important parameter which describes mixing conditions in stirred tank.
混合时间是表征搅拌槽内流体混合状况的重要参数之一。
The relationship between mixing time and buoyant stirring energy density is also obtained.
并得到熔池混匀时间与浮力搅拌功率密度的关系。
If emulsifier is not used in cake production, the mixing time needed is about 20-25 minutes.
制造蛋糕时如未加乳化起泡剂，搅拌时间约需20 ~ 25分钟。
It has more advantages, such as: small size, fast mixing time, good effect to stir and so on.
具有体积小，混合时间快、搅拌效果好等优点。
The information on top, bottom and top-bottom mixed blowing with regard to the mixing time are given.
文中给出了有关纯顶吹、纯底吹和顶底复合吹的有关搅拌情况。
The observed parameters of the experiments are the mixing time and the remove ratio of the inclusion.
实验考察指标为混匀时间和夹杂物的去除率。
The observed parameters of the experiments are the mixing time and the angle of gas-liquid phase region.
实验考察指标为混匀时间和气液两相区夹角。
In the double logarithm coordinate, the relation between the mixing time and the power consumption is linear.
转速升高，混合时间缩短，混合时间与功率消耗在双对数坐标系下呈线性关系。
Concrete mixing time should be in line with "concrete structural engineering and construction inspection norms".
混凝土搅拌的时间应符合《混凝土结构工程施工及验收规范》的规定。
The results show that bleeding quality and consolidation strength are a function of mixing time and rotational ratio.
结果表明水泥浆液的泛浆性能和结石体强度是搅拌时间和速率的函数。
It has been found, that the mixing time mainly depends upon the mechanic power brought into the bath by the blowing gas.
研究中发现，熔池混合均匀时间主要和随气体输入的机械功率有关。
The yellow index of blends at different mixing time and thermal aging time increased obviously than that of pure polymer.
在不同混炼时间及热老化时间下，共混物的黄度指数相对纯聚合物有明显提高。
This product is evenly mixed with water directly, no particles, into a paint-like, mixing time is greater than 5 minutes.
本品直接加水搅拌均匀，无颗粒，成涂料状，搅拌时间大于5分钟。
The result shows that the effect of top blowing oxygen jet on the mixing time and circulation flow rate can be disregarded.
结果表明，顶吹氧射流对钢包混匀时间和循环流量的作用可以忽略。
This machine has many advantages, such as constant operation, low noise, high loading coefficient and short mixing time etc.
该机还具有运转平稳、噪音低、装载系数高、混合时间短等优点。
Properties and morphology of thermites mixed up by twin-screw and ball milling procedures are investigated with different mixing time.
采用双螺旋和球磨两种混料方式，研究不同混料时间对（铝）热剂性能及颗粒微现形态的影响。
The mixing time predicted by CFD for the single DT-6, CBY impeller and multiple CBY impellers was in good agreement with the experiment.
对于单层桨体系，不论是DT-6桨还是CBY桨，其混合时间的模拟值均与实验结果吻合良好；
It is pointed out that the ratio of macromixing time to total mixing time increases with the increase in power consumption by calculation.
计算表明，宏观混合时间与整个过程的混合时间的比例，随单位体积功耗的增大而增大。
The influences of nozzle design and position of injection lance on the mixing time of hot metal in the ladle were experimentally investigated.
通过实验考察了喷枪喷嘴结构不同和喷枪平面位置不同条件下吹气对熔池搅拌的影响；
The results of experiment showed that:the most affect factor was reaction temperature, core-wall ratio following, mixing time was the least one.
实验结果表明：反应温度对微胶囊气体二氧化氯释放速率影响最大，芯壁比次之，搅拌时间影响最小。
Mixing time was prolonged and the effect of Ug extended in a larger range and showed extremum points when cross heat exchange tube was introduced.
引入横向换热管后，混合间延长，且表观气速的影响范围变大，表观气速对混合时间的影响不是单调关系，存在极值点。
A special mixing device was developed by improving the traditional rotation mixer, the best mixing time was shorten, and the homogeneity was improved.
首次利用转鼓式混合机原理设计的真空后喷涂抛散混合机构可以缩短其最佳混合时间，提高了混合均匀性。
The results showed that the range of the region of phase co-continuity PS/PA6 was 40/60-65/35 at experimental temperature, rotor speed or mixing time;
结果表明在一定螺杆转速、共混温度、共混时间范围内，PS/PA6共混物形成双连续相组分的比例范围为40/60—65/35；
Mechanically agitated reactors are widely used in many industrial processes. Mixing time is one of the key parameters to the design of stirred reactors.
搅拌槽反应器广泛应用于许多工业过程，混合时间是搅拌反应器设计的重要参数。
This Mixer has the following distinguishing features. No blind Angle in the cylinders, no accumulation of materials. High speed, and short mixing mixing time.
本机具有筒体无死角，不积料，速度快，混合时间短的特点。
Increase of carrier addition will result in the decreased oxygen transfer efficiency, shortened recycle time, mixing time as well as the decrease of air content.
载体加入量增加，会导致氧传递性能下降，循环时间和混合时间缩短，气含率减小。
Increase of carrier addition will result in the decreased oxygen transfer efficiency, shortened recycle time, mixing time as well as the decrease of air content.
载体加入量增加，会导致氧传递性能下降，循环时间和混合时间缩短，气含率减小。
应用推荐