Power control mode of on-off heating and its characters are analyzed.
分析了开关式加热的能量控制方式与特点。
Power control is one of the key technologies for CDMA cellular mobile systems.
功率控制是CD MA蜂窝移动通信系统的关键技术之一。
Power control technique is a key technique of CDMA mobile communication systems.
功率控制技术是CD MA移动通信系统的关键技术之一。
The design and implementation of uplink power control module in RNC is proposed.
给出了RNC中上行链路功率控制模块的设计方案并予以实现。
An expert system of voltage and reactive power control for substation is presented.
提出了一个变电站电压无功综合控制专家系统。
The Mooney viscosity fluctuation of mix can be decreased by using instantaneous power control.
采用瞬时功率控制可减小混炼胶的门尼粘度波动。
An algorithm for voltage and reactive power control device based on expert system is proposed.
提出了一种基于专家系统的变电站电压无功控制装置设计方案。
The keystone is pulse power control components developed independently and software based on IPC.
着重点在自主开发的脉冲电源控制部件和基于IPC的软件上。
All of these have relied on phase controlled thyristors (PCT), offering the higher power control.
所有这些都依赖于能提供更大功率控制的相控晶闸管(PCT)。
This paper studies the problem of optimal power control of transmitters in cellular radio systems.
本文研究了移动通信系统中的功率最优控制问题。
The active power control is of great importance for the safe and stable operation of power systems.
电力系统的有功功率控制对于电力系统的安全稳定运行具有重要的意义。
The system is composed of single loop controller, programmable controller and power control module.
该系统由单回程调节器、可编程控制器与功率控制模块组成。
An interface power control strategy based on power flow tracing and generator re-dispatch is presented.
给出一种基于潮流追踪和发电机再调度的割集断面潮流控制方法。
The results show that the continuous power control mode in drying cocoon by microwave is more efficient.
结果发现，采用连续式的功率控制方式对于微波烘茧有较好的效果。
High frequency pulse width modulation power control systems can be realized using semiconductor switches.
高频脉冲宽度调制电力控制系统，可以实现用半导体开关。
The paper describes briefly interference of cellular communication systems and its related power control method.
文中简述移动通信系统的干扰和与之相关的功率控制方法。
In LTE Uplink, further optimization of the system performance can be done via closed loop power control commands.
在LTE上行链路，通过完成闭环功率控制命令对系统的性能进一步优化。
The APC (Automatic Power Control) of semiconductor lasers is an important issue in the practical fiber communication.
半导体激光器的自动功率控制(APC)是光纤通信实用化过程中提出来的重要课题之一。
After you set the BMC address on a node, you have remote power control, which makes life easier when configuring the cluster.
在节点上设置了BMC地址之后，就可以进行远程电源控制，这样的话就可以更加轻松地配置集群了。
The main problem in the existing system is that maximum power control is separate from charging and discharging control.
上述系统主要的问题是缺乏最大功率跟踪控制和蓄电池充放电控制的统一考虑。
Discussing the necessary of laser power control in cutting processing. Giving out a method to realize laser power controlling.
讨论了激光功率控制的必要性，给出了激光功率控制的原理以及一种实现方法。
Secondly, the instantaneous reactive power theory and it 's application to reactive power control and detection are introduced.
其次，论文还介绍了瞬时无功功率理论及其在无功控制和无功检测方面的应用。
Auto power control, frequency auto-adjustment and load balance make it more flexible and stable to establish large scale network.
自动电源控制，频率自动调整负载平衡，使其更为灵活和稳定，建立大规模的网络。
One embodiment provides additional value to a power control unit (PCU) to make appropriate power decisions using existing designs.
一个实施例向功率控制单元(PCU)提供了额外的值用以使用现有设计做出适当的功率决定。
In the design of cellular radio systems, power control methods based on signal-to-interference ratio (SIR) measurement have been used widely.
在蜂窝无线通信系统设计中，基于信号干扰比(SIR)测量的功率控制方法得到广泛的应用。
Aiming at the problems existing in present voltage and reactive power control device of substation, puts forward a reactive power control project.
针对现有变电站电压、无功控制装置存在的问题，提出了一种电压无功控制方案。
If you have no hardware power control (no BMC IP address is set), start by flashing the BMC firmware, which enables you to set the IP address at the same time.
如果没有硬件电源控制(没有设置BMCIP地址)，请先从刷新BM c固件开始，使您能够同时设置IP地址。
Main circuit configuration and integrated voltage-reactive power control scheme for balancing compensation with cascade inverters based STATCOM is proposed.
给出了采用链式STATCOM实现平衡化补偿的主电路结构及电压-无功综合控制方法。
Main circuit configuration and integrated voltage-reactive power control scheme for balancing compensation with cascade inverters based STATCOM is proposed.
给出了采用链式STATCOM实现平衡化补偿的主电路结构及电压-无功综合控制方法。
应用推荐