This circuit features low temperature coefficient and high power supply rejection ratio.
该电路有较低的温度系数和较高的电源抑制比。
By adding some auxiliary circuits, the power rejection ratio of the circuit is improved.
通过增加一些辅助电路，提高了电路的电源抑制比。
In this situation, the CMRR (common-mode rejection ratio) of the input differential amplifier was unsatisfactory.
在这种情况下，输入差分放大器的CMRR 不令人满意。
CMOS bandgap reference (BGR) without a resistor, with a high power supply rejection ratio and output below 1v is proposed.
提出一种输出低于1V的、无电阻高电源抑制比的CMOS带隙基准源(BGR)。
The advantages of using a spectrum analyser to measure image rejection ratio of a tuner are direct in observation, accurate in reading, easy in operation and so on.
用频谱分析仪测量调谐器的假象抑制比，具有显示直观、读数准确、测试简便等优点。
The fragmentation of resource placement is a critical factor to affect CU (Chip Utilization) and TRR (Task Rejection Ratio) in the field of reconfigurable computing.
在可重构计算领域，布局硬件任务所产生的碎片是影响系统资源利用率和任务拒绝率的关键因素之一。
Thermal stability and Power Supply Rejection Ratio of the voltage reference circuit are the two major factors that influence the precision and stability of the whole system.
它的温度稳定性和电源电压拟制比是影响整个系统精度和性能的关键性因素。
Thermal stability and Power Supply Rejection Ratio (PSRR) of the voltage reference circuit are the two major factors that influence the precision and stability of the whole system.
它的温度稳定性和电源电压抑制比是影响整个系统精度和性能的关键性因素。
Based on the basic principle of bandgap reference, design a high precision, high power supply rejection ratio (PSRR) and low temperature coefficient (TC) bandgap voltage reference.
基于带隙基准的基本原理，设计了一种高精度、高电源抑制比(PSRR)、低温度系数(TC)的带隙基准电压源。
The bandgap reference uses the exponential curvature compensation as the nonlinear compensation and has the better temperature characteristic and high PSRR(Power Supply Rejection Ratio);
其中带隙基准采用指数曲率补偿作为非线性补偿，具有很好的温度性能和高电源电压抑制比；
Because PTFE membrane was more hydrophobic than PVDF membrane, PTFE membrane employed in the treatment of phenol aqueous solution had a better efficiency and a higher ion rejection ratio.
PTFE膜的疏水性较PV DF膜强，在相同进料条件下，用PTFE膜处理含酚水溶液的分离效率和离子截留率更高。
In order to decrease the rejection ratio in the rubber-producing process, the dispersed homogeneous degree of carbon-black in rubber should be indirectly, real time and accurately determined.
为了减少橡胶生产过程中的废品率，需要间接、实时、准确地确定橡胶中炭黑的分散均匀度。
With such ratio, rejection rate will be reduced and quality of molding sand and casting will be improved.
该配比可降低废品率，提高型砂和铸件质量。
Simulation results show that the user rejection criterion can lower down the computation complexity more than 50% when the signal to noise ratio is relatively small.
仿真结果表明，当信噪比较低时，采用该用户丢弃准则使得计算复杂度的下降超过50%。
Simulation results show that the user rejection criterion can lower down the computation complexity more than 50% when the signal to noise ratio is relatively small.
仿真结果表明，当信噪比较低时，采用该用户丢弃准则使得计算复杂度的下降超过50%。
应用推荐