His other trick is to boost the output power of the lasing material, neodymium-doped yttrium aluminium garnet.
他所采用的另一个诀窍就是提高激光物质，掺钕的钇铝石榴石的输出功率。
Fujitsu points out that using GaN HEMT technology allows more than 6 times the output power of existing amplifiers using gallium-arsenide (GaAs) transistors.
富士通公司指出使用氮化镓高电子迁移率晶体管技术后，新型放大器功率比目前使用砷化镓晶体管的放大器的功率提高了6倍多。
The success of technical modification made a remarkable increase of boiler output power and stability.
锅炉技改方案的成功实施使锅炉出力和运行稳定性得到显著提高。
The experimental results show that this circuit is effective in optical output power adjustment and stabilization.
实验结果表明，该电路对调节和稳定光输出功率非常有效。
For a certain resonator, it is necessary to find out the optimum position of the laser rod to achieve maximum output power.
对于给定的腔型，为获得最大的稳定激光输出，必须选择最佳的激光棒位置。
Openframe power, for 37-42 inch LCD TV, output power are 260W.
内置电源，适用于37“-42”寸液晶电视，输出功率260W。
The peak output power of laser diodes using this material is up to 15 W.
利用该材料制作的激光二极管，其峰值输出功率达到15W。
The cause of output power unbalance between paralleled inverters is analyzed.
分析了逆变器并联时，各模块输出功率不平衡的原因。
This method suits for pumping the fiber laser and amplifier of several watts output power.
该方法适用于输出功率为数瓦的光纤激光器和放大器的侧面抽运。
The steady power circuit of laser diode is designed in order to stabilize the output power.
为了使半导体激光二极管输出激光功率稳定，设计了激光二极管稳功率电路。
The output power of this He-Ne laser can be enhanced by increasing its transverse dimension.
对这种氦氖激光器，可利用增加其横向尺寸来提高输出功率。
Longer duty cycle for the same output power results in lower peak currents on the primary side.
更大的占空比实现同样的输出功率可以使用更低的一次侧峰值电流。
The main function of the power amplifier is to get the highest output power at high efficiency.
功率放大器的主要目的是以高效率得到大的输出功率。
In the condition of two-channel, when input pulses overlap, the output power and gain become steeper.
在双信道情况下，输入脉冲重叠时的输出功率和增益变得更陡峭。
Inhomogeneous distribution of radial temperature is major factor resulted in output power restriction.
指出径向温度分布不均匀是导致输出功率受限的主要原因。
Overmodulation may be employed in the optical transmitter to increase the output power of laser diode.
在光发送机中采用过调制技术来提高激光器的输出光功率；
Whether the main engine runs on the proper fuel oil will directly decide its operation and output power.
主机使用的燃油是否合适将直接决定机器的运行和输出功率。
Load matching is intended to make induction heating power to the rated output power, and improve efficiency.
负载阻抗匹配的目的是为了使感应加热电源能够输出额定功率、提高效率。
Deep research on how to improve the efficiency and output power and to reduce the focusing magnetic of RBWO.
对如何提高RBWO输出功率和效率、降低聚焦磁场的方法作了较为深入的探讨。
The calculated results show that its effects on the average laser output power and beam quality are noticeable.
计算结果表明，这种热效应对激光输出平均功率与光束特性有不可忽视的影响。
We design a set of computer aided test system for measuring the output power of the tractor motive power shaft.
为了测量拖拉机动力输出轴的输出功率，设计了一套计算机辅助测试系统。
All of them have been operation at 300 kHz, bus voltage of 400 V, output power of 120 W, output voltage of 16 V.
它们都工作在300千赫兹，直流母线电压400伏特，输出功率120瓦特，输出电压16伏特。
The coupling efficiency of the amplifier and the factors affecting the output power improvement are investigated.
研究光纤放大器的耦合效率以及影响输出功率的因素。
It was also found that we could enhance the LED output power by using lateral epitaxial patterned sapphire (LEPS).
也发现借由条状蓝宝石基板横向磊晶法(LEPS)，可以提升发光二极体的输出功率。
Use of Rare earth NdFeB permanent magnet, high efficiency and light weight, low energy consumption, high output power.
磁铁使用稀土钕铁硼永久磁铁，效率高且自重轻，耗能少，输出功率大。
The changes of the step amplitude in non-linear dual step circuits are emphasized which affect saturated output power.
重点研究了非线性双跳变电路中跳变幅度的变化对饱和输出功率的影响。
The use of two-rod or multi-rod connection technology can effectively improve the solid-state lasers output power (energy).
而利用双棒或多棒串接技术能有效地提高固体激光器的输出功率(能量)。
We calculated longitudinal confinement factor, threshold gain, optical gain and output power etc through theoretical model.
根据理论模型计算了纵模限制因子、阈值增益、光增益、输出功率等特征参数。
The upper frequency limit and some factors affecting noise output power of microwave solid state noise diodes are discussed.
讨论了微波固体噪声二极管使用频率的上限和影响噪声输出功率的因素。
A solid state laser operated at lower-order mixed mode possesses both advantages of high output power and good beam quality.
当固体激光器运转在低阶混合模时，既可得到较高的功率输出，又可保证较好的光束质量。
应用推荐