It is shown that the electrostatic filtration fabric has high purifying efficiency and low pressure loss.
测试结果表明,荷电纤维滤料具有低阻高效性能。
Due to its inherent characteristics in reducing low frequency, small pressure loss and simple geometry, the resonant silencer is being extensively used in engine induction noise reduction.
由于共振式消声器具有结构简单、良好的消除低频噪声的性能和流动损失小等优点,因此在发动机进气噪声的控制中得到了广泛的应用。
The introduction of ultrasonic vibration reduces the metal flow resistance and fluid pressure loss, raises the flow speed, raises the welding quality and facilitates welding of thick plates.
超声振动的引入降低金属流动阻力和流体压力的沿程损失,提高流动速度,提高了焊缝质量,也可有效解决厚板焊接困难。
And blowers are chosen according to calculation of air volume and total pressure loss.
风机根据计算空气量和总压力损失的数值进行选择。
With the help of simulation results, the reason of pressure loss was discussed briefly.
并结合流场分析结果,初步探讨了引起压力损失的原因。
In order to reduce the power consumption flow meters with low pressure loss should be used.
按照降低能耗的要求,应选用压损小的流量计。
Local optimal method is used in the design of hole connection to reduce pressure loss of the system.
在孔道连通设计中,还采用了局部优化的方法以减少系统的压力损失。
Such cyclone gives advantages as: high separation precision, low pressure loss, and large throughput.
该旋流器具有分选精度高、压力损失低、处理能力大等优点。
The pressure drop model is discussed, and the pressure loss for single perforation section is calculated.
在给定条件下对压力降模型进行了讨论,计算了单个孔眼段的压力损失。
Criterion for gas flow pressure loss is presented for rotating liquid film heat and mass transfer device.
提出了旋转液膜气液传热传质设备的气体压力损失的准则关系式。
Based on the hydrodynamics theory, the pressure loss of the liquid within a pipe of spray boom was analyzed.
运用流体力学理论,对喷雾机喷杆压力损失进行了分析。
The pressure loss caused the increase in exhaust back pressure, leading to the decrease in charge efficiency.
压力损失使发动机的排气背压升高,引起充气效率下降;
Through analysis and calculation I find the pressure loss of the compressed gas in the pipelines is more obvious.
通过分析和计算发现,管道内压缩气体的压力损失比较明显。
At the same time, the average heat exchange coefficient and the pressure loss of the cold plate have been tested.
同时对冷板的散热性能进行了测试,得到了冷板的平均换热系数和压力损失。
The results show that: the pressure loss of muffler elements increased dramatically with the inlet velocity increased.
研究结果表明:消声单元的压力损失随入口流速的提高显著增大。
The maximization of the static pressure rise and minimization of the total pressure loss are taken as the design targets.
压气机叶型气动优化设计目标是静压升最大和总压损失最小。
The pressure loss and separation efficiency under various temperature conditions of cyclones has been numerically studied.
对不同温度条件下旋风分离器的压力损失和分离效率进行了数值研究。
This article mainly introduces the cold mode trial and the result analysis about the spring nozzle with small pressure loss.
主要介绍了小压差弹簧喷嘴的冷态试验和结果分析。
The pressure loss in horizontal borehole may have certain influences on production performance of fractured horizontal wells.
水平井筒内的压力损失对压裂水平井的生产动态有一定的影响;
The longer the expand length is, the smaller the inlet diameter is, the greater the pressure loss of expand muffler element is.
扩张腔腔体长度越大、进出口管管径越小,扩张腔消声器的压力损失越大。
Downhole annular pressure is a key parameter. Conventional pressure loss calculation method is not applicable to a slin - hole.
井底环空压力是小井眼钻井的关键参数,通常的压力降计算方法对小井眼不适用。
The article analyzes the cause of pressure loss in hydraulic system and relevant classification and calculation of pressure loss.
介绍液压系统中压力损失的原因以及压力损失的种类和计算。
The formulas can be used as empirical formulas for the analysis of pressure loss of carbon black and gas mixture in the conveying pipe.
该公式可作为工程上分析炭黑与气体混合流在输送管道中压力损失的经验公式。
After that, we figure out a ladder-type wind tunnel to bring out uniform suction, and provide several means to reduce the pressure loss.
根据相关理论,得出了可以实现均匀吸风的阶梯形风道,并且提出一些降低阻力损失的方法。
This aspect is to reduce the pipeline pressure loss, the other is to avoid the path contraction obstacle to the mechanical cleaning pipelines.
这一方面是为了减小管线的阻力损失,另一方面是为了避免通径收缩后给机械清扫管线造成障碍。
The effect of the velocity difference on total pressure loss may be neglected, if the density and the static temperature difference are equal.
若密度比、静温比相同或相近时,速度差对总压损失的影响可忽略。
Through the pressure loss theoretical study of the sampling nozzle, the inner compensation structure of fly-ash sampling nozzle was determined.
通过对取样嘴内压力损失的理论研究,确定了飞灰取样嘴的内补偿结构。
Through the pressure loss theoretical study of the sampling nozzle, the inner compensation structure of fly-ash sampling nozzle was determined.
通过对取样嘴内压力损失的理论研究,确定了飞灰取样嘴的内补偿结构。
应用推荐