An ESD protection circuit for IC CARDS is described, which is based on CMOS process.
介绍了ESD保护结构的基本原理，并提出一个基于CMOS工艺用于IC卡芯片的保护电路。
The paper gives the hardware and software of the system, and its detection and protection circuit.
文中给出了系统的硬件、软件，并详细介绍了其检测、保护电路。
IC type overload protection circuit has gradually replaced thermal relay overload protection mode.
煤电钻采用热继电器进行过载保护方式已逐渐被IC型过载保护电路取代。
This paper analyses the overcurrent protection circuit and puts forward some reasonable Suggestions.
对过流保护电路进行了分析并提出了一些合理的建议。
The protection circuit on the input end has a gate electrode comprised of a band-like conductive film.
输入端的保护电路有由带状导电膜组成的栅电极。
This text introduces an structure simple, performance steady and output over-voltage protection circuit.
文章介绍一种结构简单、性能可靠的输出过压保护电路。
The rapid protection circuit has many advantages in rapid response, simple structure and convenient adjustment.
这种快速保护电路具有响应快、结构简单、调试方便等众多优点。
The voltage regulator has an overload protection circuit coupled between a feedback network and a regulation section.
电压调节器具有耦合在反馈网络和调节部分之间的过载保护电路。
With detection circuit in the protection circuit can make the whole system running with the reliability of protection.
回路中有了检测保护电路就可以使整个系统运行的可靠性有了保障。
If the delay exceeds a predetermined amount of time, the overload protection circuit shuts down the voltage regulator.
如果延迟超过预定的时间量，则过载保护电路关闭电压调节器。
The system is composed of stable current source, light power feedback, protection circuit, and temperature controller.
该系统包括恒流源、光功率反馈、保护电路、温度控制等部分。
The protection circuit should be enclosed in a light-tight shield. the shield should be connected to the low of the ammeter.
保护电路应当做遮光屏蔽，且屏蔽要接到安培计的低压端。
A dynamic gate floating ESD protection circuit is first analyzed and then designed according to the whole-chip ESD planning.
本文研究了一种基于动态栅极悬浮技术的ESD保护电路，并根据全芯片ESD防护的要求设计了试验电路。
Effects of some key design parameters on the performance of the ESD protection circuit are discussed and physically explained.
讨论了一些重要的设计参数对ESD保护电路性能的影响并进行了物理上的解释。
The whole circuit includes Dynamic Self-Supply (DSS) circuit, over current protection circuit and temperature shutdown circuit.
并具有动态自供电、过流保护、过温保护等功能。
This paper recommends a new type of IGBT driving protection circuit, which is fast, safe and reliable in performing its function.
介绍一种新型的性能较完善的IGBT驱动保护电路。实验结果表明，该电路能快速、安全、可靠地实现保护功能。
Figure 2-24 shows a protection circuit for an electrometer ammeter or picoammeter, consisting of a resistor and two diodes (1n3595).
图2 - 24示出静电计或皮安计的过载保护电路，其中包括一个电阻器和两个二极管(1n3595)。
Four modules are included in the SPDT analog switch, for example, MOS switch circuit, driver circuit, buffer circuit, and ESD protection circuit.
单刀双掷模拟开关电路的设计包括四个模块：MOS开关电路、驱动电路、缓冲电路和ESD保护电路。
This paper designed the charge circuit and protection circuit of phosphoric acid iron battery, and verified the effectiveness of the charge circuit.
本文主要根据锂电池的特性，设计了磷酸铁锂电池的充电电路和保护电路，并通过实验验证了本文设计的充电电路的正确性。
A voltage regulator having an overload protection circuit and a method for protecting against an output voltage being less than a predetermined level.
一种具有过载保护电路的电压调节器和用于防护输出电压大于预定的电平的方法。
Based on analysing the reasons for (reverse) -current operating, the protection circuit is designed. This (protection) circuit stops a future trouble.
从分析造成逆电的原因入手，设计防止机车逆电操纵电路，以达到从根本上防止逆电发生的目的。
Previously, a typical protection circuit would include a relay, resettable fuse and MOV combination to protect against the above combination of threats.
以往来说，典型电路保护将继电器、可恢复式保险丝、与金属氧化物压敏电阻组合来保护防止损害。
The principle of the drive and protection circuits is introduced, the method of measuring the response time of the protection circuit is also introduced.
介绍了驱动电路和快速保护电路的原理，及保护电路响应时间的测量方法。
The operation and characteristics of the DC DC converter are discussed, and its control and protection circuit is presented. It is verified by experiment.
分析了该变换器的工作原理和特性，简介了变换器的控制和保护电路，并用实验进行了验证。
The analytical and experimental results show that the shortcircuit protection circuit is fast, safe, reliable and simple, and is of great application value.
分析与实验结果表明，短路保护快速、安全、可靠、简便、应用价值较大。
It discusses the design of power-fail protection circuit for SCM from hardware and software, and analyzes the credibility of power-fail protection in detail.
详细地介绍了单片机樟电保护电路的设计原理及硬、软件实现方法，分析了其可靠性。
The design of the filter circuit, starting current check circuit and switching surge absorption-protection circuit in an auxiliary circuit of PFC is analyzed.
对功率因数校正器辅助电路中的滤波电路设计、起动电流抑制电路的设计和开关的浪涌吸收保护电路的设计进行了分析。
This paper analyses the ways to realize rapid protection of GTR and presents a practical rapid protection circuit. The detector circuit is discussed in detail.
分析了实现大功率晶体管（GTR）快速保护的途径，提出了一种GTR的快速保护电路，尤其对检测电路作了详细的讨论。
This paper analyses the ways to realize rapid protection of GTR and presents a practical rapid protection circuit. The detector circuit is discussed in detail.
分析了实现大功率晶体管（GTR）快速保护的途径，提出了一种GTR的快速保护电路，尤其对检测电路作了详细的讨论。
应用推荐