You just built multiple SSL Web sites on the same server and on the same physical network card.
我们已经在同一台服务器、同一块物理网卡上构建了多个SSLWeb站点。
Therefore, you won't be using Dynamic Host Configuration Protocol (DHCP) to setup the network card.
因此，您不能使用动态主机配置协议(Dynamic Host Configuration Protocol,DHCP)来设置网卡。
Set the IP address and physical network card interface ID for the zone created as shown in Figure 7.
为创建的专区设置IP地址和物理网卡接口id，如图7所示。
rc.modules Loads kernel modules. Things like your network card, PPP support, and other things are loaded here.
加载内核模块，比如你的网卡，PPP支持和其他类似设备都在这里载入。
You may find that when the system comes back up, your network card no longer works, or the display is confused.
当系统从休眠状态醒来后，您可能发现您的网卡不能正常工作，或者显示器显示不正常。
The network card listens for a specific packet, called the "Magic Packet".
网卡侦听特定的数据包，被称为“魔术包” 。
This can occur when you move a network card from one PCI slot to another PCI slot.
当您将网卡从一个PCI插槽移到另一个PCI插槽时，可能会出现此问题。
Choose this option if you are not sure what network card is currently installed in the computer.
如果无法确定计算机内当前安装了何种网卡，请选中该选项。
You need to provide the drivers needed for the network card in the computer that you are setting up.
需要为正在安装的计算机的网卡提供驱动程序。
Setup has detected existing network card drivers that may conflict with the new network configuration.
安装程序检测到已有的网卡驱动程序可能和新的网络配置冲突。
Choose this option if you know the name of the network card, or if the network card could not be detected.
如果知道网卡的名称或无法检测到网卡，请选中该选项。
A bad network card, hard drive, or memory might result in your system spending a long time waiting for information.
不能正常工作的网卡、硬盘或内存，都可能导致系统花费很长的时间等待信息。
In this paper, we introduce the makeup, operating principle and the realization of the dual-redundance network card.
本文介绍了一种双冗余网卡的组成及工作原理，同时介绍了网卡冗余的实现过程。
The receiving and transmission of network frames are implemented through the ISA bus between MCU and the network card.
该系统以TCP/IP协议为基础，单片机通过ISA总线与网卡通信来实现网络数据包的收发。
Based on this, the design of embed network card hardware platform and the software method of exploitation are introduced.
在此基础上介绍嵌入式网卡硬件平台的设计及软件开发方法。
This is done (a little simplified) by using the worldwide unique id of the network card, combined with the current date and time.
这是通过(简单来说)使用全球唯一的网卡id和当前时间和日期结合来生成的。
Network communicating module includes network card initialization sub-module, data sending sub-module and data receiving sub-module.
网络通讯模块包含了网卡初始化子模块、数据发送子模块和数据接收子模块。
So we design a net transmission system based on DSP and network card. We present the whole circuit design and corresponding software.
因此基于DSP和网卡设计了一个网络传输系统，给出了系统整体电路设计和相应的软件程序。
The set up computer Wizard will automatically detect the network card in the computer you are setting up and install the correct driver.
安装计算机向导会自动检测正在安装的计算机中的网卡，并安装正确的驱动程序。
Compressed data can be delivered through network card and other devices, so that can realize the distant communication of multimedia data.
系统通过网卡等入网设备可以将压缩后的数据在网络上传送，从而实现多媒体数据的远程通信。
This detail level includes generic counters (including processor, disk, memory, and more) and specific counters (including network card interfaces).
该详细级别包括一般的计数器(包括处理器、磁盘、内存，等等)和具体的计数器(包括网卡接口)。
Clients without a CD-ROM drive but with a Linux-supported bootable network card, for example, can boot remotely from a Knoppix-running server by means of PXE.
例如，不带CD - ROM驱动器，但是带有支持Linux的可引导网卡的客户机可以通过PXE从正在运行Knoppix的服务器进行远程引导。
The first subject is network card driver, which gives an introduction the structure and function of NE2000 network card and discusses design of netcards'driver.
第一个专题是网卡驱动，主要讲述NE2000网卡的硬件特性与具体的软件驱动程序设计。
If you select the driver for the network card, you will need either a floppy disk with the driver file, or access to the computer where the driver file is located.
如果要为网卡选择驱动程序，则需要提供存有驱动程序文件的软盘，或者访问存有驱动程序文件的计算机。
NIC device driver controls the process of network card, and at the same time the device driver provides some application programming interfaces (APIs) for high layers.
网卡驱动程序控制着网卡的通信过程，并为上层程序提供应用编程接口(API)。
If it isn't, there may be a problem with the physical connection from the network adapter on your host to the gateway (for example, a faulty switch port, cable, network card).
如果无法到达这个网关，那么从您主机上的网络适配器到网关的物理连接可能有问题（例如交换机端口、线路和网卡有故障）。
Therefore, it is important to know the difference between turning off a network card on a short-term basis with the ifconfig command versus dropping it with the chdev command.
因此，一定要了解用ifconfig命令短期关闭网卡与用chdev命令删除网卡之间的差异。
The network device must be configured to use TCP/IP and the IP address for the network card must be obtained through a DHCP server or you must assign a static IP address.
网络设备必须配置成使用TCP/IP而且网络卡的IP地址必须经由DHCP服务器获得。 如若不然，则必须分配静态IP 地址。
Rc.pcmcia Probes for and configures any pcmcia devices that you might have on your system. This is most useful for laptop users, who probably have a pcmcia modem or network card.
探查并配置所有你系统里存在的PCMCIA设备，这对那些拥有PCMCIA调制解调器(modem)或网卡的笔记本用户来说是很有用的。
The network transmit program in user's tasks of the system is based on UDP. It includes network card driving function, protocol layer handling function and user interface function.
系统中用户任务的网络传输程序是基于UDP编写的，它包括了网卡驱动函数，协议层操作函数和用户接口函数。
应用推荐